350 research outputs found
Experimental and numerical simulation of single-phase flow in a micro heat spreader applied to the cold start of internal combustion engines fueled with ethanol
Paper presented to the 10th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, Florida, 14-16 July 2014.This work presents the results of numerical simulations and
experimental evaluation of a micro heat spreader applied to the
cold start of internal combustion engines fuelled with ethanol.
At low temperatures (below 11 °C), using only ethanol as fuel,
engines are unable to start. So, it was adopted as solution in
Brazil the use of gasoline to assist the first start. The gasoline is
contained in an additional small reservoir implying on safety
concerns. Additionally, the use of gasoline causes an increase
of emissions compared with the use of only ethanol. Therefore,
in the present study a micro heat spreader containing an
electrical heater was developed in order to heat up the ethanol
and permit the engine start under ambient temperatures down to
-10 °C. Based on this, numerical simulations were performed
using Computational Fluid Dynamics (CFD) software to predict
the thermal behaviour of the device. Then, based on these
simulations, a micro heat spreader was fabricated and
experimentally evaluated. Good agreement between
experimental and simulated results was obtained. Based on the
initial results, the heat spreader seems to attend the
requirements of its application.dc201
Atypical actinobacillosis in bulls in Argentina: granulomatous dermatitis and lymphadenitis
Actinobacillosis is a common cause of sporadic infection in cattle. It was mostly characterized as a pyogranulomatous inflammation of the tongue, but also soft tissues as lymph nodes, other digestive tract localization and skin. The aim of this study was to describe an episode of granulomatous dermatitis and lymphadenitis affecting a bull herd in Argentina during 2010. Actinobacillus lignieresii was isolated from samples collected from one of the affected bulls, and characteristic lesions were observed. Lesions other than 'wooden tongue' are usually uncommon; however, actinobacillosis should be included as a differential diagnosis for cutaneous diseases
Anisotropic flow of charged hadrons, pions and (anti-)protons measured at high transverse momentum in Pb-Pb collisions at TeV
The elliptic, , triangular, , and quadrangular, , azimuthal
anisotropic flow coefficients are measured for unidentified charged particles,
pions and (anti-)protons in Pb-Pb collisions at TeV
with the ALICE detector at the Large Hadron Collider. Results obtained with the
event plane and four-particle cumulant methods are reported for the
pseudo-rapidity range at different collision centralities and as a
function of transverse momentum, , out to GeV/.
The observed non-zero elliptic and triangular flow depends only weakly on
transverse momentum for GeV/. The small dependence
of the difference between elliptic flow results obtained from the event plane
and four-particle cumulant methods suggests a common origin of flow
fluctuations up to GeV/. The magnitude of the (anti-)proton
elliptic and triangular flow is larger than that of pions out to at least
GeV/ indicating that the particle type dependence persists out
to high .Comment: 16 pages, 5 captioned figures, authors from page 11, published
version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/186
Centrality dependence of charged particle production at large transverse momentum in Pb-Pb collisions at TeV
The inclusive transverse momentum () distributions of primary
charged particles are measured in the pseudo-rapidity range as a
function of event centrality in Pb-Pb collisions at
TeV with ALICE at the LHC. The data are presented in the range
GeV/ for nine centrality intervals from 70-80% to 0-5%.
The Pb-Pb spectra are presented in terms of the nuclear modification factor
using a pp reference spectrum measured at the same collision
energy. We observe that the suppression of high- particles strongly
depends on event centrality. In central collisions (0-5%) the yield is most
suppressed with at -7 GeV/. Above
GeV/, there is a significant rise in the nuclear modification
factor, which reaches for GeV/. In
peripheral collisions (70-80%), the suppression is weaker with almost independently of . The measured nuclear
modification factors are compared to other measurements and model calculations.Comment: 17 pages, 4 captioned figures, 2 tables, authors from page 12,
published version, figures at
http://aliceinfo.cern.ch/ArtSubmission/node/284
- …