IFPA meeting 2018 workshop report II: Abnormally invasive placenta; inflammation and infection; preeclampsia; gestational trophoblastic disease and drug delivery

Workshops are an important part of the IFPA annual meeting as they allow for discussion of specialized topics. At IFPA meeting 2018 there were nine themed workshops, five of which are summarised in this report. These workshops discussed new perspectives and knowledge in the following areas of research: 1) preeclampsia; 2) abnormally invasive placenta; 3) placental infection; 4) gestational trophoblastic disease; 4) drug delivery to treat placental dysfunction

Nanocolumnar Crystalline Vanadium Oxide-Molybdenum Oxide Antireflective Smart Thin Films with Superior Nanomechanical Properties

Vanadium oxide-molybdenum oxide (VO-MO) thin (21-475 nm) films were grown on quartz and silicon substrates by pulsed RF magnetron sputtering technique by altering the RF power from 100 to 600 W. Crystalline VO-MO thin films showed the mixed phases of vanadium oxides e.g., V2O5, V2O3 and VO2 along with MoO3. Reversible or smart transition was found to occur just above the room temperature i.e., at similar to 45-50 degrees C. The VO-MO films deposited on quartz showed a gradual decrease in transmittance with increase in film thickness. But, the VO-MO films on silicon exhibited reflectance that was significantly lower than that of the substrate. Further, the effect of low temperature (i.e., 100 degrees C) vacuum (10(-5) mbar) annealing on optical properties e.g., solar absorptance, transmittance and reflectance as well as the optical constants e.g., optical band gap, refractive index and extinction coefficient were studied. Sheet resistance, oxidation state and nanomechanical properties e.g., nanohardness and elastic modulus of the VO-MO thin films were also investigated in as-deposited condition as well as after the vacuum annealing treatment. Finally, the combination of the nanoindentation technique and the finite element modeling (FEM) was employed to investigate yield stress and von Mises stress distribution of the VO-MO thin films

Simulation of nanoindentation experiment on RF magnetron sputtered nanocolumnar V2O5 film using finite element method

The present work reports the nanomechanical behavior of a pulsed radio frequency (RF) magnetron sputtered vanadium pentoxide (V2O5) film deposited on silicon (Si) substrate using a combination of nanoindentation experiments and a finite element model (FEM). Deposited V2O5 film is characterized by x-ray diffraction (XRD), nanoprofilometry, field emission scanning electron microscopy (FESEM), nanoindentation and FEM. The phase pure 6.16 mu m V2O5 film shows a nanocolumnar structure. The film exhibits nanohardness (H) of 0.16 +/- 0.013 GPa and Young's modulus (E) of about 12.05 +/- 1.41 GPa. The FEM reproduces experimentally obtained load versus depth (P-h) plot and subsequently give yield stress and strain hardening component data of V2O5 film on Si substrate. Stress-strain behavior and von-Mises stress distribution of the V2O5 film with Si substrate system are also simulated. The FE model confirms the local maximum equivalent stress active underneath the nanoindenters to be nearly twice as high as the yield stress and thereby explains the plastic deformation observed in the V2O5 film

Effect of low temperature vacuum annealing on microstructural, optical, electronic, electrical, nanomechanical properties and phase transition behavior of sputtered vanadium oxide thin films

Vanadium oxide thin films were deposited on quartz substrate by pulsed RF magnetron sputtering technique at 400-600 W and subsequently annealed at 100 degrees C in vacuum (1.5 x 10(-5) mbar). Phase analysis, surface morphology and topology of the films e.g., both as-deposited and annealed were investigated by x-ray diffraction, field emission scanning electron microscopy and atomic force microscopy techniques. X-ray photoelectron spectroscopy (XPS) was employed to understand the elemental oxidation of the films. Transmittance of the films was evaluated byUV-vis-NIR spectrophotometer in the wavelength range of 200-1600 nm. Sheet resistance of the films was measured by two-probe method both for as-deposited and annealed conditions. XPS study showed the existence of V5+ and V4+ species. Metal to insulator transition temperature of the as-deposited film decreased from 339 degrees C to 326 degrees C after annealing as evaluated by differential scanning calorimetric technique. A significant change in transmittance was observed in particular at near infrared region due to alteration of surface roughness and grain size of the film after annealing. Sheet resistance values of the annealed films decreased as compared to the as-deposited films due to the lower in oxidation state of vanadium which led to increase in carrier density. Combined nanoindentation and finite element modeling were applied to evaluate nanohardness (H), Young's modulus (E), von Mises stress and strain distribution. Both H and E were improved after annealing due to increase in crystallinity of the film

IFPA meeting 2018 workshop report II: abnormally invasive placenta; inflammation and infection; preeclampsia; gestational trophoblastic disease and drug delivery

Workshops are an important part of the IFPA annual meeting as they allow for discussion of specialized topics. At IFPA meeting 2018 there were nine themed workshops, five of which are summarised in this report. These workshops discussed new perspectives and knowledge in the following areas of research: 1) preeclampsia; 2) abnormally invasive placenta; 3) placental infection; 4) gestational trophoblastic disease; 4) drug delivery to treat placental dysfunction

IFPA meeting 2018 workshop report II: Abnormally invasive placenta; inflammation and infection; preeclampsia; gestational trophoblastic disease and drug delivery.

Workshops are an important part of the IFPA annual meeting as they allow for discussion of specialized topics. At IFPA meeting 2018 there were nine themed workshops, five of which are summarised in this report. These workshops discussed new perspectives and knowledge in the following areas of research: 1) preeclampsia; 2) abnormally invasive placenta; 3) placental infection; 4) gestational trophoblastic disease; 4) drug delivery to treat placental dysfunction