The Effect of Surfactants and pH Modifying Agents on the Dissolution and Permeation of Pimobendan

Solubility and permeability are key parameters for establishing in vitro-in vivo correlation for poorly water-soluble active pharmaceutical ingredients (APIs). Recent studies demonstrate that not only solubility, but also effective permeability of the API may change due to the addition of solubilizing agents, and there is a certain mathematical relation between these physicochemical parameters. The aim of this study was to show the importance of early screening of solubility and permeability in presence of additives in order to achieve the expected bioavailability of the API. In this work, the effect of surfactants and microenvironmental pH modifiers were in focus, and pimobendan was chosen as model drug.In the case of pH modifiers, the equilibrium solubility of the API increased, while the permeability decreased significantly. No negative effect was observed for two surfactants at low additive levels, but these two additives also exhibited a slightly negative effect on permeability when used at higher concentrations. In the simultaneous dissolution-permeation studies the surfactants-containing formulation was found to have slightly higher flux than the pH-modifier-containing one. It can be due to the phenomenon that the dissolution of the active substance can be enhanced by these surfactants without any significant permeability reducing effect.The results obtained from the present study clearly demonstrate the importance of studying drug-additive interactions in every step of formulation development and based on these, the selection of the appropriate quality and quantity of additives. In addition, the results also underline the significance of performing simultaneous dissolution-permeation studies to predict bioavailability

Prediction of Bioequivalence and Food Effect Using Flux- and Solubility-Based Methods

In this work, two different approaches have been developed to predict the food effect and the bioequivalence of marketed itraconazole (ITRA) formulations. Kinetic solubility and simultaneous dissolution–permeation tests of three (ITRA) formulations (Sporanox capsules and solution and SUBA-ITRA capsules) were carried out in simulated fasted and fed states. Fraction of dose absorbed ratios estimating food effect and bioequivalence were calculated based on these results and were compared to the in vivo study results published by Medicines Agencies. The comparison demonstrated that kinetic solubility and flux values could be used as input parameters for biopharmaceutics modeling and simulations to estimate food effect and bioequivalence. Both prediction methods were able to determine a slightly negative food effect in the case of the Sporanox solution and also a pronounced positive food effect for the Sporanox capsule. Superior bioavailability was predicted when the Sporanox solution was compared to the Sporanox capsule (in agreement with in vivo data)

Inclusion complexation of the anticancer drug pomalidomide with cyclodextrins: fast dissolution and improved solubility

Pomalidomide (POM), a potent anticancer thalidomide analogue was characterized in terms of cyclodextrin complexation to improve its aqueous solubility and maintain its anti-angiogenic activity. The most promising cyclodextrin derivatives were selected by phase-solubility studies. From the investigated nine cyclodextrins – differing in cavity size, nature of substituents, degree of substitution and charge – the highest solubility increase was observed with sulfobutylether-β-cyclodextrin (SBE-β-CD). The inclusion complexation between POM and SBE-β-CD was further characterized with a wide variety of state-of-the-art analytical techniques, such as nuclear magnetic resonance spectroscopy (NMR), infrared spectroscopy (IR), circular dichroism spectroscopy, fluorescence spectroscopy as well as X-ray powder diffraction method (XRD). Job plot titration by NMR and the AL-type phase-solubility diagram indicated 1:1 stoichiometry in a liquid state. Complementary analytical methods were employed for the determination of the stability constant of the complex; the advantages and disadvantages of the different approaches are also discussed. Inclusion complex formation was also assessed by molecular modelling study. Solid state complexation in a 1:1 M ratio was carried out by lyophilization and investigated by IR and XRD. The complex exhibited fast-dissolution with immediate release of POM, when compared to the pure drug at acidic and neutral pH. Kinetic analysis of POM release from lyophilized complex shows that Korsmeyer-Peppas and Weibull model described the best the dissolution kinetics. The cytotoxicity of the complex was tested against the LP-1 human myeloma cell line which revealed that supramolecular interactions did not significantly affect the anti-cancer activity of the drug. Overall, our results suggest that the inclusion complexation of POM with SBE-β-CD could be a promising approach for developing more effective POM formulations with increased solubility

Understanding the pH Dependence of Supersaturation State—A Case Study of Telmisartan

Creating supersaturating drug delivery systems to overcome the poor aqueous solubility of active ingredients became a frequent choice for formulation scientists. Supersaturation as a solution phenomenon is, however, still challenging to understand, and therefore many recent publications focus on this topic. This work aimed to investigate and better understand the pH dependence of supersaturation of telmisartan (TEL) at a molecular level and find a connection between the physicochemical properties of the active pharmaceutical ingredient (API) and the ability to form supersaturated solutions of the API. Therefore, the main focus of the work was the pH-dependent thermodynamic and kinetic solubility of the model API, TEL. Based on kinetic solubility results, TEL was observed to form a supersaturated solution only in the pH range 3–8. The experimental thermodynamic solubility-pH profile shows a slight deviation from the theoretical Henderson–Hasselbalch curve, which indicates the presence of zwitterionic aggregates in the solution. Based on pKa values and the refined solubility constants and distribution of macrospecies, the pH range where high supersaturation-capacity is observed is the same where the zwitterionic form of TEL is present. The existence of zwitterionic aggregation was confirmed experimentally in the pH range of 3 to 8 by mass spectrometry

Understanding the pH Dependence of Supersaturation State — A Case Study of Telmisartan

Creating supersaturating drug delivery systems to overcome the poor aqueous solubility of active ingredients became a frequent choice for formulation scientists. Supersaturation as a solution phenomenon is, however, still challenging to understand, and therefore many recent publications focus on this topic. This work aimed to investigate and better understand the pH dependence of supersaturation of telmisartan (TEL) at a molecular level and find a connection between the physicochemical properties of the active pharmaceutical ingredient (API) and the ability to form supersaturated solutions of the API. Therefore, the main focus of the work was the pH-dependent thermodynamic and kinetic solubility of the model API, TEL. Based on kinetic solubility results, TEL was observed to form a supersaturated solution only in the pH range 3–8. The experimental thermodynamic solubility-pH profile shows a slight deviation from the theoretical Henderson–Hasselbalch curve, which indicates the presence of zwitterionic aggregates in the solution. Based on pKa values and the refined solubility constants and distribution of macrospecies, the pH range where high supersaturation-capacity is observed is the same where the zwitterionic form of TEL is present. The existence of zwitterionic aggregation was confirmed experimentally in the pH range of 3 to 8 by mass spectrometry

Use of an In Vitro Skin Parallel Artificial Membrane Assay (Skin-PAMPA) as a Screening Tool to Compare Transdermal Permeability of Model Compound 4-Phenylethyl-Resorcinol Dissolved in Different Solvents

Absorption through the skin of topically applied chemicals is relevant for both formulation development and safety assessment, especially in the early stages of development. However, the supply of human skin is limited, and the traditional in vitro methods are of low throughput. As an alternative, an artificial membrane-based Skin Parallel Artificial Membrane Permeability Assay (Skin-PAMPA) has been developed to mimic the permeability through the stratum corneum. In this study, this assay was used to measure the permeability of a model compound, 4-phenylethyl-resorcinol (PER), dissolved in 13 different solvents that are commonly used in cosmetic formulation development. The study was performed at concentrations close to the saturated solution of PER in each solvent to investigate the maximum thermodynamic potential of the solvents. The permeability of PER in selected solvents was also measured on ex vivo pig skin for comparison. Pig ear skin is an accepted alternative model of human skin. The permeability coefficient, which is independent of the concentration of the applied solution, showed a good correlation (R2 = 0.844) between the Skin-PAMPA and the pig skin permeation data. Our results support the use of the Skin-PAMPA to screen the suitability of different solvents for non-polar compounds at an early stage of formulation development

The Effect of the Particle Size Reduction on the Biorelevant Solubility and Dissolution of Poorly Soluble Drugs with Different Acid-Base Character

Particle size reduction is a commonly used process to improve the solubility and the dissolution of drug formulations. The solubility of a drug in the gastrointestinal tract is a crucial parameter, because it can greatly influence the bioavailability. This work provides a comprehensive investigation of the effect of the particle size, pH, biorelevant media and polymers (PVA and PVPK-25) on the solubility and dissolution of drug formulations using three model compounds with different acid-base characteristics (papaverine hydrochloride, furosemide and niflumic acid). It was demonstrated that micronization does not change the equilibrium solubility of a drug, but it results in a faster dissolution. In contrast, nanonization can improve the equilibrium solubility of a drug, but the selection of the appropriate excipient used for nanonization is essential, because out of the two used polymers, only the PVPK-25 had an increasing effect on the solubility. This phenomenon can be explained by the molecular structure of the excipients. Based on laser diffraction measurements, PVPK-25 could also inhibit the aggregation of the particles more effectively than PVA, but none of the polymers could hold the nanonized samples in the submicron range until the end of the measurements