Thermal stability and grain growth behavior of mechanically alloyed nanocrystalline Fe-Cu alloys

X-ray diffraction, transmission electron microscopy, and differential scanning calorimetry were used to study the thermal stability of highly supersaturated nanocrystalline FexCu100−x alloys (10~80. For 60<=x<=80 fcc and bcc phases coexist. Heating to elevated temperatures leads to structural relaxation, phase separation, and grain growth of the metastable nanocrystalline solid solutions. Single-phase fcc and bcc alloys undergo significant strain release but no appreciable grain growth prior to phase separation. After phase separation pronounced grain growth sets in. In contrast, samples in the two-phase region show some grain growth and significant chemical redistribution even at low temperatures. The phase separation of single-phase fcc and bcc alloys proceeds via different mechanisms: fcc solid solutions decompose by forming small Fe precipitates, while demixing in bcc alloys starts by segregation of Cu atoms to bcc grain boundaries before nucleation of Cu precipitates. These results show that the stability and grain growth behavior of nanocrystalline alloys is strongly affected by the microstructure of the material

Mechanically driven alloying and grain size changes in nanocrystalline Fe-Cu powders

Highly supersaturated nanocrystalline FexCu100-x alloys (10 less-than-or-equal-to x less-than-or-equal-to 95) have been prepared by mechanical alloying of elemental crystalline powders. The development of the microstructure is investigated by x-ray diffraction, differential scanning calorimetry, and transmission electron microscopy. The results are compared with data for ball-milled elemental Fe and Cu powders, samples prepared by inert gas condensation, and sputtered films. The deformation during milling reduces the grain size of the alloys to 6-20 nm. The final grain size of the powders depends on the composition of the material. Single-phase fcc alloys with x less-than-or-equal-to 60 and single-phase bcc alloys with x greater-than-or-equal-to 80 are formed even though the Fe-Cu system exhibits vanishingly small solid solubilities under equilibrium conditions. For 60 less-than-or-equal-to x less-than-or-equal-to 80, fcc and bcc solid solutions coexist. The alloy formation is discussed with respect to the thermodynamic conditions of the material. The role of the large volume fraction of grain boundaries between the nanometer-sized crystals, as well as the influence of internal strains and stored enthalpies introduced by ball milling, is critically assessed

The Next Stage for Social Policy: Encouraging Work and Family Formation Among Low-Income Men

Examines proposals to create work incentives for less-educated young men by changing the Earned Income Tax Credit for the childless into an individual work credit and reducing the marriage penalty. Simulates each proposal's effects, with cost estimates

Gibbs free energy difference between the undercooled liquid and the beta-phase of a Ti-Cr alloy

The heat of fusion and the specific heats of the solid and liquid have been experimentally determined for a Ti60Cr40 alloy. The data are used to evaluate the Gibbs free energy difference, DELTA-G, between the liquid and the beta-phase as a function of temperature to verify a reported spontaneous vitrification (SV) of the beta-phase in Ti-Cr alloys. The results show that SV of an undistorted beta-phase in the Ti60Cr40 alloy at 873 K is not feasible because DELTA-G is positive at the temperature. However, DELTA-G may become negative with additional excess free energy to the beta-phase in the form of defects

OGO-3 observations of ELF noise in the magnetosphere - Part 1 - Spatial extent and frequency of occurrence

OGO-3 spectrum analyzer measurements of magnetic noise in magnetospher

Gibbs free-energy difference between the glass and crystalline phases of a Ni-Zr alloy

The heats of eutectic melting and devitrification, and the specific heats of the crystalline, glass, and liquid phases have been measured for a Ni24Zr76 alloy. The data are used to calculate the Gibbs free-energy difference, DeltaGAC, between the real glass and the crystal on an assumption that the liquid-glass transition is second order. The result shows that DeltaGAC continuously increases as the temperature decreases in contrast to the ideal glass case where DeltaGAC is assumed to be independent of temperature

A study of waves in the earth's bow shock

The perturbation vectors of waves up and downstream from the region of maximum compression in the bow shock were examined on OGO-5 under particularly steady solar wind conditions. The polarization of the upstream waves was RH, circular and of the downstream waves LH, elliptical in the spacecraft frame. By observing that the polarization of the waves remained unchanged as the shock motion swept the wave structure back and forth across the satellite three times in eight minutes, it was found that the waves were not stationary in the shock frame. A study of the methods of determining the shock normal indicates that the normal estimated from a shock model should be superior to one based upon magnetic coplanarity. The propagation vectors of the waves examined did not coincide with the shock model normal, the average magnetic field, or the plasma flow velocity. However, the major axis of the polarization ellipse of the downstream wave was nearly parallel to the upstream propagation vector

Direct measurement of shear-induced cross-correlations of Brownian motion

Shear-induced cross-correlations of particle fluctuations perpendicular and along stream-lines are investigated experimentally and theoretically. Direct measurements of the Brownian motion of micron-sized beads, held by optical tweezers in a shear-flow cell, show a strong time-asymmetry in the cross-correlation, which is caused by the non-normal amplification of fluctuations. Complementary measurements on the single particle probability distribution substantiate this behavior and both results are consistent with a Langevin model. In addition, a shear-induced anti-correlation between orthogonal random-displacements of two trapped and hydrodynamically interacting particles is detected, having one or two extrema in time, depending on the positions of the particles.Comment: 4 pages, 4 figure

Measurements of heavy ion beam losses from collimation

The collimation efficiency for Pb ion beams in the LHC is predicted to be lower than requirements. Nuclear fragmentation and electromagnetic dissociation in the primary collimators create fragments with a wide range of Z/A ratios, which are not intercepted by the secondary collimators but lost where the dispersion has grown sufficiently large. In this article we present measurements and simulations of loss patterns generated by a prototype LHC collimator in the CERN SPS. Measurements were performed at two different energies and angles of the collimator. We also compare with proton loss maps and find a qualitative difference between Pb ions and protons, with the maximum loss rate observed at different places in the ring. This behavior was predicted by simulations and provides a valuable benchmark of our understanding of ion beam losses caused by collimation.Comment: 12 pages, 20 figure

Beam losses from ultra-peripheral nuclear collisions between Pb ions in the Large Hadron Collider and their alleviation

Electromagnetic interactions between colliding heavy ions at the Large Hadron Collider (LHC) at CERN will give rise to localized beam losses that may quench superconducting magnets, apart from contributing significantly to the luminosity decay. To quantify their impact on the operation of the collider, we have used a three-step simulation approach, which consists of optical tracking, a Monte-Carlo shower simulation and a thermal network model of the heat flow inside a magnet. We present simulation results for the case of Pb ion operation in the LHC, with focus on the ALICE interaction region, and show that the expected heat load during nominal Pb operation is 40% above the quench level. This limits the maximum achievable luminosity. Furthermore, we discuss methods of monitoring the losses and possible ways to alleviate their effect.Comment: 17 pages, 20 figure