On spin optics for gravitational waves lensed by a rotating object

We study gravitational lensing of gravitational waves taking into account the spin of a graviton coupled with a dragged spacetime made by a rotating object. We decompose the phase of gravitational waves into helicity-dependent and independent components with spin optics, analyzing waves whose wavelengths are shorter than the curvature radius of a lens object. We analytically confirm that the trajectory of gravitational waves splits depending on the helicity, generating additional time delay and elliptical polarization onto the helicity-independent part. We exemplify monotonic gravitational waves lensed by a Kerr black hole and derive the analytical expressions of corrections in phase and magnification. The corrections are enhanced for longer wavelengths, potentially providing a novel probe of rotational properties of lens objects in low-frequency gravitational-wave observations in the future.Comment: 14 pages, 6 figure

Fabrication of CNT/Cu Composite Yarn via Single-Step Electrodeposition

Carbon nanotube (CNT)/Cu composite yarns were formed via a single-step electrodeposition process. A twisted CNT yarn composed of multiwalled CNTs (MWCNTs) was used. Copper was directly electrodeposited onto the CNT yarn under galvanostatic conditions using copper sulfate baths with and without additives. Four additives (polyethylene glycol (PEG), chloride anion (Cl-), bis(3-sulfopropyl)disulfide (SPS), and Janus green B (JGB)) that are well known as "via-filling additives" were used together. The surface and cross-sectional microstructures of the copper-deposited CNT yarns were analyzed. Copper was electrodeposited only onto the surface of the CNT yarn from the bath without additives, resulting in a copper-coated CNT yarn. By contrast, copper was deposited not only onto the surface but also into the interior of the CNT yarn from the bath with the additives. The amount of copper deposited into the CNT yarn tended to increase with increasing PEG and Cl-concentrations. The current density also affected the size and location of the deposited copper particles. When the electrodeposition conditions were optimized, copper was relatively homogeneously deposited into the interior of the CNT yarn, resulting in a CNT/Cu composite yarn. (C) 2020 The Author(s). Published on behalf of The Electrochemical Society by IOP Publishing Limited.ArticleJOURNAL OF THE ELECTROCHEMICAL SOCIETY. 167(10):102509 (2020)journal articl

Selective hydrogenation of acetophenone with supported Pd and Rh catalysts in water, organic solvents, and CO2-dissolved expanded liquids

Solvent effects were investigated for selective hydrogenation of acetophenone (AP) with commercial 5% Pd/Al2O3 and 5% Pd/C catalysts using polar and nonpolar solvents. The rate of AP hydrogenation varied with the solvents used in different ways depending on the catalysts used. The highest AP conversion was achieved with water for the two catalysts and the AP conversion was correlated with hydrogen-bond-acceptance (HBA) capability (beta) for Pd/Al2O3 and hydrogen-bond-donation (HBD) capability (alpha) for Pd/C. These trends were the same as the corresponding solvent effects obtained previously with Rh/ Al2O3 and Rh/C catalysts, respectively (Green Chem., 2015, 17, 1877-1883). The influence of solvents on the rate of AP hydrogenation depends on the support materials and not on the metal species. Furthermore, AP hydrogenation was conducted with the four supported noble metal catalysts in different solvents pressurized by CO2 (CO2-dissolved expanded solvents). The influence of CO2 pressurization on the rate of reaction, the product selectivity, and the catalyst life was investigated to know whether or not CO2 molecules could function as a reaction promoter in heterogeneous AP hydrogenation reactions with supported Pd and Rh catalysts in different solvents

Lithium production on a low-mass secondary in a black hole soft X-ray transient

We examine production of Li on the surface of a low-mass secondary in a black hole soft X-ray transient (BHSXT) through the spallation of CNO nuclei by neutrons which are ejected from a hot (> 10 MeV) advection-dominated accretion flow (ADAF) around the black hole. Using updated binary parameters, cross sections of neutron-induced spallation reactions, and mass accretion rates in ADAF derived from the spectrum fitting of multi-wavelength observations of quiescent BHSXTs, we obtain the equilibrium abundances of Li by equating the production rate of Li and the mass transfer rate through accretion to the black hole. The resulting abundances are found to be in good agreement with the observed values in seven BHSXTs. We note that the abundances vary in a timescale longer than a few months in our model. Moreover, the isotopic ratio Li6/Li7 is calculated to be about 0.7--0.8 on the secondaries, which is much higher than the ratio measured in meteorites. Detection of such a high value is favorable to the production of Li via spallation and the existence of a hot accretion flow, rather than an accretion disk corona system in quiescent BHSXT.Comment: 4 pages, 3 figures, and 2 tables, submitted to Astrophyscal Jounal Letter

40Ar-39Ar analysis of phlogopite in the Horoman Peridotite Complex, Hokkaido, Japan and implications for its origin

金沢大学理工研究域自然システム学系40Ar-39Ar analysis of phlogopite separated from a plagioclase lherzolite of the Horoman Peridotite Complex, Hokkaido, Japan, has yielded a plateau age of 20.6 ± 0.5 Ma in an environment where the metamorphic fluid was characterized by an almost atmospheric Ar isotopic ratio. The age spectrum is slightly saddle-shaped, implying some incorporation of excess 40Ar during the formation of the phlogopite at a depth. As the phlogopite has been inferred to have formed in veins and/or interstitials during exhumation of the peridotite body, metasomatic fluids, to which ground- and sea water might have contributed, were probably involved in the formation of phlogopite in the crustal environment. A total 40Ar-39Ar age of 129 Ma of a whole rock sample of the plagioclase lherzolite, from which the phlogopite was separated and is representative of the main lithology of the Horoman Peridotite Complex, indicates the occurrence of excess 40Ar. Hence, the age has no geological meaning

Analysis of the phenomenon of speculative trading in one of its basic manifestations: postage stamp bubbles

We document and analyze the empirical facts concerning one of the clearest evidence of speculation in financial trading as observed in the postage collection stamp market. We unravel some of the mechanisms of speculative behavior which emphasize the role of fancy and collective behavior. In our conclusion, we propose a classification of speculative markets based on two parameters, namely the amplitude of the price peak and a second parameter that measures its ``sharpness''. This study is offered to anchor modeling efforts to realistic market constraints and observations.Comment: 9 pages, 5 figures and 2 tables, in press in Int. J. Mod. Phys.

The impact of uncertainty in society on the use of traditional, complementary and alternative medicine: a comparative study on visits to alternative/traditional/folk health care practitioners

Background: While traditional, complementary and alternative medicine (TCAM) is gaining increased interest worldwide, the structural factors associated with the usage of TCAM at the social level have not been sufficiently explored. We aim to understand the social structure of uncertainty in society that affects the TCAM usage for men and women. Methods: We studied 32 countries using data from the International Social Survey Programme and the World Bank. In this study, we defined TCAM usage as visits to an alternative/traditional/folk health care practitioner during the past 12 months. We performed a correlation analysis and used a generalized linear model . Results: The prevalence of TCAM usage in terms of visits to practitioners was 26.1% globally, while usage varied across the 32 countries. Generalized linear models showed that unemployment rate was associated with the prevalence of TCAM usage in terms of visits to practitioners. Conclusions: At the social-structural level TCAM usage involving visits to practitioners was related to job insecurity. Job insecurity led to a decrease in TCAM usage regarding visits to practitioners. These findings suggest that it is necessary to consider the social-structural factors of uncertainty in society when designing health policies related to TCAM

Mechanobiological Signal Transduction in Differentiating Chondrocyte and New Configuration for Mechanical Stress Culture

Proceedings of the 2nd IEEE International Conference on Nano/Micro Engineered and Molecular Systems, January 16 - 19, 2007, Bangkok, Thailan