A shipboard cable-hauling system for large electrical cables

An air -powered hauling machine and reeling device for use at sea with large electrical cable systems such as hydrophone arrays is described. The system may be used to haul cables from 0. 3 to 2 . 0 inch diameter. Hauling tensions up to 9 80 lbs . and speeds up to 4 30 ft/ min. are provided. The principal advantage of the system is that it does not cause the cable to bend while under tension. Reeling is accomplished under only sufficient tension to cause the cable to conform to the reel.Undersea Warfare Branch Office of Naval Research under Contracts Nonr-4029(00) NR 260-10

Study of aerodynamic technology for single-cruise-engine V/STOL fighter/attack aircraft

A viable, single engine, supersonic V/STOL fighter/attack aircraft concept was defined. This vectored thrust, canard wing configuration utilizes an advanced technology separated flow engine with fan stream burning. The aerodynamic characteristics of this configuration were estimated and performance evaluated. Significant aerodynamic and aerodynamic propulsion interaction uncertainties requiring additional investigation were identified. A wind tunnel model concept and test program to resolve these uncertainties and validate the aerodynamic prediction methods were defined

Shear-stress controlled dynamics of nematic complex fluids

Based on a mesoscopic theory we investigate the non-equilibrium dynamics of a sheared nematic liquid, with the control parameter being the shear stress $\sigma_{\mathrm{xy}}$ (rather than the usual shear rate, $\dot\gamma$). To this end we supplement the equations of motion for the orientational order parameters by an equation for $\dot\gamma$, which then becomes time-dependent. Shearing the system from an isotropic state, the stress- controlled flow properties turn out to be essentially identical to those at fixed $\dot\gamma$. Pronounced differences when the equilibrium state is nematic. Here, shearing at controlled $\dot\gamma$ yields several non-equilibrium transitions between different dynamic states, including chaotic regimes. The corresponding stress-controlled system has only one transition from a regular periodic into a stationary (shear-aligned) state. The position of this transition in the $\sigma_{\mathrm{xy}}$-$\dot\gamma$ plane turns out to be tunable by the delay time entering our control scheme for $\sigma_{\mathrm{xy}}$. Moreover, a sudden change of the control method can {\it stabilize} the chaotic states appearing at fixed $\dot\gamma$.Comment: 10 pages, 11 figure

Analytical and experimental study of the dynamics of a single-tube counterflow boiler

Experimental and analytical study of dynamics of single tube counterflow boile

Improved solution for potential flow about arbitrary axisymmetric bodies by the use of a higher-order surface source method. Part 1. Theory and results

The surface-source method of calculating potential flow is improved by refining the underlying numerical analysis. The analysis uses parabolic elements and linearly-varying source density. The result is a large increase in computing speed and accuracy. The theory is described, and the effectiveness of the modification is illustrated

Excimer lasers

A theoretical and experimental investigation into the possibility of achieving CW discharge pumped excimer laser oscillation is reported. Detailed theoretical modeling of capillary discharge pumping of the XeF and KXe and K2 excimer systems was carried out which predicted the required discharge parameters for reaching laser threshold on these systems. Capillary discharge pumping of the XeF excimer system was investigated experimentally. The experiments revealed a lower excimer level population density than predicted theoretically by about an order of magnitude. The experiments also revealed a fluorine consumption problem in the discharge in agreement with theory

Calculation of compressible flow about three-dimensional inlets with auxiliary inlets, slats and vanes by means of a panel method

An efficient and user oriented method was constructed for calculating flow in and about complex inlet configurations. Efficiency is attained by: (1) the use of a panel method; (2) a technique of superposition for obtaining solutions at any inlet operating condition; and (3) employment of an advanced matrix iteration technique for solving large full systems of equations, including the nonlinear equations for the Kutta condition. User concerns are addressed by the provision of several novel graphical output options that yield a more complete comprehension of the flowfield than was possible previously

Investigation of the potentialities of photochemical laser systems. Part I - Survey and analysis Final report, 1 Feb. 1966 - 31 Jan. 1967

Photodissociative laser systems used to convert solar radiation to monochromatic coherent emission - excitation mechanisms, spectroscopy of gases absorbing light, and chemical processe

Excimer lasers

The results of a two-year investigation into the possibility of developing continuous wave excimer lasers are reported. The program included the evaluation and selection of candidate molecular systems and discharge pumping techniques. The K Ar/K2 excimer dimer molecules and the xenon fluoride excimer molecule were selected for study; each used a transverse and capillary discharges pumping technique. Experimental and theoretical studies of each of the two discharge techniques applied to each of the two molecular systems are reported. Discharge stability and fluorine consumption were found to be the principle impediments to extending the XeF excimer laser into the continuous wave regime. Potassium vapor handling problems were the principal difficulty in achieving laser action on the K Ar/K2 system. Of the four molecular systems and pumping techniques explored, the capillary discharge pumped K Ar/K2 system appears to be the most likely candidate for demonstrating continuous wave excimer laser action primarily because of its predicted lower pumping threshold and a demonstrated discharge stability advantage

DIAL with heterodyne detection including speckle noise: Aircraft/shuttle measurements of O3, H2O, and NH3 with pulsed tunable CO2lasers

A parametric analysis of DIAL sensitivity with heterodyne detection is presented and comparisons with direct detection are discussed. Examples are given for monitoring vertical distributions of O3, H2O, and NH3 using a ground-, aircraft-, or shuttle-based pulsed tunable CO2 laser DIAL system. Results indicate that maximum sensitivity at minimum laser energy per measurement requires multiple pulse operation with the energy per pulse selected so that the measured photon rate is approximately equal to the detector IF bandwidth. Measurement sensitivities can be maximized and interference effects minimized by fine adjustment of measurement frequencies using the tunability of high pressure lasers. The use of rare isotope lasers minimizes loss due to CO2 atmospheric absorption