275 research outputs found
Polycomb group protein complexes exchange rapidly in living Drosophila
Fluorescence recovery after photobleaching (FRAP) microscopy was used to determine the kinetic properties of Polycomb group (PcG) proteins in whole living Drosophila organisms (embryos) and tissues (wing imaginal discs and salivary glands). PcG genes are essential genes in higher eukaryotes responsible for the maintenance of the spatially distinct repression of developmentally important regulators such as the homeotic genes. Their absence, as well as overexpression, causes transformations in the axial organization of the body. Although protein complexes have been isolated in vitro, little is known about their stability or exact mechanism of repression in vivo. We determined the translational diffusion constants of PcG proteins, dissociation constants and residence times for complexes in vivo at different developmental stages. In polytene nuclei, the rate constants suggest heterogeneity of the complexes. Computer simulations with new models for spatially distributed protein complexes were performed in systems showing both diffusion and binding equilibria, and the results compared with our experimental data. We were able to determine forward and reverse rate constants for complex formation. Complexes exchanged within a period of 1-10 minutes, more than an order of magnitude faster than the cell cycle time, ruling out models of repression in which access of transcription activators to the chromatin is limited and demonstrating that long-term repression primarily reflects mass-action chemical equilibria
Recommended from our members
Optical photon reassignment microscopy (OPRA)
To enhance the resolution of a confocal laser scanning microscope the additional information of a pinhole plane image taken at every excitation scan position can be used (Sheppard 1988). This photon reassignment principle is based on the fact that the most probable position of an emitter is at half way between the nominal focus of the excitation laser and the position corresponding to the (off centre) detection position. Therefore, by reassigning the detected photons to this place, an image with enhanced detection efficiency and resolution is obtained. Here we present optical photon reassignment microscopy (OPRA) which realizes this concept in an all-optical way obviating the need for image-processing. With the help of an additional intermediate optical beam expansion between descanning and a further rescanning of the detected light, an image with the advantages of photon reassignment can be acquired. However, just as in computational photon reassignment, a loss in confocal sectioning performance is caused by working with relatively open pinholes. The OPRA system shares properties such as flexibility and ease of use with a confocal laser scanning microscope, and is therefore expected to be of use for future biomedical routine research
Super-resolution microscopy: a brief history and new avenues.
Super-resolution microscopy (SRM) is a fast-developing field that encompasses fluorescence imaging techniques with the capability to resolve objects below the classical diffraction limit of optical resolution. Acknowledged with the Nobel prize in 2014, numerous SRM methods have meanwhile evolved and are being widely applied in biomedical research, all with specific strengths and shortcomings. While some techniques are capable of nanometre-scale molecular resolution, others are geared towards volumetric three-dimensional multi-colour or fast live-cell imaging. In this editorial review, we pick on the latest trends in the field. We start with a brief historical overview of both conceptual and commercial developments. Next, we highlight important parameters for imaging successfully with a particular super-resolution modality. Finally, we discuss the importance of reproducibility and quality control and the significance of open-source tools in microscopy. This article is part of the Theo Murphy meeting issue 'Super-resolution structured illumination microscopy (part 2)'
Recommended from our members
Vinculin binding angle in podosomes revealed by high resolution microscopy
Podosomes are highly dynamic actin-rich adhesive structures formed predominantly by cells of the monocytic lineage, which degrade the extracellular matrix. They consist of a core of F-actin and actin-regulating proteins, surrounded by a ring of adhesion-associated proteins such as vinculin. We have characterised the structure of podosomes in macrophages, particularly the structure of the ring, using three super-resolution fluorescence microscopy techniques: stimulated emission depletion microscopy, structured illumination microscopy and localisation microscopy. Rather than being round, as previously assumed, we found the vinculin ring to be created from relatively straight strands of vinculin, resulting in a distinctly polygonal shape. The strands bind preferentially at angles between 116° and 135°. Furthermore, adjacent vinculin strands are observed nucleating at the corners of the podosomes, suggesting a mechanism for podosome growth
Optical Photon Reassignment Microscopy (OPRA)
To enhance the resolution of a confocal laser scanning microscope the
additional information of a pinhole plane image taken at every excitation scan
position can be used [C. J. R. Sheppard, Super-resolution in confocal imaging,
Optik 80, 5354 (1988)]. This photon reassignment principle is based on the fact
that the most probable position of an emitter is at half way between the
nominal focus of the excitation laser and the position corresponding to the
(off centre) detection position. Therefore, by reassigning the detected photons
to this place, an image with enhanced detection efficiency and resolution is
obtained. Here we present optical photon reassignment microscopy (OPRA) which
realises this concept in an all-optical way obviating the need for
image-processing. With the help of an additional intermediate optical beam
expansion between descanning and a further rescanning of the detected light, an
image with the advantages of photon reassignment can be acquired. Due to its
simplicity and flexibility this method has the potential to enhance the
performance of nearly every laser scanning microscope and is therefore expected
to play an important role in future systems.Comment: 8 pages, 3 figure
Non-radial oscillations of anisotropic neutron stars in the Cowling approximation
One of the most common assumptions in the study of neutron star models and
their oscillations is that the pressure is isotopic, however there are
arguments that this may not be correct. Thus in the present paper we make a
first step towards studying the nonradial oscillations of neutron stars with an
anisotropic pressure. We adopt the so-called Cowling approximation where the
spacetime metric is kept fixed and the oscillation spectrum for the first few
fluid modes is obtained. The effect of the anisotropy on the frequencies is
apparent, although with the present results it might be hard to distinguish it
from the changes in the frequencies caused by different equations of state.Comment: 17 pages, 8 figures; title changed, comments adde
satFRET: estimation of Forster resonance energy transfer by acceptor saturation
We demonstrate theoretically and experimentally the quantification of Förster resonance energy transfer (FRET) by direct and systematic saturation of the excited state of acceptor molecules. This version of acceptor depletion methods for FRET estimation, denoted as “satFRET” is reversible and suitable for time-resolved measurements. The technique was investigated theoretically using the steady-state solution of the differential equation system of donor and acceptor molecular states. The influence of acceptor photobleaching during measurement was included in the model. Experimental verification was achieved with the FRET-pair Alexa 546- Alexa 633 loaded on particles in different stoichiometries and measured in a confocal microscope. Estimates of energy transfer efficiency by excited state saturation were compared to those obtained by measurements of sensitised emission and acceptor photobleaching. The results lead to a protocol that allows time-resolved FRET measurements of fixed and living cells on a conventional confocal microscope. This procedure was applied to fixed Chinese hamster ovary cells containing a cyan fluorescent protein and yellow fluorescent protein pair. The time resolution of the technique was demonstrated in a live T cell activation assay comparing the FRET efficiencies measured using a genetically encoded green and red fluorescent protein biosensor for GTP/GDP turnover to those measured by acceptor photobleaching of fixed cells
Interpretation of the optical transfer function: Significance for image scanning microscopy
The optical transfer function (OTF) is widely used to compare the performance of different optical systems. Conventionally, the OTF is normalized to unity for zero spatial frequency, but in some cases it is better to consider the unnormalized OTF, which gives the absolute value of the image signal. Examples are in confocal microscopy and image scanning microscopy, where the signal level increases with pinhole or array size. Comparison of the respective unnormalized OTFs gives useful insight into their relative performance. The significance of other properties of the general OTF is discussed
Recommended from our members
Autofluorescent granules of the human retinal pigment epithelium: phenotypes, intracellular distribution, and age-related topography
PURPOSE. The human retinal pigment epithelium (RPE) accumulates granules significant for autofluorescence imaging. Knowledge of intracellular accumulation and distribution is limited. Using high-resolution microscopy techniques, we determined the total number of granules per cell, intracellular distribution, and changes related to retinal topography and age. METHODS. RPE cells from the fovea, perifovea, and near-periphery of 15 human RPE flat mounts were imaged using structured illumination microscopy (SIM) and confocal fluorescence microscopy in young (=51 years, n = 8) and older (>80 years, n = 7) donors. Using custom FIJI plugins, granules were marked with computer assistance, classified based on morphological and autofluorescence properties, and analyzed with regard to intracellular distribution, total number per cell, and granule density. RESULTS. A total of 193,096 granules in 450 RPE cell bodies were analyzed. Based on autofluorescence properties, size, and composition, the RPE granules exhibited nine different phenotypes (lipofuscin, two; melanolipofuscin, five; melanosomes, two), distinguishable by SIM. Overall, lipofuscin (low at the fovea but increases with eccentricity and age) and melanolipofuscin (equally distributed at all three locations with no age-related changes) were the major granule types. Melanosomes were under-represented due to suboptimal visualization of apical processes in flat mounts. CONCLUSIONS. Low lipofuscin and high melanolipofuscin content within foveal RPE cell bodies and abundant lipofuscin at the perifovea suggest a different genesis, plausibly related to the population of overlying photoreceptors (fovea, cones only; perifovea, highest rod density). This systematic analysis provides further insight into RPE cell and granule physiology and links granule load to cell autofluorescence, providing a subcellular basis for the interpretation of clinical fundus autofluorescence. © 2020 Association for Research in Vision and Ophthalmology Inc.. All rights reserved
Bounds on the basic physical parameters for anisotropic compact general relativistic objects
We derive upper and lower limits for the basic physical parameters
(mass-radius ratio, anisotropy, redshift and total energy) for arbitrary
anisotropic general relativistic matter distributions in the presence of a
cosmological constant. The values of these quantities are strongly dependent on
the value of the anisotropy parameter (the difference between the tangential
and radial pressure) at the surface of the star. In the presence of the
cosmological constant, a minimum mass configuration with given anisotropy does
exist. Anisotropic compact stellar type objects can be much more compact than
the isotropic ones, and their radii may be close to their corresponding
Schwarzschild radii. Upper bounds for the anisotropy parameter are also
obtained from the analysis of the curvature invariants. General restrictions
for the redshift and the total energy (including the gravitational
contribution) for anisotropic stars are obtained in terms of the anisotropy
parameter. Values of the surface redshift parameter greater than two could be
the main observational signature for anisotropic stellar type objects.Comment: 18 pages, no figures, accepted for publication in CQ
- …