Laminar boundary-layer heat transfer from a partially-ionized monatomic gas by the similarity approach

Laminar boundary layer heat transfer from ionized monatomic gas to wind tunnel wal

Geoneutrinos in Borexino

This paper describes the Borexino detector and the high-radiopurity studies and tests that are integral part of the Borexino technology and development. The application of Borexino to the detection and studies of geoneutrinos is discussed.Comment: Conference: Neutrino Geophysics Honolulu, Hawaii December 14-16, 200

Prediction of heat transfer from laminar boundary layers, with emphasis on large free- stream velocity gradients and highly cooled walls

Prediction of heat transfer and shear stress from laminar boundary laye

Fundamental study of flow field generated by rotorcraft blades using wide-field shadowgraph

The vortex trajectory and vortex wake generated by helicopter rotors are visualized using a wide-field shadowgraph technique. Use of a retro-reflective Scotchlite screen makes it possible to investigate the flow field generated by full-scale rotors. Tip vortex trajectories are visible in shadowgraphs for a range of tip Mach number of 0.38 to 0.60. The effect of the angle of attack is substantial. At an angle of attack greater than 8 degrees, the visibility of the vortex core is significant even at relatively low tip Mach numbers. The theoretical analysis of the sensitivity is carried out for a rotating blade. This analysis demonstrates that the sensitivity decreases with increasing dimensionless core radius and increases with increasing tip Mach number. The threshold value of the sensitivity is found to be 0.0015, below which the vortex core is not visible and above which it is visible. The effect of the optical path length is also discussed. Based on this investigation, it is concluded that the application of this wide-field shadowgraph technique to a large wind tunnel test should be feasible. In addition, two simultaneous shadowgraph views would allow three-dimensional reconstruction of vortex trajectories

Equine digital tendons show breed‐specific differences in their mechanical properties that may relate to athletic ability and predisposition to injury

Background Throughout the ages, human subjects have selected horse breeds for their locomotor capacities. Concurrently, tissue properties may have diversified because of specific requirements of different disciplines. Objectives The aim of this study was to compare the biomechanical properties of tendons with different functions between equine breeds traditionally selected for racing or sport. Study design This study used ex vivo tendons and compared the mechanical properties of the common digital extensor tendon (CDET) and superficial digital flexor tendon (SDFT) between racehorses (Thoroughbred [TB]) and sports horses (Friesian Horse [FH], Warmblood [WB]). Methods The SDFT and CDET of FH (n = 12), WBs (n = 12) and TBs (n = 8) aged 3-12 years were harvested. The cross sectional area (cm(2)), maximal load (N), ultimate strain (%), ultimate stress (MPa) and elastic modulus (MPa) were determined and tested for significant differences between the breeds (P<0.05). Results The SDFT from WB horses had a significantly lower elastic modulus than TB horses and failed at a higher strain and load than both FHs and TBs. The mechanical properties of the CDET did not differ between breeds. In agreement with previous studies, the CDET failed at a higher stress and had a higher elastic modulus than the SDFT and, for the WB group of horses only, failed at a significantly lower strain. Interestingly, the mode of failure differed between breeds, particularly with respect to the FHs. Main limitations The exercise history of horses used in this study was unknown and the age-range was relatively large; both these factors may have influenced the absolute properties reported in this study. Conclusions This study shows for the first time that mechanical properties of the SDFT differ between breeds. These properties are likely to be related to selection for high-speed vs. an extravagant elastic gait and may be an important indicator of performance ability. The is available in Spanish - see Supporting Informatio

Kaon and Φ\Phi production vs Participants in Nuclear Collisions

Data on kaon and $\Phi$ production in nuclear collisions as a function of centrality are analysed both at AGS and SPS energy range. We compare the results of several experiments, looking for common trend in `participant scaling' of production yields. We find a smooth description of scaled kaon and $\Phi$ yields as a function of participant density. We also show a participant density dependence of kaons and $\Phi$ produced in the forward hemisphere for proton-nucleus collisions.Comment: Proceedings of the International Conference on Strangeness in Quark Matter, 20-25 July 2000, Berkeley, CA. To appear in Journal of Physics G: Nuclear and Particle Physic

Energy and precious fuels requirements of fuel alcohol production. Volume 4: Appendices G and H, methanol from coal

Coal mine location, mining technology, energy consumption in mining, coal transport, and potential availability of coal are discussed. Methanol from coal is also discussed

Convective heat transfer in a convergent- divergent nozzle

Turbulent flow convective heat transfer in convergent-divergent nozzle