Treatment of refinery crude oil tank sludge : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Environmental Engineering at Massey University

Appendix A-5 held on floppy disk. Please consult print copy in Library.The treatment and disposal of oil refinery tank sludge is a critical issue among oil refineries. This is because of the hazardous nature of the sludge due to high levels of oil and heavy metals, which must be removed prior to disposal. This study was carried out to investigate the removal of crude oil and heavy metals to allow the design of an appropriate disposal treatment that could meet the environmental regulations for this type of waste. A typical emulsified crude oil tank sludge, produced from tank cleaning operations was characterised and was shown to contain approximately 41%, 16%, 25%, and 8% of solids (sand), oil, water and volatile materials, respectively. The sludge also contained high level of metals, of which more than 98% resided in the solids fraction. The heavy metals analysed were copper, nickel and zinc with average values of 3,955mg/kg, 443 mg/kg and 13,851 mg/kg of raw sludge, respectively. The crude oil fraction of the sludge was removed by solvent washing with kerosene which resulted in emulsion breakdown. A model which optimises the removal of crude oil was developed and validated against experimental data. The model predictions agreed well with experimental trials using kerosene as the solvent. A 2:1 solvent to sludge ratio is adequate to remove the oil (> 98%) in the sludge after two washing stages. This resulted in oil-free/metal-rich solids. Kerosene washing reduced the volume by 76% and mass by 59%, which allows easier handling and disposal. Heavy metals reduction was achieved by acid washing using 8N nitric acid and a 10:4 mixture of 2.4N hydrochloric and 8N nitric acids. Approximately 99% of the metals were removed using a 10:1 acid to solids ratio, at pH <1 and ambient conditions, making the sludge suitable for land application and meeting the appropriate disposal guidelines for oil and metal levels. The solvent washing process was shown to be industrially feasible for volume and mass reduction of the sludge. However, heavy metal reduction by acid washing requires further optimisation before it can be applied on an industrial scale

Novel Compact and High Selectivity Dual-band BPF with Wide Stopband

A novel type of compact and high selectivity dual-band bandpass filter (BPF) incorporating a dual-mode defected ground structure resonator (DDGSR) and a dual-mode open-stub loaded stepped impedance resonator (DOLSIR) is proposed in this paper. Utilizing capacitive source-load coupling and the intrinsic characteristics of the two types of dual-mode resonators, compact dual-band BPF with multi transmission zeros near the passband edges as well as a wide stopband which can be used to achieve high selectivity is realized. An experimental dual-band BPF located at 2.4 and 3.2 GHz was designed and fabricated. The validity of the design approach is verified by good agreement between simulated and measurement results

Atrocalopteryx melli orohainani ssp. nov. on the Island of Hainan, China (Zygoptera: Calopterygidae)

The new sp. is described from the mountain core of Hainan, southern China, where it usually occurs at altitudes not lower than 300 m asl. It lives on the same type of small, shaded rivers as the nominate ssp. on the continent, and is distinguished by its larger size, slightly less enfumed wings, and a 2.6% difference in the sequence of the barcoding portion of the mitochodrial DNA-cytochrome c oxidase subunit I gene (COI). Holotype male: Diaoluoshan mountain, 6-VIII-2011; deposited in the Inst. Hydrobiol., Jinan Univ., Guanghou. It is argued that this geographically defined ssp. evolved because of persistent poor gene flow with continental populations, caused by the lowland "panhandle" between Hainan and the continent. This barrier was probably functioning equally well during interglacials (like at present) as during pleniglacials (when Hainan was connected to the mainland), because lack of suitable environments (small sized running waters), and dry and cold conditions continued to limit the contact with A. melli of the mainland

Two problems related to prescribed curvature measures

Existence of convex body with prescribed generalized curvature measures is discussed, this result is obtained by making use of Guan-Li-Li's innovative techniques. In surprise, that methods has also brought us to promote Ivochkina's $C^2$ estimates for prescribed curvature equation in \cite{I1, I}.Comment: 12 pages, Corrected typo

Time-dependent density functional study of the electronic potential energy curves and excitation spectrum of the oxygen molecule

Orbital energies, ionization potentials, molecular constants, potential energy curves, and the excitation spectrum of O(2) are calculated using time-dependent density functional theory (TDDFT) with Tamm-Dancoff approximation (TDA). The calculated negative highest occupied molecular orbital energy (-epsilon(HOMO)) is compared with the energy difference ionization potential for five exchange correlation functionals consisting of the local density approximation (LDAxc), gradient corrected Becke exchange plus Perdew correlation (B(88X)+P(86C)), gradient regulated asymptotic correction (GRAC), statistical average of orbital potentials (SAOP), and van Leeuwen and Baerends asymptotically correct potential (LB94). The potential energy curves calculated using TDDFT with the TDA at internuclear distances from 1.0 to 1.8 A are divided into three groups according to the electron configurations. The 1pi(u) (4)1pi(g) (2) electron configuration gives rise to the X (3)Sigma(g) (-), a (1)Delta(g), and b (1)Sigma(g) (+) states; the 1pi(u) (3)1pi(g) (3) electron configuration gives rise to the c (1)Sigma(u) (-), C (3)Delta(u), and A (3)Sigma(u) (+) states; and the B (3)Sigma(u) (-), A (1)Delta(u), and f (1)Sigma(u) (+) states are determined by the mixing of two or more electron configurations. The excitation spectrum of the oxygen molecule, calculated with the aforementioned exchange correlation functionals, shows that the results are quite sensitive to the choice of functional. The LDAxc and the B(88X)+P(86C) functionals produce similar spectroscopic patterns with a single strongly absorbing band positioned at 19.82 and 19.72 eV, respectively, while the asymptotically corrected exchange correlation functionals of the SAOP and the LB94 varieties yield similar excitation spectra where the computed strongly absorbing band is located at 16.09 and 16.42 eV, respectively. However, all of the exchange correlation functionals yield only one strongly absorbing band (oscillator strength greater than 0.1) in the energy interval of 0-20 eV, which is assigned to a X (3)Sigma(g) (-) to (3)Sigma(u) (-) transition. Furthermore, the oxygen molecule has a rich spectrum in the energy range of 14-20 eV and no spin allowed absorption bands are predicted to be observed in the range of 0-6 eV

Organizing information on the next generation web - Design and implementation of a new bookmark structure

The next-generation Web will increase the need for a highly organized and ever evolving method to store references to Web objects. These requirements could be realized by the development of a new bookmark structure. This paper endeavors to identify the key requirements of such a bookmark, specifically in relation to Web documents, and sets out a suggested design through which these needs may be accomplished. A prototype developed offers such features as the sharing of bookmarks between users and groups of users. Bookmarks for Web documents in this prototype allow more specific information to be stored such as: URL, the document type, the document title, keywords, a summary, user annotations, date added, date last visited and date last modified. Individuals may access the service from anywhere on the Internet, as long as they have a Java-enabled Web browser