Potential environmental impact of tidal energy extraction in the Pentland Firth at large spatial scales : results of a biogeochemical model

A model study was carried out of the potential large-scale (> 100 km) effects of marine renewable tidal energy generation in the Pentland Firth, using the 3-D hydrodynamics–biogeochemistry model GETM-ERSEM-BFM. A realistic 800 MW scenario and a high-impact scenario with massive expansion of tidal energy extraction to 8 GW scenario were considered. The realistic 800 MW scenario suggested minor effects on the tides, and undetectable effects on the biogeochemistry. The massive-expansion 8 GW scenario suggested effects would be observed over hundreds of kilometres away with changes of up to 10 % in tidal and ecosystem variables, in particular in a broad area in the vicinity of the Wash. There, waters became less turbid, and primary production increased with associated increases in faunal ecosystem variables. Moreover, a one-off increase in carbon storage in the sea bed was detected. Although these first results suggest positive environmental effects, further investigation is recommended of (i) the residual circulation in the vicinity of the Pentland Firth and effects on larval dispersal using a higher-resolution model and (ii) ecosystem effects with (future) state-of-the-art models if energy extraction substantially beyond 1 GW is planned

Generation of internal stress and its effects

Internal stresses may be generated continually in many polycrystalline materials. Their existence is manifested by changes in crystal defect concentration and arrangement, by surface observations, by macroscopic shape changes and particularly by alteration of mechanical properties when external stresses are simultaneously imposed

The measurement of the winds near the ocean surface with a radiometer-scatterometer on Skylab

The author has identified the following significant results. There were a total of twenty-six passes in the ZLV mode that yielded useful data. Six were in the in-track noncontiguous mode; all others were in the cross-track noncontiguous mode. The wind speed and direction, as effectively determined in a neutral atmosphere at 19.5 m above the sea surface, were found for each cell scanned by S193. It is shown how the passive microwave measurements were used both to compute the attenuation of the radar beam and to determine those cells where the backscatter measurement was suspect. Given the direction of the wind from some independent source, with the typical accuracy of measurement by available meteorological methods, a backscatter measurement at a nadir angle of 50, 43, or 32 deg can be used to compute the speed of the wind averaged over the illuminated area

The effects of dust evolution on disks in the mid-IR

In this paper, we couple together the dust evolution code two-pop-py with the thermochemical disk modelling code ProDiMo. We create a series of thermochemical disk models that simulate the evolution of dust over time from 0.018 Myr to 10 Myr, including the radial drift, growth, and settling of dust grains. We examine the effects of this dust evolution on the mid-infrared gas emission, focussing on the mid-infrared spectral lines of C2H2, CO2, HCN, NH3, OH, and H2O that are readily observable with Spitzer and the upcoming E-ELT and JWST. The addition of dust evolution acts to increase line fluxes by reducing the population of small dust grains. We find that the spectral lines of all species except C2H2 respond strongly to dust evolution, with line fluxes increasing by more than an order of magnitude across the model series as the density of small dust grains decreases over time. The C2H2 line fluxes are extremely low due to a lack of abundance in the infrared line-emitting regions, despite C2H2 being commonly detected with Spitzer, suggesting that warm chemistry in the inner disk may need further investigation. Finally, we find that the CO2 flux densities increase more rapidly than the other species as the dust disk evolves. This suggests that the flux ratios of CO2 to other species may be lower in disks with less-evolved dust populations.Comment: 13 pages, 9 figures, accepted in A&

Total scattering descriptions of local and cooperative distortions in the oxide spinel (Mg,Cu)Cr2O4 with dilute Jahn-Teller ions

The normal spinel oxide MgCr2O4 is cubic at room temperature while the normal spinel CuCr2O4 is tetragonal as a consequence of the Jahn-Teller nature of Cu2+ on the tetrahedral sites. Despite different end-member structures, complete solid solutions of Mg_{1-x}Cu_xCr2O4 can be prepared that display a first-order structural transition with composition x = 0.43 at room temperature. Reverse Monte Carlo analysis of total neutron scattering on data acquired between 300 K and 15 K on samples with x = 0.10, 0.20, and 0.43 provides unbiased local and average structure descriptions of the samples, including an understanding of the transition from local Jahn-Teller distortions in the cubic phase to cooperative distortions that result in a tetragonal structure. Distributions of continuous symmetry measures help to understand and distinguish distorted and undistorted coordination around the tetrahedral site in the solid solutions. Magnetic exchange bias is observed in field-cooled hysteresis loops of samples with dilute Cu2+ concentration and in samples with tetragonal--cubic phase coexistence around 300 K.Comment: 10 pages, 14 figure

Using a Grid-Enabled Wireless Sensor Network for Flood Management

Flooding is becoming an increasing problem. As a result there is a need to deploy more sophisticated sensor networks to detect and react to flooding. This paper outlines a demonstration that illustrates our proposed solution to this problem involving embedded wireless hardware, component based middleware and overlay networks

Optical and dc transport properties of a strongly correlated charge density wave system: exact solution in the ordered phase of the spinless Falicov-Kimball model with dynamical mean-field theory

We derive the dynamical mean-field theory equations for transport in an ordered charge-density-wave phase on a bipartite lattice. The formalism is applied to the spinless Falicov-Kimball model on a hypercubic lattice at half filling. We determine the many-body density of states, the dc charge and heat conductivities, and the optical conductivity. Vertex corrections continue to vanish within the ordered phase, but the density of states and the transport coefficients show anomalous behavior due to the rapid development of thermally activated subgap states. We also examine the optical sum rule and sum rules for the first three moments of the Green's functions within the ordered phase and see that the total optical spectral weight in the ordered phase either decreases or increases depending on the strength of the interactions.Comment: 14 pages, 14 figures, submitted to Phys. Rev.

Static Versus Dynamic Friction: The Role of Coherence

A simple model for solid friction is analyzed. It is based on tangential springs representing interlocked asperities of the surfaces in contact. Each spring is given a maximal strain according to a probability distribution. At their maximal strain the springs break irreversibly. Initially all springs are assumed to have zero strain, because at static contact local elastic stresses are expected to relax. Relative tangential motion of the two solids leads to a loss of coherence of the initial state: The springs get out of phase due to differences in their sizes. This mechanism alone is shown to lead to a difference between static and dynamic friction forces already. We find that in this case the ratio of the static and dynamic coefficients decreases with increasing relative width of the probability distribution, and has a lower bound of 1 and an upper bound of 2.Comment: 10 pages, 2 figures, revtex