Periprosthetic Joint Infection After Total Knee Arthroplasty With or Without Antibiotic Bone Cement.

IMPORTANCE Despite increased use of antibiotic-loaded bone cement (ALBC) in joint arthroplasty over recent decades, current evidence for prophylactic use of ALBC to reduce risk of periprosthetic joint infection (PJI) is insufficient. OBJECTIVE To compare the rate of revision attributed to PJI following primary total knee arthroplasty (TKA) using ALBC vs plain bone cement. DESIGN, SETTING, AND PARTICIPANTS This international cohort study used data from 14 national or regional joint arthroplasty registries in Australia, Denmark, Finland, Germany, Italy, New Zealand, Norway, Romania, Sweden, Switzerland, the Netherlands, the UK, and the US. The study included primary TKAs for osteoarthritis registered from January 1, 2010, to December 31, 2020, and followed-up until December 31, 2021. Data analysis was performed from April to September 2023. EXPOSURE Primary TKA with ALBC vs plain bone cement. MAIN OUTCOMES AND MEASURES The primary outcome was risk of 1-year revision for PJI. Using a distributed data network analysis method, data were harmonized, and a cumulative revision rate was calculated (1 - Kaplan-Meier), and Cox regression analyses were performed within the 10 registries using both cement types. A meta-analysis was then performed to combine all aggregated data and evaluate the risk of 1-year revision for PJI and all causes. RESULTS Among 2 168 924 TKAs included, 93% were performed with ALBC. Most TKAs were performed in female patients (59.5%) and patients aged 65 to 74 years (39.9%), fully cemented (92.2%), and in the 2015 to 2020 period (62.5%). All participating registries reported a cumulative 1-year revision rate for PJI of less than 1% following primary TKA with ALBC (range, 0.21%-0.80%) and with plain bone cement (range, 0.23%-0.70%). The meta-analyses based on adjusted Cox regression for 1 917 190 TKAs showed no statistically significant difference at 1 year in risk of revision for PJI (hazard rate ratio, 1.16; 95% CI, 0.89-1.52) or for all causes (hazard rate ratio, 1.12; 95% CI, 0.89-1.40) among TKAs performed with ALBC vs plain bone cement. CONCLUSIONS AND RELEVANCE In this study, the risk of revision for PJI was similar between ALBC and plain bone cement following primary TKA. Any additional costs of ALBC and its relative value in reducing revision risk should be considered in the context of the overall health care delivery system

The use of antibiotic-loaded bone cement and systemic antibiotic prophylactic use in 2,971,357 primary total knee arthroplasties from 2010 to 2020: an international register-based observational study among countries in Africa, Europe, North America, and Oceania.

BACKGROUND AND PURPOSE Antibiotic-loaded bone cement (ALBC) and systemic antibiotic prophylaxis (SAP) have been used to reduce periprosthetic joint infection (PJI) rates. We investigated the use of ALBC and SAP in primary total knee arthroplasty (TKA). PATIENTS AND METHODS This observational study is based on 2,971,357 primary TKAs reported in 2010-2020 to national/regional joint arthroplasty registries in Australia, Denmark, Finland, Germany, Italy, the Netherlands, New Zealand, Norway, Romania, South Africa, Sweden, Switzerland, the UK, and the USA. Aggregate-level data on trends and types of bone cement, antibiotic agents, and doses and duration of SAP used was extracted from participating registries. RESULTS ALBC was used in 77% of the TKAs with variation ranging from 100% in Norway to 31% in the USA. Palacos R+G was the most common (62%) ALBC type used. The primary antibiotic used in ALBC was gentamicin (94%). Use of ALBC in combination with SAP was common practice (77%). Cefazolin was the most common (32%) SAP agent. The doses and duration of SAP used varied from one single preoperative dosage as standard practice in Bolzano, Italy (98%) to 1-day 4 doses in Norway (83% of the 40,709 TKAs reported to the Norwegian arthroplasty register). CONCLUSION The proportion of ALBC usage in primary TKA varies internationally, with gentamicin being the most common antibiotic. ALBC in combination with SAP was common practice, with cefazolin the most common SAP agent. The type of ALBC and type, dose, and duration of SAP varied among participating countries

Are There Any Changes in the Causative Microorganisms Isolated in the Last Years from Hip and Knee Periprosthetic Joint Infections? Antimicrobial Susceptibility Test Results Analysis

Background: PJIs following total hip and knee arthroplasty represent severe complications with broad implications, and with significant disability, morbidity, and mortality. To be able to provide correct and effective management of these cases, an accurate diagnosis is needed. Classically, acute PJIs are characterized by a preponderance of virulent microorganisms, and chronic PJIs are characterized by a preponderance of less-virulent pathogens like coagulase-negative staphylococci or Cutibacterium species. This paper aims to analyze if there are any changes in the causative microorganisms isolated in the last years, as well as to provide a subanalysis of the types of PJIs. Methods: In this single-center study, we prospectively included all retrospectively consecutive collected data from patients aged over 18 years that were hospitalized from 2016 through 2022, and patients that underwent a joint arthroplasty revision surgery. A standardized diagnostic protocol was used in all cases, and the 2021 EBJIS definition criteria for PJIs was used. Results: 114 patients were included in our analysis; of them, 67 were diagnosed with PJIs, 12 were acute/acute hematogenous, and 55 were chronic PJIs. 49 strains of gram-positive aerobic or microaerophilic cocci and 35 gram-negative aerobic bacilli were isolated. Overall, Staphylococcus aureus was the most common isolated pathogen, followed by coagulase-negative staphylococci (CoNS). All cases of acute/acute hematogenous PJIs were caused by gram-positive aerobic or microaerophilic cocci pathogens. Both Staphylococcus epidermidis and methicillin-resistant S. aureus were involved in 91.66% of the acute/acute hematogenous PJIs cases. 21.8% of the chronic PJIs cases were caused by pathogens belonging to the Enterobacterales group of bacteria, followed by the gram-negative nonfermenting bacilli group of bacteria, which were involved in 18.4% of the cases. 12 chronic cases were polymicrobial. Conclusion: Based on our findings, empiric broad-spectrum antibiotic therapy in acute PJIs could be focused on the bacteria belonging to the gram-positive aerobic or microaerophilic cocci, but the results should be analyzed carefully, and the local resistance of the pathogens should be taken into consideration

Organic field effect transistor OFET optimization considering volume channel conduction mechanism

International audienceThe main contribution of this paper is to highlight a new work regime of an optimised organic field effect transistor (OFET) respectively volume channel mode. If the device comprises a vertical n + p junction on insulator, the longitudinal conduction can be deviated by two gates. The carriers rejection from surface deep into the volume is limited by the metallurgical junction, via the top, bottom gates and deep contacts for source and drain. In respect with the electrodes biasing, a new work regime is defined. The conduction is allowed by a volume n-channel, for both negative gate voltages, with the advantage of interface conduction avoiding. A current density of 1.45μA/cm2 occurs in this situation for usual biasing. After the final analysis, a distinct device function is encountered - transistor with volume channel. The situation is analysed versus the traditional OFET case with neutral or accumulation channels

Low cost flexible assembly technique applied in wireless sensors and organic transistors

International audienceThe paper depicts some advanced technologies in order to install a low power consumption and reconfigurable sensor networks, which presents optimal operation and excellent reliability. The results of this paper are prepared during a research project that implements a low power microsystem in package so that the antenna and the radio interface are co-integrated. Consequently, the used instrumentation is designed for small distances, in order to be able to work in restricted areas as space and non-planar zones. A key requirement for the communicating node, which are acted by the sensors network, is to propose a flexible technology able to integrate the CMOS transceiver by Flip Chip onto an organic substrate. For this purpose, the antenna was directly implemented onto a flexible polymer material. The organic substrate selection must be performed in agreement to the radiation diagram of the antenna. As a second aim of this paper, an Organic Thin Film Transistor with pentacene film is simulated to capture the static characteristics and to find the matching parameters for other organic materials. In this scope, an alternative polymer grafted on nano-core material synthesis, is depicted