Stress induced martensite at the crack tip in NiTi alloys during fatigue loading

Crack tip stress-induced phase transformation mechanisms in nickel-titanium alloys (NiTi) were analyzed by Digital Image Correlation (DIC), under fatigue loads. In particular, Single Edge Crack (SEC) specimens, obtained from a commercial pseudoelastic NiTi sheet, and an ad-hoc experimental setup were used, for direct measurements of the near crack tip displacement field by the DIC technique. Furthermore, a fitting procedure was developed to calculate the mode I Stress Intensity Factor (SIF), starting from the measured displacement field. Finally, cyclic tensile tests were performed at different operating temperature, in the range 298-338 K, and the evolution of the SIF was studied, which revealed a marked temperature dependence

Structural transitions in a NiTi alloy: a multistage loading-unload cycle

NiTi shape memory alloys (SMAs) are increasingly used in many engineering and medical applications, because they combine special functional properties, such as shape memory effect and pseudoelasticity, with good mechanical strength and biocompatibility. However, the microstructural changes associated with these functional properties are not yet completely known. In this work a NiTi pseudo-elastic alloy was investigated by means of X-ray diffraction in order to assess micro-structural transformations under mechanical uniaxial deformation. The structure after complete shape recovery have been compared with initial state

Fracture mechanics of pseudoelastic NiTi alloys: review of the research activities carried out at University of Calabria

This paper reports a brief review of the research activities on fracture mechanics of nickel-titaniumbased shape memory alloys carried out at University of Calabria. In fact, this class of metallic alloys show aunusual fracture response due to the reversible stress-induced and thermally phase transition mechanismsoccurring in the crack tip region as a consequence of the highly localized stresses. The paper illustrates the mainresults concerning numerical, analytical and experimental research activities carried out by using commercialNiTi based pseudoelastic alloys. Furthermore, the effect of several thermo-mechanical loading conditions onthe fracture properties of NiTi alloys are illustrated

Fracture mechanics of pseudoelastic NiTi alloys: review of the research activities carried out at University of Calabria

This paper reports a brief review of the research activities on fracture mechanics of nickel-titanium based shape memory alloys carried out at University of Calabria. In fact, this class of metallic alloys show a unusual fracture response due to the reversible stress-induced and thermally phase transition mechanisms occurring in the crack tip region as a consequence of the highly localized stresses. The paper illustrates the main results concerning numerical, analytical and experimental research activities carried out by using commercial NiTi based pseudoelastic alloys. Furthermore, the effect of several thermo-mechanical loading conditions on the fracture properties of NiTi alloys are illustrated

Fatigue assessment of Ti-6Al-4V titanium alloy laser welded joints in absence of filler material by means of full-field techniques

The aim of this research activity was to study the fatigue behavior of laser welded joints of titanium alloy, in which the welding was performed using a laser source and in the absence of filler material, by means of unconventional full field techniques: Digital Image Correlation (DIC), and Infrared Thermography (IRT). The DIC technique allowed evaluating the strain gradients around the welded zone. The IRT technique allowed analyzing the thermal evolution of the welded surface during all the fatigue tests. The fatigue limit estimated using the Thermographic Method corresponds with good approximation to the value obtained from the experimental fatigue tests. The obtained results provided useful information for the development of methods and models to predict the fatigue behavior of welded T-joints in titanium alloy

INFLUENZA DELLA SALDATURA LASER SUL COMPORTAMENTO A MEMORIA DI FORMA A DUE VIE DI UNA LEGA NiTi

Nel presente lavoro è riportato lo studio del comportamento funzionale di un giunto saldato in lega NiTi a memoria di forma. In particolare, sono stati analizzati gli effetti della saldatura laser Nd:YAG sul comportamento a memoria di forma a due vie (Two Way Shape Memory Effect, TWSME) di una lega Ni- 51 at.% Ti, attraverso un confronto sistematico con i risultati relativi al materiale non saldato. Il TWSME è stato indotto nel materiale attraverso un opportuna procedura di training, che consiste nella ripetizione di cicli termomeccanici; successivamente, sono stati misurati i cicli di isteresi (temperatura-deformazione) caratteristici del TWSME. Sono stati valutati, inoltre, gli effetti del numero di cicli di training e delle deformazioni plastiche, che si generano nel materiale durante il processo di training, sul comportamento a memoria di forma del materiale. I risultati mostrano come il comportamento funzionale, e in particolare il TWSME, sia parzialmente preservato nel materiale saldato che, comunque, presenta valori di deformazioni plastiche maggiori rispetto al materiale base

Reentrant Spin-Peierls Transition in Mg-Doped CuGeO_3

We report a synchrotron x-ray scattering study of the diluted spin-Peierls (SP) material Cu_{1-x}Mg_xGeO_3. In a recent paper we have shown that the SP dimerization attains long-range order only for x < x_c = 0.022(0.001). Here we report that the SP transition is reentrant in the vicinity of the critical concentration x_c. This is manifested by broadening of the SP dimerization superlattice peaks below the reentrance temperature, T_r, which may mean either the complete loss of the long-range SP order or the development of a short-range ordered component within the long-range ordered SP state. Marked hysteresis and very large relaxation times are found in the samples with Mg concentrations in the vicinity of x_c. The reentrant transition is likely related to the competing Neel transition which occurs at a temperature similar to T_r. We argue that impurity-induced competing interchain interactions play an essential role in these phenomena.Comment: 5 pages, 4 embedded eps figure

Comparison of perioperative outcomes between standard laparoscopic and robot-assisted approach in patients with rectosigmoid endometriosis

Introduction: Robot-assisted laparoscopic surgery (RALS) has gained widespread application in several surgical specialties. Previous studies on the feasibility and safety of RALS vs standard laparoscopy (S-LPS) for rectosigmoid endometriosis are limited and reported conflicting data. This study aims to compare S-LPS and RALS in patients with rectosigmoid endometriosis in terms of perioperative surgical and clinical data. Material and methods: This is a multicentric, observational, prospective cohort study including 44 patients affected by rectosigmoid endometriosis referred to two tertiary referral centers for endometriosis from September 2018 to September 2019. Patients were divided into two groups: 22 patients underwent S-LPS, and 22 underwent RALS. Our primary outcome was to compare operative time (from skin incision to suture) between the two groups. Secondary outcomes included: operative room time (patient entry into operative room and patient out), estimated blood loss, laparotomic conversion rate, length of hospital stay, perioperative complications, and evaluation of endometriosis-related symptoms at 12-month follow up. Results: The two groups were comparable regarding preoperative and surgical data, except for higher rates of hysterectomies and bilateral uterosacral ligament removal procedures in the RALS group. Also after adjusting for these discrepancies, operative time was similar between S-LPS and RALS. Operative room time was statistically longer in the RALS group compared with that of S-LPS. No statistically significant difference was found concerning other study outcomes. Pain and bowel symptoms improved in both groups at 12-month follow up. Conclusions: If performed by expert teams, RALS provides similar perioperative outcomes compared with S-LPS in rectosigmoid endometriosis surgical treatment, except for longer operative room time

Intron 4–5 hTERT DNA Hypermethylation in Merkel Cell Carcinoma: Frequency, Association with Other Clinico-pathological Features and Prognostic Relevance

Merkel cell carcinoma (MCC) is an aggressive skin tumor with neuroendocrine differentiation, mainly affecting elderly population or immunocompromised individuals. As methylation of the human telomerase reverse transcriptase (mhTERT) has been shown to be a prognostic factor in different tumors, we investigated its role in MCC, in particular in intron 4–5 where rs10069690 has been mapped and recognized as a cancer susceptibility locus. DNA methylation analysis of hTERT gene was assessed retrospectively in a cohort of 69 MCC patients from the University of Bologna, University of Turin and University of Insubria. Overall mortality was evaluated with Kaplan-Meier curves and multivariable Royston-Parmar models. High levels of mhTERT (mhTERThigh) (HR = 2.500, p = 0.015) and p63 (HR = 2.659, p = 0.016) were the only two clinico-pathological features significantly associated with a higher overall mortality at the multivariate analysis. We did not find different levels of mhTERT between MCPyV (+) and (−) cases (21 vs 14, p = 0.554); furthermore, mhTERThigh was strongly associated with older age (80.5 vs 72&nbsp;years, p = 0.026), no angioinvasion (40.7% vs 71.0%, p = 0.015), lower Ki67 (50 vs 70%, p = 0.005), and PD-L1 expressions in both tumor (0 vs 3%, p = 0.021) and immune cells (0 vs 10%, p = 0.002). mhTERT is a frequently involved epigenetic mechanism and a relevant prognostic factor in MCC. In addition, it belongs to the shared oncogenic pathways of MCC (MCPyV and UV-radiations) and it could be crucial, together with other epigenetic and genetic mechanisms as gene amplification, in determining the final levels of hTERT mRNA and telomerase activity in these patients