Tunable mechanical coupling between driven microelectromechanical resonators

We present a microelectromechanical system, in which a silicon beam is attached to a comb-drive actuator, that is used to tune the tension in the silicon beam, and thus its resonance frequency. By measuring the resonance frequencies of the system, we show that the comb-drive actuator and the silicon beam behave as two strongly coupled resonators. Interestingly, the effective coupling rate (~ 1.5 MHz) is tunable with the comb-drive actuator (+10%) as well as with a side-gate (-10%) placed close to the silicon beam. In contrast, the effective spring constant of the system is insensitive to either of them and changes only by $\pm$ 0.5%. Finally, we show that the comb-drive actuator can be used to switch between different coupling rates with a frequency of at least 10 kHz.Comment: 5 pages, 4 figures, 1 tabl

Fabrication of comb-drive actuators for straining nanostructured suspended graphene

We report on the fabrication and characterization of an optimized comb-drive actuator design for strain-dependent transport measurements on suspended graphene. We fabricate devices from highly p-doped silicon using deep reactive ion etching with a chromium mask. Crucially, we implement a gold layer to reduce the device resistance from $\approx51.6$ k$\mathrm{\Omega}$ to $\approx236$ $\mathrm{\Omega}$ at room temperature in order to allow for strain-dependent transport measurements. The graphene is integrated by mechanically transferring it directly onto the actuator using a polymethylmethacrylate membrane. Importantly, the integrated graphene can be nanostructured afterwards to optimize device functionality. The minimum feature size of the structured suspended graphene is 30 nm, which allows for interesting device concepts such as mechanically-tunable nanoconstrictions. Finally, we characterize the fabricated devices by measuring the Raman spectrum as well as the a mechanical resonance frequency of an integrated graphene sheet for different strain values.Comment: 10 pages, 9 figure

Strain engineering for GeSn/SiGeSn multiple quantum well laser structures

Optically pumped GeSn laser have been realized, thus alloying of group IV elements germanium (Ge) and tin (Sn) has a large potential to be a solution for Si-photonics, since a direct bandgap for Sn incorporations above ~9 at.% is obtained [1]. The value of the bandgap can further be controlled by adding Si into the mix, which can be exploited for the formation of heterostructures for carrier confinement [2]. However, a sufficiently large difference in energy ΔE between the indirect L-valley and the direct Г-valley is required to achieve room temperature lasing. Recently lasing was reported at 180K in GeSn alloys with Sn concentrations as high as 22,3% [3]. Alternatively ΔE can be increased by adding tensile strain to the GeSn layers. Here we will discuss that an appropriate combination of Sn concentration and strain will be advantageous to tailor gain and temperature stability of the structures. Please click Additional Files below to see the full abstract

Design of a high-speed germanium-tin absorption modulator at mid-infrared wavelengths

We propose a high-speed electro-absorption modulator based on a direct bandgap Ge0.875Sn0.125 alloy operating at mid-infrared wavelengths. Enhancement of the Franz-Keldysh-effect by confinement of the applied electric field to GeSn in a reverse-biased junction results in 3.2dB insertion losses, a 35GHz bandwidth and a 6dB extinction ratio for a 2Vpp drive signal

Direct bandgap GeSn light emitting diodes for short-wave infrared applications grown on Si

The experimental demonstration of fundamental direct bandgap, group IV GeSn alloys has constituted an important step towards realization of the last missing ingredient for electronic-photonic integrated circuits, i.e. the e cient group IV laser source. In this contribution, we present electroluminescence studies of reduced-pressure CVD grown, direct bandgap GeSn light emitting diodes (LEDs) with Sn contents up to 11 at.%. Besides homojunction GeSn LEDs, complex heterojunction structures, such as GeSn/Ge multi quantum wells (MQWs) have been studied. Structural and compositional investigations con rm high crystalline quality, abrupt interfaces and tailored strain of the grown structures. While also being suitable for light absorption applications, all devices show light emission in a narrow short-wave infrared (SWIR) range. Temperature dependent electroluminescence (EL) clearly indicates a fundamentally direct bandgap in the 11 at.% Sn sample, with room temperature emission at around 0.55 eV (2.25 m). We have, however, identi ed some limitations of the GeSn/Ge MQW approach regarding emission e ciency, which can be overcome by introducing SiGeSn ternary alloys as quantum con nement barriers

Optical Transitions in Direct-Bandgap Ge1-xSnx Alloys

A comprehensive study of optical transitions in direct-bandgap Ge0.875Sn0.125 group IV alloys via photoluminescence measurements as a function of temperature, compressive strain and excitation power is performed. The analysis of the integrated emission intensities reveals a strain-dependent indirect-to-direct bandgap transition, in good agreement with band structure calculations based on the 8-band k·p and deformation potential methods. We have observed and quantified Γ valley-heavy hole and Γ valley-light hole transitions at low pumping power and low temperatures in order to verify the splitting of the valence band due to strain. We will demonstrate that the intensity evolution of these transitions supports the conclusion about the fundamental direct bandgap in compressively strained GeSn alloys. The presented investigation, thus, demonstrates that direct-bandgap group IV alloys can be directly grown on Ge-buffered Si(001) substrates despite their residual compressive strain

Weight discordance and perinatal mortality in twin pregnancy: systematic review and meta‐analysis

Objectives The primary aim of this systematic review was to explore the strength of association between birth‐weight (BW) discordance and perinatal mortality in twin pregnancy. The secondary aim was to ascertain the contribution of gestational age and growth restriction in predicting mortality in growth‐discordant twins. Methods MEDLINE, EMBASE, CINAHL and ClinicalTrials.gov databases were searched. Only studies reporting on the risk of mortality in twin pregnancies affected compared with those not affected by BW discordance were included. The primary outcomes explored were incidence of intrauterine death (IUD), neonatal death (NND) and perinatal death. Outcome was assessed separately for monochorionic (MC) and dichorionic (DC) twin pregnancies. Analyses were stratified according to BW discordance cut‐off (≥ 15%, ≥ 20%, ≥ 25% and ≥ 30%) and selected gestational characteristics, including incidence of IUD or NND before and after 34 weeks' gestation, presence of at least one small‐for‐gestational age (SGA) fetus in the twin pair and both twins being appropriate‐for‐gestational age. Risk of mortality in the larger vs smaller twin was also assessed. Meta‐analyses using individual data random‐effects logistic regression and meta‐analyses of proportion were used to analyze the data. Results Twenty‐two studies (10 877 twin pregnancies) were included in the analysis. In DC pregnancies, a higher risk of IUD, but not of NND, was observed in twins with BW discordance ≥ 15% (odds ratio (OR) 9.8, 95% CI, 3.9–29.4), ≥ 20% (OR 7.0, 95% CI, 4.15–11.8), ≥ 25% (OR 17.4, 95% CI, 8.3–36.7) and ≥ 30% (OR 22.9, 95% CI, 10.2–51.6) compared with those without weight discordance. For each cut‐off of BW discordance explored in DC pregnancies, the smaller twin was at higher risk of mortality compared with the larger one. In MC twin pregnancies, excluding cases affected by twin–twin transfusion syndrome, twins with BW discordance ≥ 20% (OR 2.8, 95% CI, 1.3–5.8) or ≥ 25% (OR 3.2, 95% CI, 1.5–6.7) were at higher risk of IUD, compared with controls. MC pregnancies with ≥ 25% weight discordance were also at increased risk of NND (OR 4.66, 95% CI, 1.8–12.4) compared with those with concordant weight. The risk of IUD was higher when considering discordant pregnancies involving at least one SGA fetus. The overall risk of mortality in MC pregnancies was similar between the smaller and larger twin, except in those with BW discordance ≥ 20%. Conclusion DC and MC twin pregnancies discordant for fetal growth are at higher risk of IUD but not of NND compared with pregnancies with concordant BW. The risk of IUD in BW‐discordant DC and MC twins is higher when at least one fetus is SGA