47 research outputs found

    Electrooptic Methods for Measurement of Small DC Currents at High Voltage Level

    Get PDF
    Two electrooptic methods for measurement of DC currents at high voltage level, extending from the nA range and up to the milliampere range have been developed. First, by switching the polarity of a measured DC voltage into a Pockels cell, DC currents can be measured and transmitted along an optical fibre to an electrooptic converter. Second, by use of an electronic circuit the measured signal can be converted into a modulated frequency form for transmission along an optical fibre. These systems are described, measurement results are presented and improvements to be made in the future are outlined. The measuring methods can be used both for development and supervision of electrical insulating systems. For DC measurements a system wherein the voltage is applied (across the Pockels cell) not directly but via an electrooptic circuit was developed. This circuit periodically inverts the polarity of the voltage across the cell, effectively applying a square wave voltage with amplitude equal to the DC voltage to be measured. The switching circuit is based around two high voltage transistors TA, TB, with the Pockels cell electrodes being each connected to one of the transistor collectors. The transistor collectors are connected via resistors RA and RB to the protective side of the voltage to be measured and the emitters to the negative side. The currents flowing in to the bases of the transistors are independently controlled by the light levels following on the two photodiodes PDA, PDB

    “Looking over the Backyard Fence”: Householders and mosquito control

    Get PDF
    Background: Vector-borne diseases are a significant public health problem in Western Australia. Mosquitoes are responsible for the transmission of a number of pathogens and may pose a serious nuisance problem. Prevention efforts in the State are multi-faceted and include physical, chemical, and cultural control methods for restricting mosquito breeding. This is less complex where breeding areas are located within public open spaces. In Australia’s developed urban areas, breeding sites are, however, frequently located within private residential landholdings, where the scope of public health officials to act is constrained by law and practicality. Consequently, mosquito prevention in these locations is predominantly the responsibility of the residents. This research addressed a gap, both in understanding the degree to which “backyard” mosquito breeding has the potential to contribute to local mosquito problems, and in assessing what residents “think and do” about mosquito control within their home environment. Methods: The study was conducted in the Town of Bassendean, a metropolitan Local Government Area of Perth, Western Australia, in close proximity to two natural, productive mosquito breeding sites, namely Ashfield Flats and Bindaring Park. A total of 150 householders were randomly surveyed during the summer of 2015–2016, to gauge residents’ knowledge, attitudes, and practices (KAP (knowledge, attitudes, and practices) Survey) in regards to mosquitoes, their breeding and ecology, and avoidance or minimization strategies. The survey comprised nine questions covering residents’ knowledge (3 questions), attitudes (3 questions), and practices (3 questions), as well as additional questions regarding the basic demographics of the resident. Larvae were collected from backyard containers and reared to adults for species identification. A series of Encephalitis Vector Surveillance carbon dioxide (EVS CO2) traps were also deployed, to assess adult mosquito density and species composition. Results: Aedes notoscriptus (Skuse), a known container-inhabiting species, accounted for just over 50% of all mosquitoes identified. Most residents were aware of mosquito-borne disease and its risk in their local area. While the majority (79%) of the sample correctly identified Ross River virus as the most common infection in WA, a significant gap in the general knowledge of residents in regards to mosquito biology and breeding habits, was noted. Furthermore, only 50% of residents reported using personal protective measures to reduce mosquito bites and only one in six residents undertook physical or chemical mosquito control around their home. Additionally, 60% of respondents believed that mosquito control was “a job for the council and the state government”, rather than for individual householders. Conclusions: A significant gap in the knowledge of residents in the study area existed in regards to the general knowledge of mosquitoes and their breeding habits; types of treatments that could be employed within the home; and the residents’ responsibility for the management of mosquito breeding on their private property. A public education campaign has been deployed to educate the residents

    The design with intent method: A design tool for influencing user behaviour

    Get PDF
    The official published version can be found at the link below.Using product and system design to influence user behaviour offers potential for improving performance and reducing user error, yet little guidance is available at the concept generation stage for design teams briefed with influencing user behaviour. This article presents the Design with Intent Method, an innovation tool for designers working in this area, illustrated via application to an everyday human–technology interaction problem: reducing the likelihood of a customer leaving his or her card in an automatic teller machine. The example application results in a range of feasible design concepts which are comparable to existing developments in ATM design, demonstrating that the method has potential for development and application as part of a user-centred design process

    Pathogenic mycobacteria achieve cellular persistence by inhibiting the Niemann-Pick Type C disease cellular pathway

    Get PDF
    Background. Tuberculosis remains a major global health concern. The ability to prevent phagosome-lysosome fusion is a key mechanism by which intracellular mycobacteria, including Mycobacterium tuberculosis, achieve long-term persistence within host cells. The mechanisms underpinning this key intracellular pro-survival strategy remain incompletely understood. Host macrophages infected with intracellular mycobacteria share phenotypic similarities with cells taken from patients suffering from Niemann-Pick Disease Type C (NPC), a rare lysosomal storage disease in which endocytic trafficking defects and lipid accumulation within the lysosome lead to cell dysfunction and cell death. We investigated whether these shared phenotypes reflected an underlying mechanistic connection between mycobacterial intracellular persistence and the host cell pathway dysfunctional in NPC.  Methods. The induction of NPC phenotypes in macrophages from wild-type mice or obtained from healthy human donors was assessed via infection with mycobacteria and subsequent measurement of lipid levels and intracellular calcium homeostasis. The effect of NPC therapeutics on intracellular mycobacterial load was also assessed.  Results. Macrophages infected with intracellular mycobacteria phenocopied NPC cells, exhibiting accumulation of multiple lipid types, reduced lysosomal Ca 2+ levels, and defects in intracellular trafficking. These NPC phenotypes could also be induced using only lipids/glycomycolates from the mycobacterial cell wall. These data suggest that intracellular mycobacteria inhibit the NPC pathway, likely via inhibition of the NPC1 protein, and subsequently induce altered acidic store Ca 2+ homeostasis. Reduced lysosomal calcium levels may provide a mechanistic explanation for the reduced levels of phagosome-lysosome fusion in mycobacterial infection. Treatments capable of correcting defects in NPC mutant cells via modulation of host cell calcium were of benefit in promoting clearance of mycobacteria from infected host cells.  Conclusion. These findings provide a novel mechanistic explanation for mycobacterial intracellular persistence, and suggest that targeting interactions between the mycobacteria and host cell pathways may provide a novel avenue for development of anti-TB therapies

    Prognostic model to predict postoperative acute kidney injury in patients undergoing major gastrointestinal surgery based on a national prospective observational cohort study.

    Get PDF
    Background: Acute illness, existing co-morbidities and surgical stress response can all contribute to postoperative acute kidney injury (AKI) in patients undergoing major gastrointestinal surgery. The aim of this study was prospectively to develop a pragmatic prognostic model to stratify patients according to risk of developing AKI after major gastrointestinal surgery. Methods: This prospective multicentre cohort study included consecutive adults undergoing elective or emergency gastrointestinal resection, liver resection or stoma reversal in 2-week blocks over a continuous 3-month period. The primary outcome was the rate of AKI within 7 days of surgery. Bootstrap stability was used to select clinically plausible risk factors into the model. Internal model validation was carried out by bootstrap validation. Results: A total of 4544 patients were included across 173 centres in the UK and Ireland. The overall rate of AKI was 14·2 per cent (646 of 4544) and the 30-day mortality rate was 1·8 per cent (84 of 4544). Stage 1 AKI was significantly associated with 30-day mortality (unadjusted odds ratio 7·61, 95 per cent c.i. 4·49 to 12·90; P < 0·001), with increasing odds of death with each AKI stage. Six variables were selected for inclusion in the prognostic model: age, sex, ASA grade, preoperative estimated glomerular filtration rate, planned open surgery and preoperative use of either an angiotensin-converting enzyme inhibitor or an angiotensin receptor blocker. Internal validation demonstrated good model discrimination (c-statistic 0·65). Discussion: Following major gastrointestinal surgery, AKI occurred in one in seven patients. This preoperative prognostic model identified patients at high risk of postoperative AKI. Validation in an independent data set is required to ensure generalizability

    Mosquito management: Views of accountability and their variance across neighborhoods in Perth, Western Australia

    No full text
    Public demand for residential land near natural wetlands has risen in Australia without sufficient account being given to the health risks posed by mosquitoes. A study conducted over the 2015-2016 Summer assessed residents’ knowledge, attitudes and practices regarding the management of backyard mosquito breeding. Backyard inspections identified breeding habitats and quantified the mosquito fauna associated with residential dwellings. Residents living closer to natural mosquito breeding sites were more likely to regard mosquito management and abatement as a joint responsibility shared with their local government authority and seemed willing to take action within their own residential lot to reduce mosquito breeding potential. As distance from natural mosquito breeding sites increased, resident attitudes seemed to increasingly reflect a view of mosquito control as ‘someone else’s responsibility’; typically one for government to address. Consistent with this, residents living further from natural breeding sites appeared less likely to identify mosquito breeding potential in their own backyards or to take steps to reduce container breeding capacity. Rather than fear-related communication, public campaigns that emphasize better understanding of mosquito breeding and accurately communicate risks and responsibilities seem important if disease risks posed by mosquitoes are to be mitigated

    The highs and lows of making a bucket list - quantifying potential mosquito breeding habitats in metropolitan backyards

    Get PDF
    While the development of land for residential housing along the Swan and Canning Rivers in Perth, WA, Australia has reduced natural mosquito breeding sites, the role of backyard container breeding remains a relatively unknown factor. Local Governments responsible for these areas focus management and control efforts on low lying, tidally driven mosquito habitats to control Aedes vigilax (Skuse) and Aedes camptorhynchus (Thomson) mosquitoes in an effort to reduce both the nuisance and disease risk to residents. In spite of their efforts, Local Governments continue to receive complaints regarding mosquito nuisance, even when environmental conditions do not favor hatching and development of the two species in the Swan River tidal flats. In this study, 150 backyard inspections were conducted in the residential suburb of Bassendean, Perth, WA, Australia, situated in close proximity to the Swan River tidal plain. The occurrence and species composition of the mosquito fauna found in residential backyards was documented. Of the backyards inspected, 94% were found to possess containers capable of breeding mosquitoes, although only 3% contained mosquito larvae. Nine species of mosquito were collected from containers ranging in capacity from 0.05 to 50 L across the study area. Additionally, encephalitis virus surveillance trapping was conducted within residential properties and compared to the tidally driven natural habitat at Ashfield Flats and a tidally influenced brackish creekline at Bindaring Park. The species composition of the fauna at the three habitat types differed significantly, with Aedes notoscriptus (Skuse) dominating residential lots and A. vigilax more prevalent at the saltmarsh site. Bindaring Park had an adult composition at the mid-point of these two habitats, reflecting its proximity to both the Swan River and residential lots
    corecore