947 research outputs found
Increasing the bandwidth of resonant gravitational antennas: The case of Explorer
Resonant gravitational wave detectors with an observation bandwidth of tens
of hertz are a reality: the antenna Explorer, operated at CERN by the ROG
collaboration, has been upgraded with a new read-out. In this new
configuration, it exhibits an unprecedented useful bandwidth: in over 55 Hz
about its frequency of operation of 919 Hz the spectral sensitivity is better
than 10^{-20} /sqrt(Hz) . We describe the detector and its sensitivity and
discuss the foreseable upgrades to even larger bandwidths.Comment: 4 pages- 4 figures Acceted for publication on Physical Review Letter
Reception frequency bandwidth of a gravitational resonant detector with optical readout
A gravitational resonant bar detector with a large scale Fabry-Perot cavity
as an optical read out and a mechanical displacement transformer is considered.
We calculate, in a fully analytical way, the final receiver bandwidth in which
the potential sensitivity, limited only by the bar thermal noise, is maintained
despite the additional thermal noise of the transformer and the additive noise
of the optical readout. We discuss also an application to the OGRAN project,
where the bar is instrumented with a 2m long FP cavity.Comment: 16 pages + 3 figures. Accepted for publicationi in Class. Quantum
Gra
Sensitivity of the spherical gravitational wave detector MiniGRAIL operating at 5 K
We present the performances and the strain sensitivity of the first spherical
gravitational wave detector equipped with a capacitive transducer and read out
by a low noise two-stage SQUID amplifier and operated at a temperature of 5 K.
We characterized the detector performance in terms of thermal and electrical
noise in the system output sygnal. We measured a peak strain sensitivity of
at 2942.9 Hz. A strain sensitivity of better than
has been obtained over a bandwidth of 30 Hz. We expect
an improvement of more than one order of magnitude when the detector will
operate at 50 mK. Our results represent the first step towards the development
of an ultracryogenic omnidirectional detector sensitive to gravitational
radiation in the 3kHz range.Comment: 8 pages, 5 figures, submitted to Physical Review
Dark Matter searches using gravitational wave bar detectors: quark nuggets and newtorites
Many experiments have searched for supersymmetric WIMP dark matter, with null
results. This may suggest to look for more exotic possibilities, for example
compact ultra-dense quark nuggets, widely discussed in literature with several
different names. Nuclearites are an example of candidate compact objects with
atomic size cross section. After a short discussion on nuclearites, the result
of a nuclearite search with the gravitational wave bar detectors Nautilus and
Explorer is reported. The geometrical acceptance of the bar detectors is 19.5
sr, that is smaller than that of other detectors used for similar
searches. However, the detection mechanism is completely different and is more
straightforward than in other detectors. The experimental limits we obtain are
of interest because, for nuclearites of mass less than g, we find a
flux smaller than that one predicted considering nuclearites as dark matter
candidates. Particles with gravitational only interactions (newtorites) are
another example. In this case the sensitivity is quite poor and a short
discussion is reported on possible improvements.Comment: published on Astroparticle Physics Sept 25th 2016 replaced fig 1
Optimizing the Earth-LISA "rendez-vous"
We present a general survey of heliocentric LISA orbits, hoping it might help
in the exercise of rescoping the mission. We try to semi-analytically optimize
the orbital parameters in order to minimize the disturbances coming from the
Earth-LISA interaction. In a set of numerical simulations we include
nonautonomous perturbations and provide an estimate of Doppler shift and
breathing as a function of the trailing angle.Comment: 18 pages, 16 figures. Submitted on CQ
Quark nuggets search using 2350 Kg gravitational waves aluminum bar detectors
The gravitational wave resonant detectors can be used as detectors of quark
nuggets, like nuclearites (nuclear matter with a strange quark). This search
has been carried out using data from two 2350 Kg, 2 K cooled, aluminum bar
detectors: NAUTILUS, located in Frascati (Italy), and EXPLORER, that was
located in CERN Geneva (CH). Both antennas are equipped with cosmic ray shower
detectors: signals in the bar due to showers are continuously detected and used
to characterize the antenna performances. The bar excitation mechanism is based
on the so called thermo-acoustic effect, studied on dedicated experiments that
use particle beams. This mechanism predicts that vibrations of bars are induced
by the heat deposited in the bar from the particle. The geometrical acceptance
of the bar detectors is 19.5 sr, that is smaller than that of other
detectors used for similar searches. However, the detection mechanism is
completely different and is more straightforward than in other detectors. We
will show the results of ten years of data from NAUTILUS (2003-2012) and 7
years from EXPLORER (2003-2009). The experimental limits we obtain are of
interest because, for nuclearites of mass less than grams, we find a
flux smaller than that one predicted considering nuclearites as dark matter
candidates.Comment: presented to the 33rd International Cosmic Ray Conference Rio de
Janeiro 201
Complete model of a spherical gravitational wave detector with capacitive transducers. Calibration and sensitivity optimization
We report the results of a detailed numerical analysis of a real resonant
spherical gravitational wave antenna operating with six resonant two-mode
capacitive transducers read out by superconducting quantum interference devices
(SQUID) amplifiers. We derive a set of equations to describe the
electro-mechanical dynamics of the detector. The model takes into account the
effect of all the noise sources present in each transducer chain: the thermal
noise associated with the mechanical resonators, the thermal noise from the
superconducting impedance matching transformer, the back-action noise and the
additive current noise of the SQUID amplifier. Asymmetries in the detector
signal-to-noise ratio and bandwidth, coming from considering the transducers
not as point-like objects but as sensor with physically defined geometry and
dimension, are also investigated. We calculate the sensitivity for an
ultracryogenic, 30 ton, 2 meter in diameter, spherical detector with optimal
and non-optimal impedance matching of the electrical read-out scheme to the
mechanical modes. The results of the analysis is useful not only to optimize
existing smaller mass spherical detector like MiniGrail, in Leiden, but also as
a technological guideline for future massive detectors. Furthermore we
calculate the antenna patterns when the sphere operates with one, three and six
resonators. The sky coverage for two detectors based in The Netherlands and
Brasil and operating in coincidence is also estimated. Finally, we describe and
numerically verify a calibration and filtering procedure useful for diagnostic
and detection purposes in analogy with existing resonant bar detectors.Comment: 23 pages, 20 figures, codes of the simulations are available on
request by contacting the autho
Analysis of 3 years of data from the gravitational wave detectors EXPLORER and NAUTILUS
We performed a search for short gravitational wave bursts using about 3 years
of data of the resonant bar detectors Nautilus and Explorer. Two types of
analysis were performed: a search for coincidences with a low background of
accidentals (0.1 over the entire period), and the calculation of upper limits
on the rate of gravitational wave bursts. Here we give a detailed account of
the methodology and we report the results: a null search for coincident events
and an upper limit that improves over all previous limits from resonant
antennas, and is competitive, in the range h_rss ~1E-19, with limits from
interferometric detectors. Some new methodological features are introduced that
have proven successful in the upper limits evaluation.Comment: 12 pages, 12 figure
Raman-based Distributed Temperature Sensor Using Simplex Code And Gain Controlled Edfa
In this work we present a comparison between simplex coded and optical amplified simplex coded Raman based Distributed Temperature Sensing (DTS). An increase in performance is demonstrated using erbium doped fiber amplifier (EDFA) with proper gain control scheme that allows a DTS operates with simplex code. Using 63-bit simplex code and gain controlled EDFA we demonstrated the temperature resolution and dynamic range improvement in 16 degrees C @ 10 km and 4 dB, respectively.963
MiniGRAIL progress report 2004
The MiniGRAIL detector was improved. The sphere was replaced by a slightly larger one, having a diameter of 68 cm (instead of 65 cm), reducing the resonant frequency by about 200 Hz to around 2.9 kHz. The last four masses of the attenuation system were machined to increase their resonant frequency and improve the attenuation around the resonant frequency of the sphere. In the new sphere, six holes were machined on the TIGA positions for easy mounting of the transducers. During the last cryogenic run, two capacitive transducers and a calibrator were mounted on the sphere. The first transducer was coupled to a double-stage SQUID amplifier having a commercial quantum design SQUID as a first stage and a DROS as a second stage. The second transducer was read by a single-stage quantum design SQUID. During the cryogenic run, the sphere was cooled down to 4 K. The two-stage SQUID had a flux noise of about 1.6 ÎŒ0 Hzâ1/2. The detector was calibrated and the sensitivity curve of MiniGRAIL was determined
- âŠ