An Investigation of the Wear of Human Enamel and Dental Ceramics

There has been an increase in the use of ceramic restorative materials in modern dentistry. This is perhaps because of continuous patients' demands for dental restorations that simulate the appearance of their natural teeth. Although ceramic restorations provide good aesthetics, clinicians were always concerned about their abrasiveness against the natural dentition. The objective of this study was to investigate the wear of human enamel and dental ceramics using a wear machine that simulated the chewing cycle. The machine provided an impact action followed by sliding motion of a tooth specimen onto the surface of various restorative materials. Tooth specimens were prepared from the buccal cusp of extracted mandibular premolars, A total of four dental ceramic systems were tested in the study. These were Vitadur Alpha porcelain (aluminous porcelain), Vita Omega porcelain (bonded-to-metal porcelain), Duceram-LFC (hydrothermal low fusing ceramic); and Cerec Vita Mark II (machinable ceramic). Cast gold was also tested for comparison. Overall, throughout the study, a load of 40N was used with a cycle rate of 80 cycles per minute for a total of 25000 cycles. The amount of wear was determined by measuring the cusp height reduction of the tooth using a reflex microscope, and the depth of wear track on the surface of restorative materials using a Dektak 3 ST surface profile measuring system. After the wear test, specimens from both tooth and material were subjected to scanning electron microscopy for qualitative evaluation

Standards of teeth preparations for anterior resin bonded all-ceramic crowns in private dental practice in Jordan

OBJECTIVES: To investigate if general dental practitioners (GDPs) in private practice in Jordan follow universal guidelines for preparation of anterior teeth for resin bonded all-ceramic crowns (RBCs). MATERIAL AND METHODS: A sample (n=100) of laboratory models containing 208 tooth preparations for IPS Empress and In Ceram, featuring work from different GDPs, was obtained from 8 commercial dental laboratories. Aspects of preparations were quantified and compared with accepted criteria defined following a review of the literature and recommendations of the manufactures' guidelines. RESULTS: Subgingival margins on the buccal aspect were noticed in 36% of the preparations, 54% demonstrated overpreparation with a tendency to overprepare the teeth on the mesiodistal plane more than buccolingual plane. Twenty percent of samples presented a shoulder finish line while a chamfer margin design was noticed in 39%. Twenty-nine percent and 12% of samples had either a feathered or no clear margin design respectively. Incisal underpreparation was observed in 18% of dies of each type. Only 17% of all preparations were found to follow the recommended anatomical labial preparations while 29% of the RBC preparations were found to have the recommended axial convergence angle. In total, 43% of preparations were found to have the recommended depth of the finish line. CONCLUSIONS: It was found that relevant guidelines for RBC preparations were not being fully adhered to in private practice in Jordan

Standards of teeth preparations for anterior resin bonded all-ceramic crowns in private dental practice in Jordan

OBJECTIVES: To investigate if general dental practitioners (GDPs) in private practice in Jordan follow universal guidelines for preparation of anterior teeth for resin bonded all-ceramic crowns (RBCs). MATERIAL AND METHODS: A sample (n=100) of laboratory models containing 208 tooth preparations for IPS Empress and In Ceram, featuring work from different GDPs, was obtained from 8 commercial dental laboratories. Aspects of preparations were quantified and compared with accepted criteria defined following a review of the literature and recommendations of the manufactures' guidelines. RESULTS: Subgingival margins on the buccal aspect were noticed in 36% of the preparations, 54% demonstrated overpreparation with a tendency to overprepare the teeth on the mesiodistal plane more than buccolingual plane. Twenty percent of samples presented a shoulder finish line while a chamfer margin design was noticed in 39%. Twenty-nine percent and 12% of samples had either a feathered or no clear margin design respectively. Incisal underpreparation was observed in 18% of dies of each type. Only 17% of all preparations were found to follow the recommended anatomical labial preparations while 29% of the RBC preparations were found to have the recommended axial convergence angle. In total, 43% of preparations were found to have the recommended depth of the finish line. CONCLUSIONS: It was found that relevant guidelines for RBC preparations were not being fully adhered to in private practice in Jordan

Standards of teeth preparations for anterior resin bonded all-ceramic crowns in private dental practice in Jordan

OBJECTIVES: To investigate if general dental practitioners (GDPs) in private practice in Jordan follow universal guidelines for preparation of anterior teeth for resin bonded all-ceramic crowns (RBCs). MATERIAL AND METHODS: A sample (n=100) of laboratory models containing 208 tooth preparations for IPS Empress and In Ceram, featuring work from different GDPs, was obtained from 8 commercial dental laboratories. Aspects of preparations were quantified and compared with accepted criteria defined following a review of the literature and recommendations of the manufactures' guidelines. RESULTS: Subgingival margins on the buccal aspect were noticed in 36% of the preparations, 54% demonstrated overpreparation with a tendency to overprepare the teeth on the mesiodistal plane more than buccolingual plane. Twenty percent of samples presented a shoulder finish line while a chamfer margin design was noticed in 39%. Twenty-nine percent and 12% of samples had either a feathered or no clear margin design respectively. Incisal underpreparation was observed in 18% of dies of each type. Only 17% of all preparations were found to follow the recommended anatomical labial preparations while 29% of the RBC preparations were found to have the recommended axial convergence angle. In total, 43% of preparations were found to have the recommended depth of the finish line. CONCLUSIONS: It was found that relevant guidelines for RBC preparations were not being fully adhered to in private practice in Jordan