8,836 research outputs found
Alkenylation and Allylation of Aldehydes by Using an Ni/Cr/TDAE Redox System
In 360 females, Bone mineral density (BMD) in lumbar vertebrae (L2-L4) was assessed by quantitative computed tomography (QCT), and the values obtained were compared with the frequency of vertebral transformation or
fracture as assessed by lateral scan image (scanogram) by X-ray CT. A correlation was observed between the frequency of vertebral transformation (or fracture) and lumbar BMD values : BMD under 125 mg/cm(3) was observed over 90% of women with vertebral transformation, and BMD under 70mg/cm(3) was found about 50% of them. These results suggest that decrease in BMD in lumbar vertebrae leads to vertebral transformation or fracture. Thus, measurement of BMD by QCT would be very useful in predicting vertebral
transformation or fractures
Recommended from our members
Transient [3,3] Cope rearrangement of 3,3-dicyano-1,5-dienes: computational analysis and 2-step synthesis of arylcycloheptanes.
A simple and modular route to arylcycloheptene scaffolds is reported. The two-step route from Knoevenagel adducts and allylic electrophiles is made possible through the design of a Cope rearrangement that utilizes a "traceless" activating group to promote an otherwise thermodynamically unfavorable transformation. Experimentally, the [3,3] rearrangement occurrs transiently at room temperature with a computed barrier of 19.5 kcal mol-1, which ultimately allows for three-component bis-allylation. Ring-closing metathesis delivers the arylcycloheptane and removes the activating group. This report describes the design and optimization of the methodology, scope and mechanistic studies, and computational analysis
Reactive organoallyl species generated from aryl halides and allene: allylation of alpha,beta-unsaturated aldehydes and cyclic ketones employing Pd/In transmetallation processes
Allylation of α,β-unsaturated aldehydes and cyclic ketones promoted by Pd/In transmetallation processes has been studied. The unsaturated aldehydes underwent regioselective 1,2-addition to afford secondary homoally alcohols. The reactions have been performed using Pd(OAc)2/PPh3 as catalytic system and metallic indium affording the products in good yields. The same transformation with unsaturated ketones proved to be less efficient, while saturated cyclic ketones delivered generally excellent yields in the presence of CuI. In these latter processes the presence of a distal heteroatom influences the reaction rate
Gold(I)-catalysed one-pot synthesis of chromans using allylic alcohols and phenols
A gold(I)-catalysed reaction of allylic alcohols and phenols produces chromans regioselectively via a one-pot Friedel–Crafts allylation/intramolecular hydroalkoxylation sequence. The reaction is mild, practical and tolerant of a wide variety of substituents on the phenol
Palladium-catalyzed heteroallylation of unactivated alkenes – synthesis of citalopram
A palladium-catalyzed difunctionalization of unactivated alkenes with tethered nucleophiles is reported. The versatile reaction occurs with simple allylic halides and can be carried out under air. The methodology provides rapid access to a wide array of desirable heterocyclic targets, as illustrated by a concise synthesis of the widely prescribed antidepressant citalopram
Gold(I)-Catalysed Direct Thioetherifications Using Allylic Alcohols: an Experimental and Computational Study
A gold(I)-catalysed direct thioetherification reaction between allylic alcohols and thiols is presented. The reaction is generally highly regioselective (S(N)2′). This dehydrative allylation procedure is very mild and atom economical, producing only water as the by-product and avoiding any unnecessary waste/steps associated with installing a leaving or activating group on the substrate. Computational studies are presented to gain insight into the mechanism of the reaction. Calculations indicate that the regioselectivity is under equilibrium control and is ultimately dictated by the thermodynamic stability of the products
Recommended from our members
Catalytic enantioselective synthesis of quaternary carbon stereocentres.
Quaternary carbon stereocentres-carbon atoms to which four distinct carbon substituents are attached-are common features of molecules found in nature. However, before recent advances in chemical catalysis, there were few methods of constructing single stereoisomers of this important structural motif. Here we discuss the many catalytic enantioselective reactions developed during the past decade for the synthesis of single stereoisomers of such organic molecules. This progress now makes it possible to incorporate quaternary stereocentres selectively in many organic molecules that are useful in medicine, agriculture and potentially other areas such as flavouring, fragrances and materials
- …