Unambiguous Acquisition and Tracking Technique for General BOC Signals

This article presents a new unambiguous acquisition and tracking technique for general Binary Offset Carrier (BOC) ranging signals, which will be used in modern GPS, European Galileo system and Chinese BeiDou system. The test criterion employed in this technique is based on a synthesized correlation function which completely removes positive side peaks while keeping the sharp main peak. Simulation results indicate that the proposed technique completely removes the ambiguity threat in the acquisition process while maintaining relatively higher acquisition performance for low order BOC signals. The potential false lock points in the tracking phase for any order BOC signals are avoided by using the proposed method. Impacts of thermal noise and multipath on the proposed technique are investigated; the simulation results show that the new method allows the removal of false lock points with slightly degraded tracking performance. In addition, this method is convenient to implement via logic circuits

Multipath Propagation, Mitigation and Monitoring in the Light of Galileo and the Modernized GPS

Among the numerous potential sources of GNSS signal degradation, multipath takes on a prominent position. Unlike other errors like ionospheric or tropospheric path delays which can be modeled or significantly reduced by differential techniques, multipath influences cannot be mitigated by such approaches. Although a lot of multipath mitigation techniques have been proposed and developed in the past among them many receiver internal approaches using special signal processing algorithms multipath (especially multipath with small geometric path delays) still remains a major error source. This is why multipath has been a major design driver for the definition of the Galileo signal structure carried out in the past years and the subsequent signal optimization activities. This thesis tries to provide a broad and comprehensive insight into various aspects of multipath propagation, mitigation and monitoring (without claiming to be exhaustive). It contains an overview of the most important aspects of multipath propagation, including the discussion of different types of multipath signals (e.g. specular vs. diffuse multipath, satellite vs. receiver multipath or hardware-induced multipath), typical characteristics such as periodic signal variations whose frequency depends on the satellite-antenna-reflector geometry and the impact on the signal tracking process within a GNSS receiver. A large part of this thesis is dedicated to aspects of multipath mitigation, first providing a summary of the most common multipath mitigation techniques with a special focus on receiver-internal approaches such as the narrow correlation technique, double-delta correlator implementations, the Early-Late Slope (ELS) technique or Early/Early tracking implementations. However, other mitigation approaches such as using arrays of closely spaced antennas or multipath-limiting antennas are discussed as well. Some of these techniques are used for subsequent multipath performance analyses considering signals of the (modernized) GPS and Galileo. These analyses base on a new methodology to estimate typical and meaningful multipath errors making use of multipath error envelopes that are scaled in a suitable way to account for different multipath environments. It will be shown that typical (mean) multipath errors can be derived from these scaled envelopes by computation of the envelopes running average and that these mean multipath errors are of the same order as multipath errors obtained from complex statistical channel models. Another part of this thesis covers various aspects of multipath detection and monitoring. First, current techniques for multipath detection and monitoring are described and discussed with respect to their benefits and drawbacks or their real-time capability. Among the considered approaches are techniques like code minus carrier monitoring, SNR monitoring, the use of differenced observations or spectral and wavelet analysis. Following this introductory overview, a completely new approach for real-time multipath monitoring by processing multi-correlator observations will be introduced. Previously being used primarily for the detection of Evil Waveforms (signal failures that originate from a malfunction of the satellites signal generation and transmission hardware), the same basic observations (linear combinations of correlator outputs) can be used for the development of a multi-correlator-based real-time multipath monitoring system. The objective is to provide the user with instant information whether or not a signal is affected by multipath. The proposed monitoring scheme has been implemented in the form of a Matlab-based software called RTMM (Real-Time Multipath Monitor) which has been used to verify the monitoring approach and to determine its sensitivity.Die Qualität eines Satellitensignals wird durch eine Vielzahl potenzieller Fehlerquellen negativ beeinflusst. Neben atmosphärischen Einflüssen tragen Mehrwegeeinflüsse einen wesentlichen Anteil zum Gesamtfehlerbudget der Satellitennavigation bei. Während eine ganze Reihe von Fehlereinflüssen durch geeignete Modellierung oder differenzielle Verfahren deutlich reduziert werden können, ist dies durch die räumliche Dekorrelation der Mehrwegeeffekte nicht möglich. Obwohl in der Vergangenheit eine Vielzahl von Verfahren zur Mehrwegereduzierung vorgeschlagen und entwickelt wurden, stellen Mehrwegesignale noch immer eine wesentliche, stets zu berücksichtigende Fehlerquelle dar. Aus diesem Grund spielten die zu erwartenden Mehrwegefehler auch eine sehr wichtige Rolle im Zuge der Definition sowie der Optimierung der Galileo-Signalstruktur und können somit als wesentliches Design-Kriterium angesehen werden. Die vorliegende Arbeit gibt einen umfassenden Einblick in verschiedene Aspekte der Mehrwegeausbreitung, -reduzierung sowie der Detektion und der Überwachung auftretender Mehrwegeeffekte. Die Arbeit beschreibt zunächst die wichtigsten Aspekte der Mehrwegeausbreitung, wobei beispielsweise unterschiedliche Arten von Reflexionen oder unterschiedliche Entstehungsarten ebenso diskutiert werden wie typische Auswirkungen von Mehrwegesignalen wie die Entstehung periodischer Signalvariationen. Solche Signalvariationen sind in starkem Maße abhängig von der durch die Satellitenposition, dem Antennenstandpunkt und der Lage des Reflexionspunktes definierten Geometrie. Die Frequenz dieser Signalvariationen wird für unterschiedliche geometrische Verhältnisse berechnet. Zudem werden der Einfluss bzw. die Auswirkungen einer Mehrwegeausbreitung auf den Signalverarbeitungsprozess in einem GNSS Empfänger aufgezeigt. Einen weiteren Schwerpunkt dieser Arbeit bilden die derzeit gebräuchlichen Methoden zur Reduzierung von Mehrwegeeinflüssen. Dabei werden zunächst die wichtigsten empfängerinternen Ansätze vorgestellt. Aber auch Methoden wie die Verwendung von Antennenarrays oder spezieller Antennen bleiben nicht unberücksichtigt. Einige dieser Methoden bilden im Folgenden die Grundlage für die Bestimmung von typischen Mehrwegefehlern. Dazu wird eine neuartige Methodik vorgestellt, um aus Hüllkurven des Mehrwegefehlers aussagekräftige mittlere Mehrwegefehler zu bestimmen. Hierzu werden die Hüllkurven mit Hilfe einiger aus statistischen Kanalmodellen abgeleiteter Parameter in geeigneter Weise skaliert, um unterschiedlichen Mehrwegeumgebungen Rechnung zu tragen. Es wird gezeigt, dass die mit Hilfe dieser relativ einfachen und effizienten Methode ermittelten Mehrwegefehler in derselben Größenordnung liegen wie die aus komplexen statistischen Kanalmodellen ermittelten Fehler. Einen weiteren Themenkomplex stellen Methoden zur Detektion und zum Monitoring von Mehrwegeeinflüssen dar. Dabei werden zunächst derzeit verwendete Ansätze vorgestellt und hinsichtlich ihrer Vor- und Nachteile sowie hinsichtlich ihrer Echtzeitfähigkeit diskutiert. In Anschluss daran wird ein neuartiger Ansatz zur Detektion und zum Monitoring von Mehrwegesignalen in Echtzeit vorgestellt, der auf der Auswertung von Multikorrelatorbeobachtungen basiert. Ziel dieser Entwicklung ist es, einen potenziellen Nutzer sofort darüber informieren zu können, wenn ein Signal mit Mehrwegefehlern behaftet ist. Der vorgeschlagene Ansatz wurde in Form einer Matlab-basierten implementiert, welche im Folgenden zur Verifizierung und zur Bestimmung der Empfindlichkeit des Verfahrens verwendet wird

Analyzing Code Tracking Algorithms for Galileo Open Service Signal

The ever-increasing public interest on location and positioning services has originated a demand for higher performance Global Navigation Satellite Systems (GNSSs). Galileo Open Service (OS) signal, part of the European contribution to future GNSS, was designed to respond to the above demand. In all GNSSs, the estimation with high accuracy of the Line-Of-Sight (LOS) delay is a prerequisite. The Delay Lock Loops (DLLs) and their enhanced variants (i.e., feed-back code tracking loops) are the structures of choice for the commercial GNSS receivers, but their performance in severe multipath scenarios is still rather limited. In addition, the new satellite positioning system proposals specify the use of a new modulation, the Binary Offset Carrier (BOC) modulation, which triggers a new challenge in the code tracking stage. Therefore, in order to meet this emerging challenge and to improve the accuracy of the delay estimation in severe multipath scenarios, this thesis analyzes feed-back as well as feed-forward code tracking algorithms and proposes a novel algorithm, namely Peak Tracking (PT), which is a combination of both feed-back and feed-forward structures and utilizes the advantages inherent in these structures. In this thesis, the code tracking algorithms are studied and analyzed for Sine BOC (SinBOC) modulated Galileo OS signal for various multipath profiles in Rayleigh fading channel model. The performance of the analyzed algorithms are measured in terms of various well-known criteria such as Root-Mean-Square-Error (RMSE), Mean-Time-to-Lose Lock (MTLL), delay error variance and Multipath Error Envelopes (MEEs). The simulation results show that the proposed PT algorithm outperforms all other analyzed algorithms in various multipath profiles in good Carrier-to-Noise-Ratios (CNRs). The simulation results are compared with the theoretical Cramer-Rao Bound (CRB) and the comparison shows that the delay error variance for PT algorithm approaches the theoretical limit with the increase in CNR. Therefore, the proposed algorithm can be considered as an excellent candidate for implementation in future Galileo receivers, especially when tracking accuracy is a concern. /Kir1

Signal design and Theoretical bounds for Time-Of-Arrival estimation in GNSS applications

Positioning accuracy in satellite navigation systems depends on time-delay estimation (TDE) between satellite transmitted codes and local receiver replicas. This thesis is specifically focused on the problem of improving time delay estimation (TDE) accuracy of SS signals, focusing on the fundamental issue of estimation theory and on the properties of the transmitted signal. TDE fundamentals limits are deeply investigated, encompassing the Cram´er Rao Bound and the Ziv-Zakai Bound, and their modified versions to lighten their computation in presence of unknown parameters, in addiction to the time delay. The adoption of the ZZB as benchmark for both acquisition and tracking stage performance is addressed, analyzing innovative or standard signalling waveforms such as Galileo SIS. The main contributions of this thesis are dealt with the analysis of applicability of spread spectrum continuous phase-modulated (SS-CPM) and spread spectrum filtered multitone (SS-FMT) as ranging signals. A special subset of CPM, labeled as “Semi-integer MSK (SiMSK)” obtained by properly setting the modulation parameters, is revealed easily adaptable to the requirements on emissions, intrinsically constant envelope and spectral efficient, while still allowing good tracking performance. Besides, an ad hoc encoding of the SS-SiMSK enables the design of a constant envelope signal bearing two different rate services, without any approximation at the transmitter side. The analysis of the multicarrier (MC) signal revealed the high degree of freedom in its design, proposing the special Filtered Multitone (FMT) modulation as possible candidate for ranging signals. The strictly bandlimited property and the full spectral flexibility possessed by the FMT are exploited in some cases of study to adapt the system to channel conditions or in particular to emulate existing or innovative spectra. For both the SSCPM and SS-FMT modulation schemes investigated, some estimation algorithms are tested and their performance are compared to the correspondent theoretical bound