Irrigated grassland monitoring using a time series of terraSAR-X and COSMO-skyMed X-Band SAR Data

[Departement_IRSTEA]Territoires [TR1_IRSTEA]SYNERGIE [Axe_IRSTEA]TETIS-ATTOSInternational audienceThe objective of this study was to analyze the sensitivity of radar signals in the X-band in irrigated grassland conditions. The backscattered radar signals were analyzed according to soil moisture and vegetation parameters using linear regression models. A time series of radar (TerraSAR-X and COSMO-SkyMed) and optical (SPOT and LANDSAT) images was acquired at a high temporal frequency in 2013 over a small agricultural region in southeastern France. Ground measurements were conducted simultaneously with the satellite data acquisitions during several grassland growing cycles to monitor the evolution of the soil and vegetation characteristics. The comparison between the Normalized Difference Vegetation Index (NDVI) computed from optical images and the in situ Leaf Area Index (LAI) showed a logarithmic relationship with a greater scattering for the dates corresponding to vegetation well developed before the harvest. The correlation between the NDVI and the vegetation parameters (LAI, vegetation height, biomass, and vegetation water content) was high at the beginning of the growth cycle. This correlation became insensitive at a certain threshold corresponding to high vegetation (LAI ~2.5 m2/m2). Results showed that the radar signal depends on variations in soil moisture, with a higher sensitivity to soil moisture for biomass lower than 1 kg/m². HH and HV polarizations had approximately similar sensitivities to soil moisture. The penetration depth of the radar wave in the X-band was high, even for dense and high vegetation; flooded areas were visible in the images with higher detection potential in HH polarization than in HV polarization, even for vegetation heights reaching 1 m. Lower sensitivity was observed at the X-band between the radar signal and the vegetation parameters with very limited potential of the X-band to monitor grassland growth. These results showed that it is possible to track gravity irrigation and soil moisture variations from SAR X-band images acquired at high spatial resolution (an incidence angle near 30°)

Soil Moisture Estimation for landslide monitoring: A new approach using multi-temporal Synthetic Aperture RADAR data

This study explores the utility of the Spotlight2 X-band Synthetic Aperture Radar product developed by the Italian Space Agency for use in multi-temporal estimation of soil moisture in a landslide monitoring context, using a time series of monthly images of the Hollin Hill Landslide Observatory – North Yorkshire, UK. The study shows the complexity of surface soil moisture at an active landslide, using high resolution in situ soil moisture data. This in situ data is also used for ground truthing the soil moisture estimations from the SAR data. The study shows the limitations of inter-and intra-sensor calibration within the Cosmo-SkyMed array and contextualises this problem within the current research climate where SAR imagery is increasingly being created using multi-satellite constellation, while being used, increasingly, by environmental scientists rather than remote sensing specialists

Modeling L- and X-band backscattering of wheat and tests over fields of Pampas

A discrete scattering model and a detailed set of ground measurements are used to simulate the backscattering coefficients of wheat fields during the whole growth cycle. Simulations are carried out at L- and X-band, and at HH, VV, and HV polarizations. Wheat fields are located in Pampas (Argentina), and are characterized by low values of plant density. Simulations show that the backscattering coefficient is driven by variations of soil moisture at L-band, particularly for HH polarization, with low vegetation effects. Conversely, the attenuation of vegetation is dominant in producing variations of backscattering coefficients at X-band, particularly for VV polarization. Simulations are compared against experimental data collected over the same Pampas region, using airborne SARAT SAR at L-band and COSMO-SKYMED at X-band. Assuming a surface height standard deviation in a 0.4–0.7 cm range, the simulations generally agree with experimental data, with an RMSE lower than about 2 dB at L-band and X-band, except a limited number of cases. Discrepancies observed in specific conditions are discussed. Overall, the results indicate that a joint use of L- and X-band has a good potential to monitor both soil moisture and vegetation growth

On the use of temporal series of L-and X-band SAR data for soil moisture retrieval. Capitanata plain case study

This paper investigates the use of time series of ALOS/PALSAR-1 and COSMO-SkyMed data for the soil moisture retrieval (mv) by means of the SMOSAR algorithm. The application context is the exploitation of mv maps at a moderate spatial and temporal resolution for improving flood/drought monitoring at regional scale. The SAR data were acquired over the Capitanata plain in Southern Italy, over which ground campaigns were carried out in 2007, 2010 and 2011. The analysis shows that the mv retrieval accuracy is 5%-7% m^3/m^3 at L- and X band, although the latter is restricted to a use over nearly bare soil only

Modeling Watershed Response in Semiarid Regions With High-Resolution Synthetic Aperture Radars

In this paper, we propose a methodology devoted to exploit the outstanding characteristics of COSMO-SkyMed for monitoring water bodies in semiarid countries at a scale never experienced before. The proposed approach, based on appropriate registration, calibration, and processing of synthetic aperture radar (SAR) data, allows outperforming the previously available methods for monitoring small reservoirs, mainly carried out with optical data, and severely limited by the presence of cloud coverage, which is a frequent condition in wet season. A tool has been developed for computing the water volumes retained in small reservoirs based on SAR-derived digital elevation model. These data have been used to derive a relationship between storage volumes and surface areas that can be used when bathymetric information is unavailable. Due to the lack of direct measures of river's discharge, the time evolution of water volumes retained at reservoirs has been used to validate a simple rainfall-runoff hydrological model that can provide useful recommendation for the management of small reservoirs. Operational scenarios concerning the improvement in the efficiency of reservoirs management and the estimation of their impact on downstream area point out the applicative outcomes of the proposed method

Potential of X-Band Images from High-Resolution Satellite SAR Sensors to Assess Growth and Yield in Paddy Rice

The comprehensive relationship of backscattering coefficient (σ0) values from two current X-band SAR sensors (COSMO-SkyMed and TerraSAR-X) with canopy biophysical variables were investigated using the SAR images acquired at VV polarization and shallow incidence angles. The difference and consistency of the two sensors were also examined. The chrono-sequential change of σ0 in rice paddies during the transplanting season revealed that σ0 reached the value of nearby water surfaces a day before transplanting, and increased significantly just after transplanting event (3 dB). Despite a clear systematic shift (6.6 dB) between the two sensors, the differences in σ0 between target surfaces and water surfaces in each image were comparable in both sensors. Accordingly, an image-based approach using the “water-point” was proposed. It would be useful especially when absolute σ0 values are not consistent between sensors and/or images. Among the various canopy variables, the panicle biomass was found to be best correlated with X-band σ0. X-band SAR would be promising for direct assessments of rice grain yields at regional scales from space, whereas it would have limited capability to assess the whole-canopy variables only during the very early growth stages. The results provide a clear insight on the potential capability of X-band SAR sensors for rice monitoring

Biomass retrieval based on genetic algorithm feature selection and support vector regression in Alpine grassland using ground-based hyperspectral and Sentinel-1 SAR data

A general framework for the integration of multi-sensor data for dry and fresh biomass retrieval is proposed and tested in Alpine meadows and pastures. To this purpose, hyperspectral spectroradiometer (as simulation of hyperspectral imagery) and biomass samples were collected in field campaigns and Copernicus Sentinel-1 Interferometric Wide (IW) swath SAR backscattering coefficients were used. First, a genetic algorithm feature selection was performed on hyperspectral data, and afterwards the resulting most sensitive bands where combined with SAR data within a support vector regression (SVR) model. The most sensitive hyperspectral bands were mainly located in different regions of the SWIR range for both fresh and dry biomass, and in the red and near-infrared regions mainly for dry biomass, but with less influence for fresh biomass. The R (2) correlation values between the sampled and the estimated biomass range from 0.24 to 0.71. The relatively low performances are mainly related to the saturation effect in the optical bands, as well as to the paucity of points for high values of biomass. The methodology allows a better understanding of the interaction between grassland systems and the electromagnetic spectrum by offering a model with a reduced number of narrow bands in the context of a multi-sensor integration

Signal level comparison between TerraSAR-X and COSMO-SkyMed SAR Sensors

International audienceSoil and vegetation biophysical parameter retrieval using synthetic-aperture-radar images requires radiometrically well-calibrated sensors. In this letter, a comparison of signal levels between TerraSAR-X (TSX) and the COSMO-SkyMed (CSK) constellation (CSK1, CSK2, CSK3, and CSK4) was carried out in order to analyze the ability to use jointly all current X-band sensors. The analysis of the X-band signal over forest stands showed a stable signal (variation lower than 1 dB) over time for each of the studied sensors, but a significant difference was observed between the different X-band sensors. Differences between radar signals were higher in HH than in HV polarization. TSX and CSK4 showed similar backscatter signals, with signal level differences of 0.6 dB in HH and 1.4 dB in HV. The CSK3 signal was observed to be lower than those from TSX and CSK4 by about 2.1 dB and 1.5 dB in HH against 3.2 dB and 1.8 dB in HV, respectively. Moreover, CSK2 and CSK1 which showed slightly different backscatter signals (within 1.1 dB in HH and 1.9 dB in HV) had signal levels lower than those obtained from TSX (2.2-3.3 dB in HH and 3.2-5.1 dB in HV for about 29° incidence angle). These results show that it is currently difficult to use jointly the available X-band satellites (CSK and TSX) for estimating the biophysical parameters of soil or vegetation. This is due to the significant difference in the radar signal level between some of the analyzed satellites, which will cause a high overor underestimation of biophysical parameters

Comparison of Machine Learning Methods Applied to SAR Images for Forest Classification in Mediterranean Areas

In this paper, multifrequency synthetic aperture radar (SAR) images from ALOS/PALSAR, ENVISAT/ASAR and Cosmo‐SkyMed sensors were studied for forest classification in a test area in Central Italy (San Rossore), where detailed in‐situ measurements were available. A preliminary discrimination of the main land cover classes and forest types was carried out by exploiting the synergy among L‐, C‐ and X‐bands and different polarizations. SAR data were preliminarily inspected to assess the capabilities of discriminating forest from non‐forest and separating broadleaf from coniferous forests. The temporal average backscattering coefficient (°) was computed for each sensor‐polarization pair and labeled on a pixel basis according to the reference map. Several classification methods based on the machine learning framework were applied and validated considering different features, in order to highlight the contribution of bands and polarizations, as well as to assess the classifiers’ performance. The experimental results indicate that the different surface types are best identified by using all bands, followed by joint L‐ and X‐ bands. In the former case, the best overall average accuracy (83.1%) is achieved by random forest classification. Finally, the classification maps on class edges are discussed to highlight the misclassification errors