Design and Analysis of RT-Ring: A Protocol for Supporting Real-Time Communications

Distributed applications with quality of service (QoS) requirements are more and more used in several areas (e.g., automated factory networks, embedded systems, conferencing systems). These applications produce a type of traffic with hard timing requirements, i.e., transmissions must be completed within specified deadlines. To handle these transmissions, the communication system must use real-time protocols to provide a communication service that is able to satisfy the QoS requirements of the distributed applications. In this paper, we propose a new real-time protocol, called RT-Ring, able to support transmissions of both real-time and generic traffic over a ring network. RT-Ring provides both network guarantees and high network resource utilization, while ensuring the compatibility with the emerging differentiated service architectures. Network guarantees are fully proved and high network utilization is highlighted by a comparative study with the FDDI protocol. This comparison shows that RT-Ring network capacities are greater than the corresponding FDDI capacities. In fact, by assuming the FDDI frames with a length equal to the RT-Ring slot size and by using the same traffic load we show that the capacities of FDDI are equal to the lower bound capacities of RT-Ring. Index Terms Real-time protocol, quality of service (QoS) traffic, worst case analysis

Guaranteeing synchronous message deadlines with the timed token medium access control protocol

We study the problem of guaranteeing synchronous message deadlines in token ring networks where the timed token medium access control protocol is employed. Synchronous capacity, defined as the maximum time for which a node can transmit its synchronous messages every time it receives the token, is a key parameter in the control of synchronous message transmission. To ensure the transmission of synchronous messages before their deadlines, synchronous capacities must be properly allocated to individual nodes. We address the issue of appropriate allocation of the synchronous capacities. Several synchronous capacity allocation schemes are analyzed in terms of their ability to satisfy deadline constraints of synchronous messages. We show that an inappropriate allocation of the synchronous capacities could cause message deadlines to be missed even if the synchronous traffic is extremely low. We propose a scheme called the normalized proportional allocation scheme which can guarantee the synchronous message deadlines for synchronous traffic of up to 33 percent of available utilization. To date, no other synchronous capacity allocation scheme has been reported to achieve such substantial performance. Another major contribution of this paper is an extension to the previous work on the bounded token rotation time. We prove that the time elapsed between any consecutive visits to a particular node is bounded by upsilon TTRT, where TTRT is the target token rotation time set up at system initialization time. The previous result by Johnson and Sevcik is a special case where upsilon = 2. We use this result in the analysis of various synchronous allocation schemes. It can also be applied in other similar studies

Telemetry downlink interfaces and level-zero processing

The technical areas being investigated are as follows: (1) processing of space to ground data frames; (2) parallel architecture performance studies; and (3) parallel programming techniques. Additionally, the University administrative details and the technical liaison between New Mexico State University and Goddard Space Flight Center are addressed

Cycle-time properties of the timed token medium access control protocol

We investigate the timing properties of the timed token protocol that are necessary to guarantee synchronous message deadlines. A tighter upper bound on the elapse time between the token's lth arrival at any node i and its (l + v)th arrival at any node k is found. A formal proof to this generalized bound is presented

Performance Improvements for FDDI and CSMA/CD Protocols

The High-Performance Computing Initiative from the White House Office of Science and Technology Policy has defined 20 major challenges in science and engineering which are dependent on the solutions to a number of high-performance computing problems. One of the major areas of focus of this initiative is the development of gigabit rate networks to be used in environments such as the space station or a National Research and Educational Network (NREN). The strategy here is to use existing network designs as building blocks for achieving higher rates, with the ultimate goal being a gigabit rate network. Two strategies which contribute to achieving this goal are examined in detail.1 FDDI2 is a token ring network based on fiber optics capable of a 100 Mbps rate. Both media access (MAC) and physical layer modifications are considered. A method is presented which allows one to determine maximum utilization based on the token-holding timer settings. Simulation results show that employing the second counter-rotating ring in combination with destination removal has a multiplicative effect greater than the effect which either of the factors have individually on performance. Two 100 Mbps rings can handle loads in the range of 400 to 500 Mbps for traffic with a uniform distribution and fixed packet size. Performance is dependent on the number of nodes, improving as the number increases. A wide range of environments are examined to illustrate robustness, and a method of implementation is discussed

Space Station Freedom data management system growth and evolution report

The Information Sciences Division at the NASA Ames Research Center has completed a 6-month study of portions of the Space Station Freedom Data Management System (DMS). This study looked at the present capabilities and future growth potential of the DMS, and the results are documented in this report. Issues have been raised that were discussed with the appropriate Johnson Space Center (JSC) management and Work Package-2 contractor organizations. Areas requiring additional study have been identified and suggestions for long-term upgrades have been proposed. This activity has allowed the Ames personnel to develop a rapport with the JSC civil service and contractor teams that does permit an independent check and balance technique for the DMS

Future benefits and applications of intelligent on-board processing to VSAT services

The trends and roles of VSAT services in the year 2010 time frame are examined based on an overall network and service model for that period. An estimate of the VSAT traffic is then made and the service and general network requirements are identified. In order to accommodate these traffic needs, four satellite VSAT architectures based on the use of fixed or scanning multibeam antennas in conjunction with IF switching or onboard regeneration and baseband processing are suggested. The performance of each of these architectures is assessed and the key enabling technologies are identified

Guaranteed bandwidth implementation of message passing interface on workstation clusters

Due to their wide availability, networks of workstations (NOW) are an attractive platform for parallel processing. Parallel programming environments such as Parallel Virtual Machine (PVM), and Message Passing Interface (MPI) offer the user a convenient way to express parallel computing and communication for a network of workstations. Currently, a number of MPI implementations are available that offer low (average ) latency and high bandwidth environments to users by utilizing an efficient MPI library specification and high speed networks. In addition to high bandwidth and low average latency requirements, mission critical distributed applications, audio/video communications require a completely different type of service, guaranteed bandwidth and worst case delays (worst case latency) to be guaranteed by underlying protocol. The hypothesis presented in this paper is that it is possible to provide an application a low level reliable transport protocol with performance and guaranteed bandwidth as close to the hardware on which it is executing. The hypothesis is proven by designing and implementing a reliable high performance message passing protocol interface which also provides the guaranteed bandwidth to MPI and to mission critical distributed MPI applications. This protocol interface works with the Fiber Distributed Data Interface (FDDI) driver which has been designed and implemented for Performance Technology Inc. commercial high performance FDDI product, the Station Management Software 7.3, and the ADI / MPICH (Argonne National Laboratory and Mississippi State University\u27s free MPI implementation)

Data communication network at the ASRM facility

The main objective of the report is to present the overall communication network structure for the Advanced Solid Rocket Motor (ASRM) facility being built at Yellow Creek near Iuka, Mississippi. This report is compiled using information received from NASA/MSFC, LMSC, AAD, and RUST Inc. As per the information gathered, the overall network structure will have one logical FDDI ring acting as a backbone for the whole complex. The buildings will be grouped into two categories viz. manufacturing critical and manufacturing non-critical. The manufacturing critical buildings will be connected via FDDI to the Operational Information System (OIS) in the main computing center in B 1000. The manufacturing non-critical buildings will be connected by 10BASE-FL to the Business Information System (BIS) in the main computing center. The workcells will be connected to the Area Supervisory Computers (ASCs) through the nearest manufacturing critical hub and one of the OIS hubs. The network structure described in this report will be the basis for simulations to be carried out next year. The Comdisco's Block Oriented Network Simulator (BONeS) will be used for the network simulation. The main aim of the simulations will be to evaluate the loading of the OIS, the BIS, the ASCs, and the network links by the traffic generated by the workstations and workcells throughout the site