958 research outputs found
Wind-structure interaction simulations for the prediction of ovalling vibrations in silo groups
Wind-induced ovalling vibrations were observed during a storm in October 2002 on several empty silos of a closely spaced group consisting of 8 by 5 thin-walled silos in the port of Antwerp (Belgium). The purpose of the present research is to investigate if such ovalling vibrations can be predicted by means of numerical simulations. More specifically, the necessity of performing computationally demanding wind-structure interaction (WSI) simulations is assessed. For this purpose, both one-way and two-way coupled simulations are performed. Before considering the entire silo group, a single silo in crosswind is simulated. The simulation results are in reasonably good agreement with observations and WSI simulations seem to be required for a correct prediction of the observed ovalling vibrations
Recommended from our members
Investigation into the wafer-scale integration of fine-grain parallel processing computer systems
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This thesis investigates the potential of wafer-scale integration (WSI) for the implementation of low-cost fine-grain parallel processing computer systems. As WSI is a relatively new subject, there was little work on which to base investigations. Indeed, most WSI architectures existed only as untried and sometimes vague proposals. Accordingly, the research strategy approached this problem by identifying a representative WSI structure and architecture on which to base investigations. An analysis of architectural proposals identified associative memory to be general purpose parallel processing component used in a wide range of WSI architectures. Furthermore, this analysis provided a set of WSI-level design requirements to evaluate the sustainability of different architectures as research vehicles. The WSI-ASP (WASP) device, which has a large associative memory as its main component is shown to meet these requirements and hence was chosen as the research vehicle. Consequently, this thesis addresses WSI potential through an in-depth investigation into the feasibility of implementing a large associative memory for the WASP device that meets the demanding technological constraints of WSI. Overall, the thesis concludes that WSI offers significant potential for the implementation of low-cost fine-grain parallel processing computer systems. However, due to the dual constraints of thermal management and the area required for the power distribution network, power density is a major design constraint in WSI. Indeed, it is shown that WSI power densities need to be an order of magnitude lower than VLSI power densities. The thesis demonstrates that for associative memories at least, VLSI designs are unsuited to implementation in WSI. Rather, it is shown that WSI circuits must be closely matched to the operational environment to assure suitable power densities. These circuits are significantly larger than their VLSI equivalents. Nonetheless, the thesis demonstrates that by concentrating on the most power intensive circuits, it is possible to achieve acceptable power densities with only a modest increase in area overheads.SER
Wind-structure interaction simulations for the prediction of ovalling vibrations in silo groups
Wind-induced ovalling vibrations were observed during a storm in October 2002 on several empty silos of a closely spaced group consisting of 8 by 5 thin-walled silos in the port of Antwerp (Belgium). The purpose of the present research is to investigate if such ovalling vibrations can be predicted by means of numerical simulations. More specifically, the necessity of performing computationally demanding wind-structure interaction (WSI) simulations is assessed. For this purpose, both one-way and two-way coupled simulations are performed. Before considering the entire silo group, a single silo in crosswind is simulated. The simulation results are in reasonably good agreement with observations and WSI simulations seem to be required for a correct prediction of the observed ovalling vibrations
Wafer-scale integration of semiconductor memory.
This work is directed towards a study of full-slice or "wafer-scale integrated" - semiconductor memory. Previous approaches to full slice technology are studied and critically compared. It is shown that a fault-tolerant, fixed-interconnection approach offers many advantages; such a technique forms the basis of the experimental work. The
disadvantages of the conventional technology are reviewed to illustrate the potential improvements in cost, packing density and reliability obtainable with wafer-scale
integration (W.S.l).
Iterative chip arrays are modelled by a pseudorandom fault distribution; algorithms to control the linking of adjacent good - chips into linear chains are proposed and
investigated by computer simulation. It is demonstrated that long chains may be produced at practicable yield levels. The on-chip control circuitry and the external control electronics required to implement one particular algorithm are described in relation to a TTL simulation of an array of 4 X 4 integrated circuit chips. A layout of the on-chip control logic is shown to require (in 40 dynamic MOS circuitry) an area equivalent to ~250 shift register stages -a reasonable overhead on large memories.
Structures are proposed to extend the fixed-interconnection, fault-tolerant concept to parallel/serial organised memory - covering RAM, ROM and Associative Memory
applications requiring up to~ 2M bits of storage. Potential problem areas in implementing W.S.I are discussed and it is concluded that current technology is capable of manufacturing such devices. A detailed cost comparison of the conventional and W.S.I approaches to large serial memories illustrates the potential savings available with wafer-scale integration.
The problem of gaining industrial acceptance for W.S.I is discussed in relation to known and anticipated views- of new technology. The thesis concludes with suggestions for
further work in the general field of wafer-scale integration
Efficient p-multigrid spectral element model for water waves and marine offshore structures
In marine offshore engineering, cost-efficient simulation of unsteady water
waves and their nonlinear interaction with bodies are important to address a
broad range of engineering applications at increasing fidelity and scale. We
consider a fully nonlinear potential flow (FNPF) model discretized using a
Galerkin spectral element method to serve as a basis for handling both wave
propagation and wave-body interaction with high computational efficiency within
a single modellingapproach. We design and propose an efficientO(n)-scalable
computational procedure based on geometric p-multigrid for solving the Laplace
problem in the numerical scheme. The fluid volume and the geometric features of
complex bodies is represented accurately using high-order polynomial basis
functions and unstructured meshes with curvilinear prism elements. The new
p-multigrid spectralelement model can take advantage of the high-order
polynomial basis and thereby avoid generating a hierarchy of geometric meshes
with changing number of elements as required in geometric h-multigrid
approaches. We provide numerical benchmarks for the algorithmic and numerical
efficiency of the iterative geometric p-multigrid solver. Results of numerical
experiments are presented for wave propagation and for wave-body interaction in
an advanced case for focusing design waves interacting with a FPSO. Our study
shows, that the use of iterative geometric p-multigrid methods for theLaplace
problem can significantly improve run-time efficiency of FNPF simulators.Comment: Submitted to an international journal for peer revie
From Conventional to Cl-Based Spatial Analysis
Series: Discussion Papers of the Institute for Economic Geography and GIScienc
Suitable and optimal locations for implementing photovoltaic water pumping systems for grassland irrigation in China
Grassland plays a key role for the food security of China because of the large number of livestock raised in those areas. Thus, grassland degradation due to climate change and overgrazing is considered as one of the most severe environmental and economic threat for the future sustainable development of China. Photovoltaic water pumping systems for irrigation can play a fundamental role for the conservation of grassland areas.
This paper investigates the geospatial distribution of the technically suitable grassland locations for the implementation of photovoltaic water pumping systems. The technically suitable grassland areas were taken as starting point to assess the optimal locations. The assessment of the optimal locations was conducted using a spatially explicit optimization model of renewable energy systems based on the cost minimization of the whole forage supply chain.
The results indicate that the photovoltaic water pumping systems provide high potential for improving forage productivity, contributing to meet the local demand. the optimal areas are highly sensitive to several environmental and economic parameters such as increased forage potential yield, forage management costs, forage water requirements, ground water depth, forage price and CO2. Most of the optimal areas are selected when the market forage price ranges from 300 to 500 $/tonne DM, indicating that the forage produced using PVWP technology for irrigation is already competitive compared to the imported forage
- …