Electrical Test of Resistive and Capacitive Open Defects at Data Bus in 3D Memory IC

We propose an electrical test method of resistive and capacitive open defects occurring at data bus lines between dies, and between dies and I/O pins in 3D memory ICs. The test method is based on supply current of an IC. The number of test vectors for a 3D memory IC made of ND memory dies in the test method is 10∙ND and small. Also, defective interconnects are located by the test method. Feasibility of the tests is examined by some experiments for a circuit made of an SRAM IC on a printed circuit board. The experimental results show that capacitive open defects and resistive open ones whose resistance values are greater than 200Ω can be detected by the test method

Concepts for Short Range Millimeter-wave Miniaturized Radar Systems with Built-in Self-Test

This work explores short-range millimeter wave radar systems, with emphasis on miniaturization and overall system cost reduction. The designing and implementation processes, starting from the system level design considerations and characterization of the individual components to final implementation of the proposed architecture are described briefly. Several D-band radar systems are developed and their functionality and performances are demonstrated

Integrating specification and test requirements as constraints in verification strategies for 2D and 3D analog and mixed signal designs

Analog and Mixed Signal (AMS) designs are essential components of today’s modern Integrated Circuits (ICs) used in the interface between real world signals and the digital world. They present, however, significant verification challenges. Out-of-specification failures in these systems have steadily increased, and have reached record highs in recent years. Increasing design complexity, incomplete/wrong specifications (responsible for 47% of all non functional ICs) as well as additional challenges faced when testing these systems are obvious reasons. A particular example is the escalating impact of realistic test conditions with respect to physical (interface between the device under test (DUT) and the test instruments, input-signal conditions, input impedance, etc.), functional (noise, jitter) and environmental (temperature) constraints. Unfortunately, the impact of such constraints could result in a significant loss of performance and design failure even if the design itself was flawless. Current industrial verification methodologies, each addressing specific verification challenges, have been shown to be useful for detecting and eliminating design failures. Nevertheless, decreases in first pass silicon success rates illustrate the lack of cohesive, efficient techniques to allow a predictable verification process that leads to the highest possible confidence in the correctness of AMS designs. In this PhD thesis, we propose a constraint-driven verification methodology for monitoring specifications of AMS designs. The methodology is based on the early insertion of test(s) associated with each design specification. It exploits specific constraints introduced by these planned tests as well as by the specifications themselves, as they are extracted and used during the verification process, thus reducing the risk of costly errors caused by incomplete, ambiguous or missing details in the specification documents. To fully analyze the impact of these constraints on the overall AMS design behavior, we developed a two-phase algorithm that automatically integrates them into the AMS design behavioral model and performs the specifications monitoring in a Matlab simulation environment. The effectiveness of this methodology is demonstrated for two-dimensional (2D) and three-dimensional (3D) ICs. Our results show that our approach can predict out-of-specification failures, corner cases that were not covered using previous verification methodologies. On one hand, we show that specifications satisfied without specification and test-related constraints have failed in the presence of these additional constraints. On the other hand, we show that some specifications may degrade or even cannot be verified without adding specific specification and test-related constraints