Fast, non-monte-carlo estimation of transient performance variation due to device mismatch

This paper describes an efficient way of simulating the effects of device random mismatch on circuit transient characteristics, such as variations in delay or in frequency. The proposed method models DC random offsets as equivalent AC pseudo-noises and leverages the fast, linear periodically time-varying (LPTV) noise analysis available from RF circuit simulators. Therefore, the method can be considered as an extension to DC match analysis and offers a large speed-up compared to the traditional Monte-Carlo analysis. Although the assumed linear perturbation model is valid only for small variations, it enables easy ways to estimate correlations among variations and identify the most sensitive design parameters to mismatch, all at no additional simulation cost. Three benchmarks measuring the variations in the input offset voltage of a clocked comparator, the delay of a logic path, and the frequency of an oscillator demonstrate the speed improvement of about 100-1000x compared to a 1000-point Monte-Carlo method

Measurements, Models, Systems and Design

531 s.

Study of the CAC mechanisms for telecommunications systems with adaptive links according to propagation conditions

This paper presents the framework and the activities of a PhD research work in progress supported by Alcatel Alenia Space in collaboration with TeSA and SUPAERO. It deals with Connection Admission Control (CAC) for Telecommunications Systems with adaptive links according to propagation conditions. Indeed, in high frequency bands communications, deep fadings may occur because of atmospheric propagation losses. The mitigation techniques used to counteract fades impacts the system capacity, therefore the CAC mechanism. The CAC which only uses current capacity information may lead to intolerable dropping of admitted connection, and thus breaches the QoS guarantees made upon connection acceptance. New CAC mechanisms shall be studied to take into account the capacity variation and the mitigation techniques (IFMT) developed to compensate the attenuation in Ka and above frequency range

Doppler-corrected differential detection system

Doppler in a communication system operating with a multiple differential phase-shift-keyed format (MDPSK) creates an adverse phase shift in an incoming signal. An open loop frequency estimation is derived from a Doppler-contaminated incoming signal. Based upon the recognition that, whereas the change in phase of the received signal over a full symbol contains both the differentially encoded data and the Doppler induced phase shift, the same change in phase over half a symbol (within a given symbol interval) contains only the Doppler induced phase shift, and the Doppler effect can be estimated and removed from the incoming signal. Doppler correction occurs prior to the receiver's final output of decoded data. A multiphase system can operate with two samplings per symbol interval at no penalty in signal-to-noise ratio provided that an ideal low pass pre-detection filter is employed, and two samples, at 1/4 and 3/4 of the symbol interval T sub s, are taken and summed together prior to incoming signal data detection

Power Estimation Technique for DSP Architectures.

The main goal of power estimation is to optimize the power consumption of a electronic design. Power is a strongly pattern dependent function. Input statistics greatly influence on average power. We solve the pattern dependence problem for intellectual property (IP) designs. In this paper, we present a power macro-modeling technique for digital signal processing (DSP) architectures in terms of the statistical knowledge of their primary inputs. During the power estimation procedure, the sequence of an input stream is generated by a genetic algorithm using input metrics. Then, a Monte Carlo zero delay simulation is performed and a power dissipation macro-model function is built from power dissipation results. From then on, this macro-model function can be used to estimate power dissipation of the system just by using the statistics of the macro-block’s primary in puts. In experiments with the DSP system, the average error is 26%

UTHM water quality classification based on sub index

River or stream at their source is unpolluted, but as water flow downstream, the river or lake is receiving point and non-point pollutant source. Ammoniacal nitrogen (NH3- N) and suspended solids (SS) strongly influences the dynamics of the dissolved oxygen in the water. Studies on monitoring this parameter were conducted for a river or lake but limited to the small man-made lake. This study is initiate to determine the changes in water quality of UTHM watershed as the water flows from upstream to downstream. The monitoring of NH3-N and TSS were monitored at two sampling schemes, 1) at the two-week interval and, 2) at a daily basis followed by the determination of the water quality sub-index particularly SIAN and SISS. The results showed that the two lakes in UTHM watershed were classified as polluted. In conclusion, the remedial action should be implemented to improve the water quality to meet the requirements at least to meet the recreational purpose

HIGH PERFORMANCE CLOCK DISTRIBUTION FOR HIGH-SPEED VLSI SYSTEMS

Tohoku University堀口 進課