Iterative intersymbol interference cancellation in vestigial sideband Nyquist–subcarrier modulation system

This is the published version. © 2014 Society of Photo-Optical Instrumentation Engineers (SPIE)The intersymbol interference caused by dispersion, chirp, and a vestigial sideband filter in intensity modulation and a direct detection single carrier system is analyzed theoretically and numerically. An iterative nonlinear intersymbol interference cancellation technique is proposed and experimentally demonstrated in a 40- Gbps 16-QAM Mach-Zehnder modulator-based vestigial sideband intensity modulation and direct detection halfcycle Nyquist–subcarrier modulation system over a 100-km uncompensated standard single-mode fiber transmission for the first time. The experimental results show that 2.2-dB receiver sensitivity improvement is obtained at the forward error correction limit by using the iterative technique

Analysis of high capacity short reach optical links

Over the last few years, the global Internet traffic has grown exponentially due to the advent of the social networks, high definition streaming, online gaming, high performance computing and cloud services. The network is saturating, facing a challenge to provide enough capacity to such ever-demanding bandwidth expensive applications. Fiber optic communications is the only technology capable of dealing such high demands due to its advantages over the traditional electrical transmission technology. The short haul transmissions currently rely on direct detection due to low cost, low power and low complexity as compared to the coherent detection schemes. In order to increase the bit rate, several advance modulation formats are under investigation for short reach transmissions. Such links mostly use intensity modulation direct detection (IMDD) schemes providing a simple system when compared with the coherent receivers. In this thesis the performance of Multilevel Pulse Amplitude Modulation (MPAM) is studied using IMDD, providing good spectral efficiency as well as able to deal with the limited electronic devices bandwidth. MPAM can address the typical optical channel without the need to go with more complex and higher power modulation schemes. It provides a trade off between sensitivity and the complexity. So a simple communication system using MPAM is implemented using an external modulated laser transmitted over a distance of 2 km. In order to reduce the cost, single laser and single receiver technique is being adopted. The performance of the MPAM system in a bandwidth limited scenarios is studied with a possibility to use equalization techniques to improve the sensitivity. The utility of Forward Error Correction codes is also studied to improve the performance without increasing the latency. By increasing the number of bits per symbol, the system becomes more sensitive to the impairments. Moreover, the components and the connectors in the transmission system also introduces multipath interference (MPI) that is a key limitation to the use of advance modulation formats. Hence a detailed study is carried out to investigate the MPI effects. At the end, a novel idea based on reflective Mach-Zehnder modulator (MZM) is presented that reuses the modulated wavelength eliminating the need for a laser. As a consequent, the cost and power consumption specifically targeted for the optical interconnect environment is reduced. In a nutshell, the thesis provides an overview of the direct detection system targeted to the short optical links. It includes the studies related to the optical transmission systems and provides an insight of the available advance modulation formats and the detection schemes. Finally, the simulations and laboratory results are provided showing that adoption of MPAM is a viable solution that should be employed in high capacity short reach optical links

Ultra-wideband indoor communications using optical technology

La communication ultra large bande (UWB) a attiré une énorme quantité de recherches ces dernières années, surtout après la présentation du masque spectral de US Federal Communications Commission (FCC). Les impulsions ultra-courtes permettent de très hauts débits de faible puissance tout en éliminant les interférences avec les systèmes existants à bande étroite. La faible puissance, cependant, limite la portée de propagation des radios UWB à quelques mètres pour la transmission sans fil à l’intérieur d’une pièce. En outre, des signaux UWB reçu sont étendus dans le temps en raison de la propagation par trajet multiple qui résulte en beaucoup d’interférence inter-symbole (ISI) à haut débit. Le monocycle Gaussien, l’impulsion la plus commune dans UWB, a une mauvaise couverture sous le masque de la FCC. Dans cette thèse, nous démontrons des transmet- teurs qui sont capables de générer des impulsions UWB avec une efficacité de puissance élevée. Une impulsion efficace résulte dans un rapport de signal à bruit (SNR) supérieur au récepteur en utilisant plus de la puissance disponible sous le masque spectral de la FCC. On produit les impulsions dans le domaine optique et utilise la fibre optique pour les transporter sur plusieurs kilomètres pour la distribution dans un réseau optique pas- sif. La fibre optique est très fiable pour le transport des signaux radio avec une faible consommation de puissance. On utilise les éléments simples comme un modulateur Mach-Zehnder ou un résonateur en anneau pour générer des impulsions, ce qui permet l’intégration dans le silicium. Compatible avec la technologie CMOS, la photonique sur silicium a un potentiel énorme pour abaisser le coût et l’encombrement des systèmes optiques. La photodétection convertit les impulsions optiques en impulsions électriques avant la transmission sur l’antenne du côté de l’utilisateur. La réponse fréquentielle de l’antenne déforme la forme d’onde de l’impulsion UWB. Nous proposons une technique d’optimisation non-linéaire qui prend en compte la distorsion d’antenne pour trouver des impulsions qui maximisent la puissance transmise, en respectant le masque spectral de la FCC. Nous travaillons avec trois antennes et concevons une impulsion unique pour chacune d’entre elle. L’amélioration de l’énergie des impulsions UWB améliore directement la SNR au récepteur. Les résultats de simulation montrent que les impulsions optimisées améliorent considérablement le taux d’erreur (BER) par rapport au monocycle Gaussien sous propagation par trajet multiple. Notre autre contribution est l’évaluation d’un filtre adapté pour recevoir efficacement des impulsions UWB. Le filtre adapté est synthétisé et fabriqué en technologie microstrip, en collaboration avec l’Université McGill comme un dispositif de bande interdite électromagnétique. La réponse fréquentielle du filtre adapté montre une ex- cellente concordance avec le spectre ciblé de l’impulsion UWB. Les mesures de BER confirment la performance supérieure du filtre adapté par rapport à un récepteur à conversion directe. Le canal UWB est très riche en trajet multiple conduisant à l’ISI à haut débit. Notre dernière contribution est l’étude de performance des récepteurs en simulant un système avec des conditions de canaux réalistes. Les résultats de la simulation montrent que la performance d’un tel système se dégrade de façon significative pour les hauts débits. Afin de compenser la forte ISI dans les taux de transfert de données en Gb/s, nous étudions l’algorithme de Viterbi (VA) avec un nombre limité d’états et un égaliseur DFE (decision feedback equalizer). Nous examinons le nombre d’états requis dans le VA, et le nombre de coefficients du filtre dans le DFE pour une transmission fiable de UWB en Gb/s dans les canaux en ligne de vue. L’évaluation par simulation de BER confirme que l’égalisation améliore considérablement les performances par rapport à la détection de symbole. La DFE a une meilleure performance par rapport à la VA en utilisant une complexité comparable. La DFE peut couvrir une plus grande mémoire de canal avec un niveau de complexité relativement réduit.Ultra-wideband (UWB) communication has attracted an enormous amount of research in recent years, especially after the introduction of the US Federal Communications Commission (FCC) spectral mask. Ultra-short pulses allow for very high bit-rates while low power eliminates interference with existing narrowband systems. Low power, however, limits the propagation range of UWB radios to a few meters for indoors wireless transmission. Furthermore, received UWB signals are spread in time because of multipath propagation which results in high intersymbol interference at high data rates. Gaussian monocycle, the most commonly employed UWB pulse, has poor coverage under the FCC mask. In this thesis we demonstrate transmitters capable of generating UWB pulses with high power efficiency at Gb/s bit-rates. An efficient pulse results in higher signal-to-noise ratio (SNR) at the receiver by utilizing most of the available power under the FCC spectral mask. We generate the pulses in the optical domain and use optical fiber to transport the pulses over several kilometers for distribution in a passive optical network. Optical fiber is very reliable for transporting radio signals with low power consumption. We use simple elements such as a Mach Zehnder modulator or a ring resonator for pulse shaping, allowing for integration in silicon. Being compatible with CMOS technology, silicon photonics has huge potential for lowering the cost and bulkiness of optical systems. Photodetection converts the pulses to the electrical domain before antenna transmission at the user side. The frequency response of UWB antennas distorts the UWB waveforms. We pro- pose a nonlinear optimization technique which takes into account antenna distortion to find pulses that maximize the transmitted power, while respecting the FCC spectral mask. We consider three antennas and design a unique pulse for each. The energy improvement in UWB pulses directly improves the receiver SNR. Simulation results show that optimized pulses have a significant bit error rate (BER) performance improvement compared to the Gaussian monocycle under multipath propagation. Our other contribution is evaluating a matched filter to receive efficiently designed UWB pulses. The matched filter is synthesized and fabricated in microstrip technology in collaboration with McGill University as an electromagnetic bandgap device. The frequency response of the matched filter shows close agreement with the target UWB pulse spectrum. BER measurements confirm superior performance of the matched filter compared to a direct conversion receiver. The UWB channel is very rich in multipath leading to ISI at high bit rates. Our last contribution is investigating the performance of receivers by simulating a system employing realistic channel conditions. Simulation results show that the performance of such system degrades significantly for high data rates. To compensate the severe ISI at gigabit rates, we investigate the Viterbi algorithm (VA) with a limited number of states and the decision feedback equalizer (DFE). We examine the required number of states in the VA, and the number of taps in the DFE for reliable Gb/s UWB trans- mission for line-of-sight channels. Non-line-of-sight channels were also investigated at lower speeds. BER simulations confirm that equalization considerably improves the performance compared to symbol detection. The DFE results in better performance compared to the VA when using comparable complexity as the DFE can cover greater channel memory with a relatively low complexity level

Low Probability of Intercept Waveforms via Intersymbol Dither Performance under Multipath Conditions

This thesis examines the effects of multipath interference on Low Probability of Intercept (LPI) waveforms generated using intersymbol dither. LPI waveforms are designed to be difficult for non-cooperative receivers to detect and manipulate, and have many uses in secure communications applications. In prior research, such a waveform was designed using a dither algorithm to vary the time between the transmission of data symbols in a communication system. This work showed that such a method can be used to frustrate attempts to use non-cooperative receiver algorithms to recover the data. This thesis expands on prior work by examining the effects of multipath interference on cooperative and non-cooperative receiver performance to assess the above method’s effectiveness using a more realistic model of the physical transmission channel. Both two and four ray multipath interference channel models were randomly generated using typical multipath power profiles found in existing literature. Different combinations of maximum allowable symbol delay, pulse shapes and multipath channels were used to examine the bit error rate performance of 1) a Minimum Mean Squared Error (MMSE) cooperative equalizer structure with prior knowledge of the dither pattern and 2) a Constant Modulus Algorithm (CMA) non-cooperative equalizer. Cooperative MMSE equalization resulted in approximately 6-8 dB BER performance improvement in Eb/No over non-cooperative equalization, and for a full range symbol timing dither non-cooperative equalization yields a theoretical BER limit of Pb=10−1. For 50 randomly generated multipath channels, six of the four ray channels and 15 of the two ray channels exhibited extremely poor equalization results, indicating a level of algorithm sensitivity to multipath conditions

UNDERWATER COMMUNICATIONS WITH ACOUSTIC STEGANOGRAPHY: RECOVERY ANALYSIS AND MODELING

In the modern warfare environment, communication is a cornerstone of combat competence. However, the increasing threat of communications-denied environments highlights the need for communications systems with low probability of intercept and detection. This is doubly true in the subsurface environment, where communications and sonar systems can reveal the tactical location of platforms and capabilities, subverting their covert mission set. A steganographic communication scheme that leverages existing technologies and unexpected data carriers is a feasible means of increasing assurance of communications, even in denied environments. This research works toward a covert communication system by determining and comparing novel symbol recovery schemes to extract data from a signal transmitted under a steganographic technique and interfered with by a simulated underwater acoustic channel. We apply techniques for reliably extracting imperceptible information from unremarkable acoustic events robust to the variability of the hostile operating environment. The system is evaluated based on performance metrics, such as transmission rate and bit error rate, and we show that our scheme is sufficient to conduct covert communications through acoustic transmissions, though we do not solve the problems of synchronization or equalization.Lieutenant, United States NavyApproved for public release. Distribution is unlimited

ASK-based spatial multiplexing RGB scheme using symbol-dependent self-interference for detection

We propose a vsible light communication scheme utilizing red, green and blue lightemitting diodes (LEDs) and three color-Tuned photodiodes. Amplitude shift keying modulation is considered, and its effect on light emission in terms of flickering, dimming, and color rendering is discussed. The presence of interference at each photodiode generated by the other two colors is used to improve detection since interference is symbol-dependent. Moreover, the capability of the photodiodes to follow the LEDs speed is considered by analyzing the possibility of equalizing the received signal, and also self-interference mitigation is proposed. The system performance is evaluated both with computer simulations and tests on an Arduino board implementation