A study of data coding technology developments in the 1980-1985 time frame, volume 2

The source parameters of digitized analog data are discussed. Different data compression schemes are outlined and analysis of their implementation are presented. Finally, bandwidth compression techniques are given for video signals

Differential encoding techniques applied to speech signals

The increasing use of digital communication systems has produced a continuous search for efficient methods of speech encoding. This thesis describes investigations of novel differential encoding systems. Initially Linear First Order DPCM systems employing a simple delayed encoding algorithm are examined. The systems detect an overload condition in the encoder, and through a simple algorithm reduce the overload noise at the expense of some increase in the quantization (granular) noise. The signal-to-noise ratio (snr) performance of such d codec has 1 to 2 dB's advantage compared to the First Order Linear DPCM system. In order to obtain a large improvement in snr the high correlation between successive pitch periods as well as the correlation between successive samples in the voiced speech waveform is exploited. A system called "Pitch Synchronous First Order DPCM" (PSFOD) has been developed. Here the difference Sequence formed between the samples of the input sequence in the current pitch period and the samples of the stored decoded sequence from the previous pitch period are encoded. This difference sequence has a smaller dynamic range than the original input speech sequence enabling a quantizer with better resolution to be used for the same transmission bit rate. The snr is increased by 6 dB compared with the peak snr of a First Order DPCM codea. A development of the PSFOD system called a Pitch Synchronous Differential Predictive Encoding system (PSDPE) is next investigated. The principle of its operation is to predict the next sample in the voiced-speech waveform, and form the prediction error which is then subtracted from the corresponding decoded prediction error in the previous pitch period. The difference is then encoded and transmitted. The improvement in snr is approximately 8 dB compared to an ADPCM codea, when the PSDPE system uses an adaptive PCM encoder. The snr of the system increases further when the efficiency of the predictors used improve. However, the performance of a predictor in any differential system is closely related to the quantizer used. The better the quantization the more information is available to the predictor and the better the prediction of the incoming speech samples. This leads automatically to the investigation in techniques of efficient quantization. A novel adaptive quantization technique called Dynamic Ratio quantizer (DRQ) is then considered and its theory presented. The quantizer uses an adaptive non-linear element which transforms the input samples of any amplitude to samples within a defined amplitude range. A fixed uniform quantizer quantizes the transformed signal. The snr for this quantizer is almost constant over a range of input power limited in practice by the dynamia range of the adaptive non-linear element, and it is 2 to 3 dB's better than the snr of a One Word Memory adaptive quantizer. Digital computer simulation techniques have been used widely in the above investigations and provide the necessary experimental flexibility. Their use is described in the text

Time and frequency domain algorithms for speech coding

The promise of digital hardware economies (due to recent advances in VLSI technology), has focussed much attention on more complex and sophisticated speech coding algorithms which offer improved quality at relatively low bit rates. This thesis describes the results (obtained from computer simulations) of research into various efficient (time and frequency domain) speech encoders operating at a transmission bit rate of 16 Kbps. In the time domain, Adaptive Differential Pulse Code Modulation (ADPCM) systems employing both forward and backward adaptive prediction were examined. A number of algorithms were proposed and evaluated, including several variants of the Stochastic Approximation Predictor (SAP). A Backward Block Adaptive (BBA) predictor was also developed and found to outperform the conventional stochastic methods, even though its complexity in terms of signal processing requirements is lower. A simplified Adaptive Predictive Coder (APC) employing a single tap pitch predictor considered next provided a slight improvement in performance over ADPCM, but with rather greater complexity. The ultimate test of any speech coding system is the perceptual performance of the received speech. Recent research has indicated that this may be enhanced by suitable control of the noise spectrum according to the theory of auditory masking. Various noise shaping ADPCM configurations were examined, and it was demonstrated that a proposed pre-/post-filtering arrangement which exploits advantageously the predictor-quantizer interaction, leads to the best subjective performance in both forward and backward prediction systems. Adaptive quantization is instrumental to the performance of ADPCM systems. Both the forward adaptive quantizer (AQF) and the backward oneword memory adaptation (AQJ) were examined. In addition, a novel method of decreasing quantization noise in ADPCM-AQJ coders, which involves the application of correction to the decoded speech samples, provided reduced output noise across the spectrum, with considerable high frequency noise suppression. More powerful (and inevitably more complex) frequency domain speech coders such as the Adaptive Transform Coder (ATC) and the Sub-band Coder (SBC) offer good quality speech at 16 Kbps. To reduce complexity and coding delay, whilst retaining the advantage of sub-band coding, a novel transform based split-band coder (TSBC) was developed and found to compare closely in performance with the SBC. To prevent the heavy side information requirement associated with a large number of bands in split-band coding schemes from impairing coding accuracy, without forgoing the efficiency provided by adaptive bit allocation, a method employing AQJs to code the sub-band signals together with vector quantization of the bit allocation patterns was also proposed. Finally, 'pipeline' methods of bit allocation and step size estimation (using the Fast Fourier Transform (FFT) on the input signal) were examined. Such methods, although less accurate, are nevertheless useful in limiting coding delay associated with SRC schemes employing Quadrature Mirror Filters (QMF)

Bandwidth compression of color video signals

The different encoder/decoder strategies to digitally encode video using an adaptive delta modulation are described. The techniques employed are: (1) separately encoding the R, G, and B components; (2) separately encoding the I, Y, and Q components; and (3) encoding the picture in a line sequential manner

Data compression techniques applied to high resolution high frame rate video technology

An investigation is presented of video data compression applied to microgravity space experiments using High Resolution High Frame Rate Video Technology (HHVT). An extensive survey of methods of video data compression, described in the open literature, was conducted. The survey examines compression methods employing digital computing. The results of the survey are presented. They include a description of each method and assessment of image degradation and video data parameters. An assessment is made of present and near term future technology for implementation of video data compression in high speed imaging system. Results of the assessment are discussed and summarized. The results of a study of a baseline HHVT video system, and approaches for implementation of video data compression, are presented. Case studies of three microgravity experiments are presented and specific compression techniques and implementations are recommended

Investigation of digital encoding techniques for television transmission

Composite color television signals are sampled at four times the color subcarrier and transformed using intraframe two dimensional Walsh functions. It is shown that by properly sampling a composite color signal and employing a Walsh transform the YIQ time signals which sum to produce the composite color signal can be represented, in the transform domain, by three component signals in space. By suitably zonal quantizing the transform coefficients, the YIQ signals can be processed independently to achieve data compression and obtain the same results as component coding. Computer simulations of three bandwidth compressors operating at 1.09, 1.53 and 1.8 bits/ sample are presented. The above results can also be applied to the PAL color system

Low bit rate digital apeech signal processing systems

Imperial Users onl