Design, Fault Modeling and Testing Of a Fully Integrated Low Noise Amplifier (LNA) in 45 nm CMOS Technology for Inter and Intra-Chip Wireless Interconnects

Research in recent years has demonstrated that intra and inter-chip wireless interconnects are capable of establishing energy-efficient data communications within as well as between multiple chips. This thesis introduces a circuit level design of a source degenerated two stage common source low noise amplifier suitable for such wireless interconnects in 45-nm CMOS process. The design consists of a simple two-stage common source structure based Low Noise Amplifier (LNA) to boost the degraded received signal. Operating at 60GHz, the proposed low noise amplifier consumes only 4.88 mW active power from a 1V supply while providing 17.2 dB of maximum gain at 60 GHz operating frequency at very low noise figure of 2.8 dB, which translates to a figure of merit of 16.1 GHz and IIP3 as -14.38 dBm

Convergence of millimeter-wave and photonic interconnect systems for very-high-throughput digital communication applications

In the past, radio-frequency signals were commonly used for low-speed wireless electronic systems, and optical signals were used for multi-gigabit wired communication systems. However, as the emergence of new millimeter-wave technology introduces multi-gigabit transmission over a wireless radio-frequency channel, the borderline between radio-frequency and optical systems becomes blurred. As a result, there come ample opportunities to design and develop next-generation broadband systems to combine the advantages of these two technologies to overcome inherent limitations of various broadband end-to-end interconnect systems in signal generation, recovery, synchronization, and so on. For the transmission distances of a few centimeters to thousands of kilometers, the convergence of radio-frequency electronics and optics to build radio-over-fiber systems ushers in a new era of research for the upcoming very-high-throughput broadband services. Radio-over-fiber systems are believed to be the most promising solution to the backhaul transmission of the millimeter-wave wireless access networks, especially for the license-free, very-high-throughput 60-GHz band. Adopting radio-over-fiber systems in access or in-building networks can greatly extend the 60-GHz signal reach by using ultra-low loss optical fibers. However, such high frequency is difficult to generate in a straightforward way. In this dissertation, the novel techniques of homodyne and heterodyne optical-carrier suppressions for radio-over-fiber systems are investigated and various system architectures are designed to overcome these limitations of 60-GHz wireless access networks, bringing the popularization of multi-gigabit wireless networks to become closer to the reality. In addition to the advantages for the access networks, extremely high spectral efficiency, which is the most important parameter for long-haul networks, can be achieved by radio-over-fiber signal generation. As a result, the transmission performance of spectrally efficient radio-over-fiber signaling, including orthogonal frequency division multiplexing and orthogonal wavelength division multiplexing, is broadly and deeply investigated. On the other hand, radio-over-fiber is also used for the frequency synchronization that can resolve the performance limitation of wireless interconnect systems. A novel wireless interconnects assisted by radio-over-fiber subsystems is proposed in this dissertation. In conclusion, multiple advantageous facets of radio-over-fiber systems can be found in various levels of end-to-end interconnect systems. The rapid development of radio-over-fiber systems will quickly change the conventional appearance of modern communications.PhDCommittee Chair: Gee-Kung Chang; Committee Member: Bernard Kippelen; Committee Member: Shyh-Chiang Shen; Committee Member: Thomas K. Gaylord; Committee Member: Umakishore Ramachandra

Energy challenges for ICT

The energy consumption from the expanding use of information and communications technology (ICT) is unsustainable with present drivers, and it will impact heavily on the future climate change. However, ICT devices have the potential to contribute signi - cantly to the reduction of CO2 emission and enhance resource e ciency in other sectors, e.g., transportation (through intelligent transportation and advanced driver assistance systems and self-driving vehicles), heating (through smart building control), and manu- facturing (through digital automation based on smart autonomous sensors). To address the energy sustainability of ICT and capture the full potential of ICT in resource e - ciency, a multidisciplinary ICT-energy community needs to be brought together cover- ing devices, microarchitectures, ultra large-scale integration (ULSI), high-performance computing (HPC), energy harvesting, energy storage, system design, embedded sys- tems, e cient electronics, static analysis, and computation. In this chapter, we introduce challenges and opportunities in this emerging eld and a common framework to strive towards energy-sustainable ICT

Millimeter-wave interconnects for intra- and inter-chip transmission and beam steering in NoC-based multi-chip systems

The primary objective of this work is to investigate the communication capabilities of short-range millimeter-wave (mm-wave) communication among Network-on-Chip (NoC) based multi-core processors integrated on a substrate board. To address the demand for high-performance multi-chip computing systems, the present work studies the transmission coefficients between the on-chip antennas system for both intra- and inter-chip communication. It addresses techniques for enhancing transmission by using antenna arrays for beamforming. It also explores new and creative solutions to minimize the adverse effects of silicon on electromagnetic wave propagation using artificial magnetic conductors (AMC). The following summarizes the work performed and future work. Intra- and inter-chip transmission between wireless interconnects implemented as antennas on-chip (AoC), in a wire-bonded chip package are studied 30GHz and 60 GHz. The simulations are performed in ANSYS HFSS, which is based on the finite element method (FEM), to study the transmission and to analyze the electric field distribution. Simulation results have been validated with fabricated antennas at 30 GHz arranged in different orientations on silicon dies that can communicate with inter-chip transmission coefficients ranging from -45dB to -60dB while sustaining bandwidths up to 7GHz. The fabricated antennas show a shift in the resonant frequency to 25GHz. This shift is attributed to the Ground-Signal-Ground (GSG) probes used for measurement and to the Short-Open-Load (SOLT) calibration which has anomalies at millimeter-wave frequencies. Using measurements, a large-scale log-normal channel model is derived which can be used for system-level architecture design. Further, at 60 GHz densely packed multilayer copper wires in NoCs have been modeled to study their impact on the wireless transmission between antennas for both intra- and inter-chip links and are shown to be equivalent to copper sheets. It is seen that the antenna radiation efficiency reduces in the presence of these densely packed wires placed close to the antenna elements. Using this model, the reduction of inter-chip transmission is seen to be about 20dB as compared to a system with no wires. Lastly, the transmission characteristics of the antennas resonating at 60GHz in a flip-chip packaging environment are also presented

Towards Single-Chip Nano-Systems

Important scientific discoveries are being propelled by the advent of nano-scale sensors that capture weak signals from their environment and pass them to complex instrumentation interface circuits for signal detection and processing. The highlight of this research is to investigate fabrication technologies to integrate such precision equipment with nano-sensors on a single complementary metal oxide semiconductor (CMOS) chip. In this context, several demonstration vehicles are proposed. First, an integration technology suitable for a fully integrated flexible microelectrode array has been proposed. A microelectrode array containing a single temperature sensor has been characterized and the versatility under dry/wet, and relaxed/strained conditions has been verified. On-chip instrumentation amplifier has been utilized to improve the temperature sensitivity of the device. While the flexibility of the array has been confirmed by laminating it on a fixed single cell, future experiments are necessary to confirm application of this device for live cell and tissue measurements. The proposed array can potentially attach itself to the pulsating surface of a single living cell or a network of cells to detect their vital signs

Limits on Fundamental Limits to Computation

An indispensable part of our lives, computing has also become essential to industries and governments. Steady improvements in computer hardware have been supported by periodic doubling of transistor densities in integrated circuits over the last fifty years. Such Moore scaling now requires increasingly heroic efforts, stimulating research in alternative hardware and stirring controversy. To help evaluate emerging technologies and enrich our understanding of integrated-circuit scaling, we review fundamental limits to computation: in manufacturing, energy, physical space, design and verification effort, and algorithms. To outline what is achievable in principle and in practice, we recall how some limits were circumvented, compare loose and tight limits. We also point out that engineering difficulties encountered by emerging technologies may indicate yet-unknown limits.Comment: 15 pages, 4 figures, 1 tabl