523 research outputs found

    Robust fuzzy PSS design using ABC

    Get PDF
    This paper presents an Artificial Bee Colony (ABC) algorithm to tune optimal rule-base of a Fuzzy Power System Stabilizer (FPSS) which leads to damp low frequency oscillation following disturbances in power systems. Thus, extraction of an appropriate set of rules or selection of an optimal set of rules from the set of possible rules is an important and essential step toward the design of any successful fuzzy logic controller. Consequently, in this paper, an ABC based rule generation method is proposed for automated fuzzy PSS design to improve power system stability and reduce the design effort. The effectiveness of the proposed method is demonstrated on a 3-machine 9-bus standard power system in comparison with the Genetic Algorithm based tuned FPSS under different loading condition through ITAE performance indices

    Optimal design for power system dynamic stabilizer by grey prediction PID control

    Get PDF
    [[abstract]]In this paper, we proposed an effective method to design the power system stabilizers (PSS). The design of a PSS can be formulated as an optimal linear regulator control problem; however, implementing this technique requires the design of estimators. This increases the implementation and reduces the reliability of control system. Therefore, favor a control scheme that uses only some desired state variables, such as torque angle and speed. To deal with this problem, we use the optimal reduced models to reduce the power system model into two state variables system by each generator and use grey prediction PID control to find control signal of each generator. Moreover, we will apply genetic algorithms (GAs) to find the appropriate parameter values for the desired system. Finally, the advantages of the proposed method are illustrated by numerical simulation of the two machines-infinite-bus power systems.[[conferencetype]]國際[[conferencedate]]20021211~20021214[[booktype]]紙本[[iscallforpapers]]Y[[conferencelocation]]Bangkok, Thailan

    Dynamic Stability and Analysis of SMIB system with FLC Based PSS including Load Damping Parameter Sensitivity

    Get PDF
    This paper studies Dynamic Analysis and Stability of Single machine connected to infinite bus (SMIB) with power system stabilizer (PSS) in presence of Fuzzy logic controller (FLC) including load damping parameter sensitivity. Here PSS is modeled using fuzzy logic controller and the response is compared with the responses of the system in presence of conventional PI, PID controllers including load damping parameters sensitivity. In case of FLC based PSS the responses are compared different load damping parameters. Matlab-Simulink is used to test the results

    Multi-stage Fuzzy Power System Stabilizer based on Modified Shuffled Frog Leaping Algorithm

    Get PDF
    This paper presents a new strategy based on Multi-stage Fuzzy (MSF) PID controller for damping Power System Stabilizer (PSS) in multi-machine environment using Modified Shuffled Frog Leaping (MSFL) algorithm. The proposed technique is a new meta-heuristic algorithm which is inspired by mating procedure of the honey bee. Actually, the mentioned algorithm is used recently in power systems which demonstrate the good reflex of this algorithm. Also, finding the parameters of PID controller in power system has direct effect for damping oscillation. Hence, to reduce the design effort and find a better fuzzy system control, the parameters of proposed controller is obtained by MSFL that leads to design controller with simple structure that is easy to implement. The effectiveness of the proposed technique is applied to Single machine connected to Infinite Bus (SMIB) and IEEE 3-9 bus power system. The proposed technique is compared with other techniques through ITAE and FD

    Artificial Intelligence-Based Power System Stabilizers for Frequency Stability Enhancement in Multi-machine Power Systems

    Get PDF
    Low frequency oscillations (LFOs) occur in a system of interconnected generators connected by weak interconnection. A power system stabilizer (PSS) is commonly used to improve the capacity of the power system dampening. Under a variety of operating conditions, traditional PSSs fail to deliver superior damping. To address this issue, a Farmland Fertility Algorithm (FFA-PSSs controller) was used to solve an optimization problem for optimal design of PSSs system parameters, and its performance efficiency was compared to GA and PSO-based PSSs controllers. In addition to PSS, flexible current transmission (FACTS) devices are widely used. PSSs controllers and FACTS devices are frequently constructed in tandem to improve the dampening efficiency of the system. In this study, an Interline Power Flow Controller (IPFC) FACTS device will be added to the PSSs controller to improve the power system’s oscillatory stability. PSSs optimal design and supplemental controller of power fluctuations for IPFC were conducted out on WSCC multi-machine test systems using a linear system model. Using time-domain simulations and quantitative analysis, the proposed IPFC model was compared to the FFA-PSSs controller in terms of performance and efficiency. The main disadvantage of this technique is the difficulty in designing a dynamic IPFC model in test systems, as well as the burden of IPFC coordinated PSSs optimization. In both PSSs design using FFA method and FFA-optimized PSS with IPFC cases, rise in the computational and simulation costs was found unavoidable. To compensate for these flaws and obtain the research contribution, this paper proposes a Neuro-Fuzzy Controller (NFC) developed as a damping controller that can take the place of the two controllers (research objectives three). The application of the NFC substitutes the computational and simulation cost involved in designing multi-machine PSS and IPFC-FACTS systems simultaneously. With the availability of NFC in SIMULINK, a dynamic model of the WSCC three-machine system was developed under a variety of operating situations. Quantitative analysis results from the WSCC test system simulation show that when comparing the proposed NFC model to the IPFC model for the WSCC test system, the proposed NFC model was found to be 149 percent and 0 percent efficient in terms of the time to settle of rotor angle respond for G2 and G3, respectively, but 394 percent efficient when compared to the uncontrolled model. The decreased settling time values ensured the proposed NFC model’s efficacy in damping down the LFO and achieving superior stability over the two controllers. The proposed NFC model was shown significant performance improvement in both the transient and steady-state areas than when the system was designed with the two damping controllers

    ANFIS Used as a Maximum Power Point Tracking Algorithm for a Photovoltaic System

    Get PDF
    Photovoltaic (PV) modules play an important role in modern distribution networks; however, from the beginning, PV modules have mostly been used in order to produce clean, green energy and to make a profit. Working effectively during the day, PV systems tend to achieve a maximum power point accomplished by inverters with built-in Maximum Power Point Tracking (MPPT) algorithms. This paper presents an Adaptive Neuro-Fuzzy Inference System (ANFIS), as a method for predicting an MPP based on data on solar exposure and the surrounding temperature. The advantages of the proposed method are a fast response, non-invasive sampling, total harmonic distortion reduction, more efficient usage of PV modules and a simple training of the ANFIS algorithm. To demonstrate the effectiveness and accuracy of the ANFIS in relation to the MPPT algorithm, a practical sample case of 10 kW PV system and its measurements are used as a model for simulation. Modelling and simulations are performed using all available components provided by technical data. The results obtained from the simulations point to the more efficient usage of the ANFIS model proposed as an MPPT algorithm for PV modules in comparison to other existing methods

    Dynamic Sleep Scheduling on Air Pollution Levels Monitoring with Wireless Sensor Network

    Get PDF
    Wireless Sensor Network (WSN) can be applied for Air Pollution Level Monitoring System that have been determined by the Environmental Impact Management Agency which is  PM10, SO2, O3, NO2 and CO. In WSN, node system is constrained to a limited power supply, so that the node system has a lifetime. To doing lifetime maximization, power management scheme is required and sensor nodes should use energy efficiently. This paper proposes dynamic sleep scheduling using Time Category-Fuzzy Logic (Time-Fuzzy) Scheduling as a reference for calculating time interval for sleep and activated node system to support power management scheme. This research contributed in power management design to be applied to the WSN system to reduce energy expenditure. From the test result in real hardware node system, it can be seen that Time-Fuzzy Scheduling is better in terms of using the battery and it is better in terms of energy consumption too because it is more efficient 51.85% when it is compared with Fuzzy Scheduling, it is more efficient 68.81% when it is compared with Standard Scheduling and it is more efficient 85.03% when compared with No Scheduling
    corecore