Spatio-temporal influence of tundra snow properties on Ku-band (17.2 GHz) backscatter

During the 2010/11 boreal winter, a distributed set of backscatter measurements was collected using a ground-based Ku-band (17.2 GHz) scatterometer system at 26 open tundra sites. A standard snow-sampling procedure was completed after each scan to evaluate local variability in snow layering, depth, density and water equivalent (SWE) within the scatterometer field of view. The shallow depths and large basal depth hoar encountered presented an opportunity to evaluate backscatter under a set of previously untested conditions. Strong Ku-band response was found with increasing snow depth and snow water equivalent (SWE). In particular, co-polarized vertical backscatter increased by 0.82 dB for every 1 cm increase in SWE (R2 = 0.62). While the result indicated strong potential for Ku-band retrieval of shallow snow properties, it did not characterize the influence of sub-scan variability. An enhanced snow-sampling procedure was introduced to generate detailed characterizations of stratigraphy within the scatterometer field of view using near-infrared photography along the length of a 5m trench. Changes in snow properties along the trench were used to discuss variations in the collocated backscatter response. A pair of contrasting observation sites was used to highlight uncertainties in backscatter response related to short length scale spatial variability in the observed tundra environment

A Ka-band wind Geophysical Model Function using doppler scatterometer measurements from the Air-Sea Interaction Tower experiment

© The Author(s), 2022. This article is distributed under the terms of the Creative Commons Attribution License. The definitive version was published in Polverari, F., Wineteer, A., Rodríguez, E., Perkovic-Martin, D., Siqueira, P., Farrar, J., Adam, M., Closa Tarrés, M., & Edson, J. A Ka-band wind Geophysical Model Function using doppler scatterometer Measurements from the Air-Sea Interaction Tower experiment. Remote Sensing, 14(9), (2022): 2067, https://doi.org/10.3390/rs14092067.Physical understanding and modeling of Ka-band ocean surface backscatter is challenging due to a lack of measurements. In the framework of the NASA Earth Ventures Suborbital-3 Submesoscale Ocean Dynamics Experiment (S-MODE) mission, a Ka-Band Ocean continuous wave Doppler Scatterometer (KaBODS) built by the University of Massachusetts, Amherst (UMass) was installed on the Woods Hole Oceanographic Institution (WHOI) Air-Sea Interaction Tower. Together with ASIT anemometers, a new data set of Ka-band ocean surface backscatter measurements along with surface wind/wave and weather parameters was collected. In this work, we present the KaBODS instrument and an empirical Ka-band wind Geophysical Model Function (GMF), the so-called ASIT GMF, based on the KaBODS data collected over a period of three months, from October 2019 to January 2020, for incidence angles ranging between 40° and 68°. The ASIT GMF results are compared with an existing Ka-band wind GMF developed from data collected during a tower experiment conducted over the Black Sea. The two GMFs show differences in terms of wind speed and wind direction sensitivity. However, they are consistent in the values of the standard deviation of the model residuals. This suggests an intrinsic geophysical variability characterizing the Ka-band surface backscatter. The observed variability does not significantly change when filtering out swell-dominated data, indicating that the long-wave induced backscatter modulation is not the primary source of the KaBODS backscatter variability. We observe evidence of wave breaking events, which increase the skewness of the backscatter distribution in linear space, consistent with previous studies. Interestingly, a better agreement is seen between the GMFs and the actual data at an incidence angle of 60° for both GMFs, and the statistical analysis of the model residuals shows a reduced backscatter variability at this incidence angle. This study shows that the ASIT data set is a valuable reference for studies of Ka-band backscatter. Further investigations are on-going to fully characterize the observed variability and its implication in the wind GMF development.F.P. research was funded by an appointment to the NASA Postdoctoral Program initially administered by Universities Space Research Association and now administered by Oak Ridge Associated Universities, under a contract with National Aeronautics and Space Administration. A.W., E.R., D.P.-M., P.S., M.A., M.C.T. and J.T.F. received support from the S-MODE project, an EVS-3 Investigation awarded under NASA Research Announcement NNH17ZDA001N-EVS3 (JPL/Cal Tech: 80NM0019F0058, WHOI: 80NSSC19K1256, UMass Amherst: 80NSSC19K1282). J.B.E. acknowledges support from NSF under grant number OCE-1756789

Oceanographic and meteorological research based on the data products of SEASAT

Reservations were expressed concerning the sum of squares wind recovery algorithm and the power law model function. The SAS sum of squares (SOS) method for recovering winds from backscatter data leads to inconsistent results when V pol and H pol winds are compared. A model function that does not use a power law and that accounts for sea surface temperature is needed and is under study both theoretically and by means of the SASS mode 4 data. Aspects of the determination of winds by means of scatterometry and of the utilization of vector wind data for meteorological forecasts are elaborated. The operational aspect of an intermittent assimilation scheme currently utilized for the specification of the initial value field is considered with focus on quantifying the absolute 12-hour linear displacement error of the movement of low centers

Theoretical modeling of dual-frequency scatterometer response: improving ocean wind and rainfall effects

Ocean surface wind is a key parameter of the Earth’s climate system. Occurring at the interface between the ocean and the atmosphere, ocean winds modulate fluxes of heat, moisture and gas exchanges. They reflect the lower branch of the atmospheric circulation and represent a major driver of the ocean circulation. Studying the long-term trends and variability of the ocean surface winds is of key importance in our effort to understand the Earth’s climate system and the causes of its changes. More than three decades of surface wind data are available from spaceborne scatterometer/radiometer missions and there is an ongoing effort to inter-calibrate all these measurements with the aim of building a complete and continuous picture of the ocean wind variability. Currently, spaceborne scatterometer wind retrievals are obtained by inversion algorithms of empirical Geophysical Model Functions (GMFs), which represent the relationship between ocean surface backscattering coefficient and the wind parameters. However, by being measurement-dependent, the GMFs are sensor-specific and, in addition, they may be not properly defined in all weather conditions. This may reduce the accuracy of the wind retrievals in presence of rain and it may also lead to inconsistencies amongst winds retrieved by different sensors. Theoretical models of ocean backscatter have the big potential of providing a more general and understandable relation between the measured microwave backscatter and the surface wind field than empirical models. Therefore, the goal of our research is to understand and address the limitations of the theoretical modeling, in order to propose a new strategy towards the definition of a unified theoretical model able to account for the effects of both wind and rain. In this work, it is described our approach to improve the theoretical modeling of the ocean response, starting from the Ku-band (13.4 GHz) frequency and then broadening the analysis at C-band (5.3 GHz) frequency. This research has revealed the need for new understanding of the frequency-dependent modeling of the surface backscatter in response to the wind-forced surface wave spectrum. Moreover, our ocean wave spectrum modification introduced to include the influences of the surface rain, allows the interpretation/investigation of the scatterometer observations in terms not only of the surface winds but also of the surface rain, defining an additional step needed to improve the wind retrievals algorithms as well as the possibility to jointly estimate wind and rain from scatterometer observations

S-193 scatterometer backscattering cross section precision/accuracy for Skylab 2 and 3 missions

Procedures for measuring the precision and accuracy with which the S-193 scatterometer measured the background cross section of ground scenes are described. Homogeneous ground sites were selected, and data from Skylab missions were analyzed. The precision was expressed as the standard deviation of the scatterometer-acquired backscattering cross section. In special cases, inference of the precision of measurement was made by considering the total range from the maximum to minimum of the backscatter measurements within a data segment, rather than the standard deviation. For Skylab 2 and 3 missions a precision better than 1.5 dB is indicated. This procedure indicates an accuracy of better than 3 dB for the Skylab 2 and 3 missions. The estimates of precision and accuracy given in this report are for backscattering cross sections from -28 to 18 dB. Outside this range the precision and accuracy decrease significantly

Insights on the OAFlux ocean surface vector wind analysis merged from scatterometers and passive microwave radiometers (1987 onward)

Author Posting. © American Geophysical Union, 2014. This article is posted here by permission of American Geophysical Union for personal use, not for redistribution. The definitive version was published in Journal of Geophysical Research: Oceans 119 (2014): 5244–5269, doi:10.1002/2013JC009648.A high-resolution global daily analysis of ocean surface vector winds (1987 onward) was developed by the Objectively Analyzed air-sea Fluxes (OAFlux) project. This study addressed the issues related to the development of the time series through objective synthesis of 12 satellite sensors (two scatterometers and 10 passive microwave radiometers) using a least-variance linear statistical estimation. The issues include the rationale that supports the multisensor synthesis, the methodology and strategy that were developed, the challenges that were encountered, and the comparison of the synthesized daily mean fields with reference to scatterometers and atmospheric reanalyses. The synthesis was established on the bases that the low and moderate winds (<15 m s−1) constitute 98% of global daily wind fields, and they are the range of winds that are retrieved with best quality and consistency by both scatterometers and radiometers. Yet, challenges are presented in situations of synoptic weather systems due mainly to three factors: (i) the lack of radiometer retrievals in rain conditions, (ii) the inability to fill in the data voids caused by eliminating rain-flagged QuikSCAT wind vector cells, and (iii) the persistent differences between QuikSCAT and ASCAT high winds. The study showed that the daily mean surface winds can be confidently constructed from merging scatterometers with radiometers over the global oceans, except for the regions influenced by synoptic weather storms. The uncertainties in present scatterometer and radiometer observations under high winds and rain conditions lead to uncertainties in the synthesized synoptic structures.The project is sponsored by the NASA Ocean Vector Wind Science Team (OVWST) activities under grant NNA10AO86G.2015-02-1

Spectral Properties of ENVISAT ASAR and QuikSCAT Surface Winds in the North Sea

Spectra derived from ENVISAT Advanced Synthetic Aperture Radar (ASAR) and QuikSCAT near-surface ocean winds are investigated over the North Sea. The two sensors offer a wide range of spatial resolutions, from 600 m to 25 km, with different spatial coverage over the area of interest. This provides a unique opportunity to study the impact of the spatial resolution on the spectral properties of the wind over a wide range of length scales. Initially, a sub-domain in the North Sea is chosen, due to the overlap of 87 wind scenes from both sensors. The impact of the spatial resolution is manifested as an increase in spectral density over similar wavenumber ranges as the spatial resolution increases. The 600-m SAR wind product reveals a range of wavenumbers in which the exchange processes between micro- and meso-scales occur; this range is not captured by the wind products with a resolution of 1.5 km or lower. The lower power levels of coarser resolution wind products, particularly when comparing QuikSCAT to ENVISAT ASAR, strongly suggest that the effective resolution of the wind products should be high enough to resolve the spectral properties. Spectra computed from 87 wind maps are consistent with those obtained from several thousands of samples. Long-term spectra from QuikSCAT show that during the winter, slightly higher energy content is identified compared to the other seasons

Inter-comparison and evaluation of Arctic sea ice type products

oai:publications.copernicus.org:tc102910Arctic sea ice type (SITY) variation is a sensitive indicator of climate change. However, systematic inter-comparison and analysis for SITY products are lacking. This study analysed eight daily SITY products from five retrieval approaches covering the winters of 1999–2019, including purely radiometer-based (C3S-SITY), scatterometer-based (KNMI-SITY and IFREMER-SITY) and combined ones (OSISAF-SITY and Zhang-SITY). These SITY products were inter-compared against a weekly sea ice age product (i.e. NSIDC-SIA – National Snow and Ice Data Center sea ice age) and evaluated with five synthetic aperture radar (SAR) images. The average Arctic multiyear ice (MYI) extent difference between the SITY products and NSIDC-SIA varies from -1.32×106 to 0.49×106 km2. Among them, KNMI-SITY and Zhang-SITY in the QuikSCAT (QSCAT) period (2002–2009) agree best with NSIDC-SIA and perform the best, with the smallest bias of -0.001×106 km2 in first-year ice (FYI) extent and -0.02×106 km2 in MYI extent. In the Advanced Scatterometer (ASCAT) period (2007–2019), KNMI-SITY tends to overestimate MYI (especially in early winter), whereas Zhang-SITY and IFREMER-SITY tend to underestimate MYI. C3S-SITY performs well in some early winter cases but exhibits large temporal variabilities like OSISAF-SITY. Factors that could impact performances of the SITY products are analysed and summarized. (1) The Ku-band scatterometer generally performs better than the C-band scatterometer for SITY discrimination, while the latter sometimes identifies FYI more accurately, especially when surface scattering dominates the backscatter signature. (2) A simple combination of scatterometer and radiometer data is not always beneficial without further rules of priority. (3) The representativeness of training data and efficiency of classification are crucial for SITY classification. Spatial and temporal variation in characteristic training datasets should be well accounted for in the SITY method. (4) Post-processing corrections play important roles and should be considered with caution.</p

Simultaneous Wind and Rain Retrieval using Seawinds Data

The Sea Winds scatterometer is designed primarily to retrieve winds over the ocean. Since the deployment of Sea Winds on QuikSCAT in 1999, rain corruption in wind measurements has been recognized as one of the largest contributors to wind retrieval error. This paper presents a new estimation method that incorporates rain effects into Sea Winds wind retrieval. The new method simultaneously retrieves wind and rain, giving improved wind estimates in rain-corrupted areas and providing Sea Winds-derived estimates of the rain rate. The simultaneous wind/rain estimation method works especially well in the sweet spot of Sea Winds\u27 swath. On the outer-beam edges of the swath, rain estimation is not possible. This area, however, is only a small fraction of the total data. Wind speeds from simultaneous wind/rain retrieval are nearly unbiased, while the wind-only wind speeds become increasingly biased with rain rate. A synoptic example demonstrates that the new method has the capability of visually reducing the error due to rain while producing a consistent (yet somewhat noisy) estimate of the rain rate