System design issues in dense urban millimeter wave cellular networks

Upcoming deployments of cellular networks will see an increasing use of millimeter wave (mmWave) frequencies, roughly between 20-100 GHz. The goal of this dissertation is to investigate some key design issues in dense urban mmWave cellular networks by developing mathematical models that are representative of these networks. In the first contribution, stochastic geometry (SG) is used to study the per user rate performance of multi-user MIMO (MU-MIMO) in downlink mmWave cellular network incorporating the impact of a spatially sparse blockage dependent multipath channel and hybrid precoding. Performance of MU-MIMO is then compared with single-user beamforming and spatial multiplexing in different network scenarios considering coverage, rate and power consumption tradeoffs to suggest when to use which MIMO scheme. The second contribution reconsiders a popular received signal power model used in system capacity analysis of MIMO wireless networks employing single user beamforming. A modification is suggested to the model by introducing a correction factor. An approximate analysis is done to justify incorporating such a factor and simulations are performed to validate it's importance. Although this contribution does not study a new system design issue for mmWave cellular, it highlights a shortcoming with using the popular received signal power model to study design issues in mmWave cellular networks. The third and fourth contributions investigate resource allocation in self-backhauled mmWave cellular networks. In order to enable affordable initial deployments of mmWave cellular, self-backhauling is envisioned as a cost-saving solution. The third contribution investigates how to divide resources between uplink and downlink for access and backhaul in self-backhauled networks with single hop wireless backhauling. The performance of dynamic time division duplexing (TDD) and integrated access-backhaul (IAB) is compared with static TDD and orthogonal access backhaul (OAB) strategies using a SG based model. The last contribution of this dissertation addresses the following key question for self-backhauled networks. What is the maximum extended coverage area that a single fiber site can support using multi-hop relaying, while still achieving a minimum target per user data rate? The problem of maximizing minimum per user rates is studied considering a series of deployments with a single fiber site and varying number of relays. Several design guidelines for multi-hop mmWave cellular networks are provided based on the analytical and empirical results.Electrical and Computer Engineerin

Improved Handover Through Dual Connectivity in 5G mmWave Mobile Networks

The millimeter wave (mmWave) bands offer the possibility of orders of magnitude greater throughput for fifth generation (5G) cellular systems. However, since mmWave signals are highly susceptible to blockage, channel quality on any one mmWave link can be extremely intermittent. This paper implements a novel dual connectivity protocol that enables mobile user equipment (UE) devices to maintain physical layer connections to 4G and 5G cells simultaneously. A novel uplink control signaling system combined with a local coordinator enables rapid path switching in the event of failures on any one link. This paper provides the first comprehensive end-to-end evaluation of handover mechanisms in mmWave cellular systems. The simulation framework includes detailed measurement-based channel models to realistically capture spatial dynamics of blocking events, as well as the full details of MAC, RLC and transport protocols. Compared to conventional handover mechanisms, the study reveals significant benefits of the proposed method under several metrics.Comment: 16 pages, 13 figures, to appear on the 2017 IEEE JSAC Special Issue on Millimeter Wave Communications for Future Mobile Network

INTERFERENCE MANAGEMENT IN LTE SYSTEM AND BEYOUND

The key challenges to high throughput in cellular wireless communication system are interference, mobility and bandwidth limitation. Mobility has never been a problem until recently, bandwidth has been constantly improved upon through the evolutions in cellular wireless communication system but interference has been a constant limitation to any improvement that may have resulted from such evolution. The fundamental challenge to a system designer or a researcher is how to achieve high data rate in motion (high speed) in a cellular system that is intrinsically interference-limited. Multi-antenna is the solution to data on the move and the capacity of multi-antenna system has been demonstrated to increase proportionally with increase in the number of antennas at both transmitter and receiver for point-to-point communications and multi-user environment. However, the capacity gain in both uplink and downlink is limited in a multi-user environment like cellular system by interference, the number of antennas at the base station, complexity and space constraint particularly for a mobile terminal. This challenge in the downlink provided the motivation to investigate successive interference cancellation (SIC) as an interference management tool LTE system and beyond. The Simulation revealed that ordered successive interference (OSIC) out performs non-ordered successive interference cancellation (NSIC) and the additional complexity is justified based on the associated gain in BER performance of OSIC. The major drawback of OSIC is that it is not efficient in network environment employing power control or power allocation. Additional interference management techniques will be required to fully manage the interference.fi=Opinnäytetyö kokotekstinä PDF-muodossa.|en=Thesis fulltext in PDF format.|sv=Lärdomsprov tillgängligt som fulltext i PDF-format

Spectrum Sharing, Latency, and Security in 5G Networks with Application to IoT and Smart Grid

The surge of mobile devices, such as smartphones, and tables, demands additional capacity. On the other hand, Internet-of-Things (IoT) and smart grid, which connects numerous sensors, devices, and machines require ubiquitous connectivity and data security. Additionally, some use cases, such as automated manufacturing process, automated transportation, and smart grid, require latency as low as 1 ms, and reliability as high as 99.99\%. To enhance throughput and support massive connectivity, sharing of the unlicensed spectrum (3.5 GHz, 5GHz, and mmWave) is a potential solution. On the other hand, to address the latency, drastic changes in the network architecture is required. The fifth generation (5G) cellular networks will embrace the spectrum sharing and network architecture modifications to address the throughput enhancement, massive connectivity, and low latency. To utilize the unlicensed spectrum, we propose a fixed duty cycle based coexistence of LTE and WiFi, in which the duty cycle of LTE transmission can be adjusted based on the amount of data. In the second approach, a multi-arm bandit learning based coexistence of LTE and WiFi has been developed. The duty cycle of transmission and downlink power are adapted through the exploration and exploitation. This approach improves the aggregated capacity by 33\%, along with cell edge and energy efficiency enhancement. We also investigate the performance of LTE and ZigBee coexistence using smart grid as a scenario. In case of low latency, we summarize the existing works into three domains in the context of 5G networks: core, radio and caching networks. Along with this, fundamental constraints for achieving low latency are identified followed by a general overview of exemplary 5G networks. Besides that, a loop-free, low latency and local-decision based routing protocol is derived in the context of smart grid. This approach ensures low latency and reliable data communication for stationary devices. To address data security in wireless communication, we introduce a geo-location based data encryption, along with node authentication by k-nearest neighbor algorithm. In the second approach, node authentication by the support vector machine, along with public-private key management, is proposed. Both approaches ensure data security without increasing the packet overhead compared to the existing approaches