REGION-BASED ADAPTIVE DISTRIBUTED VIDEO CODING CODEC

The recently developed Distributed Video Coding (DVC) is typically suitable for the applications where the conventional video coding is not feasible because of its inherent high-complexity encoding. Examples include video surveillance usmg wireless/wired video sensor network and applications using mobile cameras etc. With DVC, the complexity is shifted from the encoder to the decoder. The practical application of DVC is referred to as Wyner-Ziv video coding (WZ) where an estimate of the original frame called "side information" is generated using motion compensation at the decoder. The compression is achieved by sending only that extra information that is needed to correct this estimation. An error-correcting code is used with the assumption that the estimate is a noisy version of the original frame and the rate needed is certain amount of the parity bits. The side information is assumed to have become available at the decoder through a virtual channel. Due to the limitation of compensation method, the predicted frame, or the side information, is expected to have varying degrees of success. These limitations stem from locationspecific non-stationary estimation noise. In order to avoid these, the conventional video coders, like MPEG, make use of frame partitioning to allocate optimum coder for each partition and hence achieve better rate-distortion performance. The same, however, has not been used in DVC as it increases the encoder complexity. This work proposes partitioning the considered frame into many coding units (region) where each unit is encoded differently. This partitioning is, however, done at the decoder while generating the side-information and the region map is sent over to encoder at very little rate penalty. The partitioning allows allocation of appropriate DVC coding parameters (virtual channel, rate, and quantizer) to each region. The resulting regions map is compressed by employing quadtree algorithm and communicated to the encoder via the feedback channel. The rate control in DVC is performed by channel coding techniques (turbo codes, LDPC, etc.). The performance of the channel code depends heavily on the accuracy of virtual channel model that models estimation error for each region. In this work, a turbo code has been used and an adaptive WZ DVC is designed both in transform domain and in pixel domain. The transform domain WZ video coding (TDWZ) has distinct superior performance as compared to the normal Pixel Domain Wyner-Ziv (PDWZ), since it exploits the ' spatial redundancy during the encoding. The performance evaluations show that the proposed system is superior to the existing distributed video coding solutions. Although the, proposed system requires extra bits representing the "regions map" to be transmitted, fuut still the rate gain is noticeable and it outperforms the state-of-the-art frame based DVC by 0.6-1.9 dB. The feedback channel (FC) has the role to adapt the bit rate to the changing ' statistics between the side infonmation and the frame to be encoded. In the unidirectional scenario, the encoder must perform the rate control. To correctly estimate the rate, the encoder must calculate typical side information. However, the rate cannot be exactly calculated at the encoder, instead it can only be estimated. This work also prbposes a feedback-free region-based adaptive DVC solution in pixel domain based on machine learning approach to estimate the side information. Although the performance evaluations show rate-penalty but it is acceptable considering the simplicity of the proposed algorithm. vii

Bridging the gap between reconstruction and synthesis

Aplicat embargament des de la data de defensa fins el 15 de gener de 20223D reconstruction and image synthesis are two of the main pillars in computer vision. Early works focused on simple tasks such as multi-view reconstruction and texture synthesis. With the spur of Deep Learning, the field has rapidly progressed, making it possible to achieve more complex and high level tasks. For example, the 3D reconstruction results of traditional multi-view approaches are currently obtained with single view methods. Similarly, early pattern based texture synthesis works have resulted in techniques that allow generating novel high-resolution images. In this thesis we have developed a hierarchy of tools that cover all these range of problems, lying at the intersection of computer vision, graphics and machine learning. We tackle the problem of 3D reconstruction and synthesis in the wild. Importantly, we advocate for a paradigm in which not everything should be learned. Instead of applying Deep Learning naively we propose novel representations, layers and architectures that directly embed prior 3D geometric knowledge for the task of 3D reconstruction and synthesis. We apply these techniques to problems including scene/person reconstruction and photo-realistic rendering. We first address methods to reconstruct a scene and the clothed people in it while estimating the camera position. Then, we tackle image and video synthesis for clothed people in the wild. Finally, we bridge the gap between reconstruction and synthesis under the umbrella of a unique novel formulation. Extensive experiments conducted along this thesis show that the proposed techniques improve the performance of Deep Learning models in terms of the quality of the reconstructed 3D shapes / synthesised images, while reducing the amount of supervision and training data required to train them. In summary, we provide a variety of low, mid and high level algorithms that can be used to incorporate prior knowledge into different stages of the Deep Learning pipeline and improve performance in tasks of 3D reconstruction and image synthesis.La reconstrucció 3D i la síntesi d'imatges són dos dels pilars fonamentals en visió per computador. Els estudis previs es centren en tasques senzilles com la reconstrucció amb informació multi-càmera i la síntesi de textures. Amb l'aparició del "Deep Learning", aquest camp ha progressat ràpidament, fent possible assolir tasques molt més complexes. Per exemple, per obtenir una reconstrucció 3D, tradicionalment s'utilitzaven mètodes multi-càmera, en canvi ara, es poden obtenir a partir d'una sola imatge. De la mateixa manera, els primers treballs de síntesi de textures basats en patrons han donat lloc a tècniques que permeten generar noves imatges completes en alta resolució. En aquesta tesi, hem desenvolupat una sèrie d'eines que cobreixen tot aquest ventall de problemes, situats en la intersecció entre la visió per computador, els gràfics i l'aprenentatge automàtic. Abordem el problema de la reconstrucció i la síntesi 3D en el món real. És important destacar que defensem un paradigma on no tot s'ha d'aprendre. Enlloc d'aplicar el "Deep Learning" de forma naïve, proposem representacions novedoses i arquitectures que incorporen directament els coneixements geomètrics ja existents per a aconseguir la reconstrucció 3D i la síntesi d'imatges. Nosaltres apliquem aquestes tècniques a problemes com ara la reconstrucció d'escenes/persones i a la renderització d'imatges fotorealistes. Primer abordem els mètodes per reconstruir una escena, les persones vestides que hi ha i la posició de la càmera. A continuació, abordem la síntesi d'imatges i vídeos de persones vestides en situacions quotidianes. I finalment, aconseguim, a través d'una nova formulació única, connectar la reconstrucció amb la síntesi. Els experiments realitzats al llarg d'aquesta tesi demostren que les tècniques proposades milloren el rendiment dels models de "Deepp Learning" pel que fa a la qualitat de les reconstruccions i les imatges sintetitzades alhora que redueixen la quantitat de dades necessàries per entrenar-los. En resum, proporcionem una varietat d'algoritmes de baix, mitjà i alt nivell que es poden utilitzar per incorporar els coneixements previs a les diferents etapes del "Deep Learning" i millorar el rendiment en tasques de reconstrucció 3D i síntesi d'imatges.Postprint (published version

Development of whole-heart myocardial perfusion magnetic resonance imaging

Myocardial perfusion imaging is of huge importance for the detection of coronary artery disease (CAD), one of the leading causes of morbidity and mortality worldwide, as it can provide non-invasive detection at the early stages of the disease. Magnetic resonance imaging (MRI) can assess myocardial perfusion by capturing the rst-pass perfusion (FPP) of a gadolinium-based contrast agent (GBCA), which is now a well-established technique and compares well with other modalities. However, current MRI methods are restricted by their limited coverage of the left ventricle. Interest has therefore grown in 3D volumetric \whole-heart" FPP by MRI, although many challenges currently limit this. For this thesis, myocardial perfusion assessment in general, and 3D whole-heart FPP in particular, were reviewed in depth, alongside MRI techniques important for achieving 3D FPP. From this, a 3D `stack-of-stars' (SOS) FPP sequence was developed with the aim of addressing some current limitations. These included the breath-hold requirement during GBCA rst-pass, long 3D shot durations corrupted by cardiac motion, and a propensity for artefacts in FPP. Parallel imaging and compressed sensing were investigated for accelerating whole-heart FPP, with modi cations presented to potentially improve robustness to free-breathing. Novel sequences were developed that were capable of individually improving some current sequence limits, including spatial resolution and signal-to-noise ratio, although with some sacri ces. A nal 3D SOS FPP technique was developed and tested at stress during free-breathing examinations of CAD patients and healthy volunteers. This enabled the rst known detection of an inducible perfusion defect with a free-breathing, compressed sensing, 3D FPP sequence; however, further investigation into the diagnostic performance is required. Simulations were performed to analyse potential artefacts in 3D FPP, as well as to examine ways towards further optimisation of 3D SOS FPP. The nal chapter discusses some limitations of the work and proposes opportunities for further investigation.Open Acces

Distractor-aware Event-based Tracking

Event cameras, or dynamic vision sensors, have recently achieved success from fundamental vision tasks to high-level vision researches. Due to its ability to asynchronously capture light intensity changes, event camera has an inherent advantage to capture moving objects in challenging scenarios including objects under low light, high dynamic range, or fast moving objects. Thus event camera are natural for visual object tracking. However, the current event-based trackers derived from RGB trackers simply modify the input images to event frames and still follow conventional tracking pipeline that mainly focus on object texture for target distinction. As a result, the trackers may not be robust dealing with challenging scenarios such as moving cameras and cluttered foreground. In this paper, we propose a distractor-aware event-based tracker that introduces transformer modules into Siamese network architecture (named DANet). Specifically, our model is mainly composed of a motion-aware network and a target-aware network, which simultaneously exploits both motion cues and object contours from event data, so as to discover motion objects and identify the target object by removing dynamic distractors. Our DANet can be trained in an end-to-end manner without any post-processing and can run at over 80 FPS on a single V100. We conduct comprehensive experiments on two large event tracking datasets to validate the proposed model. We demonstrate that our tracker has superior performance against the state-of-the-art trackers in terms of both accuracy and efficiency

Application and Theory of Multimedia Signal Processing Using Machine Learning or Advanced Methods

This Special Issue is a book composed by collecting documents published through peer review on the research of various advanced technologies related to applications and theories of signal processing for multimedia systems using ML or advanced methods. Multimedia signals include image, video, audio, character recognition and optimization of communication channels for networks. The specific contents included in this book are data hiding, encryption, object detection, image classification, and character recognition. Academics and colleagues who are interested in these topics will find it interesting to read

Entropy in Image Analysis III

Image analysis can be applied to rich and assorted scenarios; therefore, the aim of this recent research field is not only to mimic the human vision system. Image analysis is the main methods that computers are using today, and there is body of knowledge that they will be able to manage in a totally unsupervised manner in future, thanks to their artificial intelligence. The articles published in the book clearly show such a future

REGION-BASED ADAPTIVE DISTRIBUTED VIDEO CODING CODEC

The recently developed Distributed Video Coding (DVC) is typically suitable for the applications where the conventional video coding is not feasible because of its inherent high-complexity encoding. Examples include video surveillance usmg wireless/wired video sensor network and applications using mobile cameras etc. With DVC, the complexity is shifted from the encoder to the decoder. The practical application of DVC is referred to as Wyner-Ziv video coding (WZ) where an estimate of the original frame called "side information" is generated using motion compensation at the decoder. The compression is achieved by sending only that extra information that is needed to correct this estimation. An error-correcting code is used with the assumption that the estimate is a noisy version of the original frame and the rate needed is certain amount of the parity bits. The side information is assumed to have become available at the decoder through a virtual channel. Due to the limitation of compensation method, the predicted frame, or the side information, is expected to have varying degrees of success. These limitations stem from locationspecific non-stationary estimation noise. In order to avoid these, the conventional video coders, like MPEG, make use of frame partitioning to allocate optimum coder for each partition and hence achieve better rate-distortion performance. The same, however, has not been used in DVC as it increases the encoder complexity. This work proposes partitioning the considered frame into many coding units (region) where each unit is encoded differently. This partitioning is, however, done at the decoder while generating the side-information and the region map is sent over to encoder at very little rate penalty. The partitioning allows allocation of appropriate DVC coding parameters (virtual channel, rate, and quantizer) to each region. The resulting regions map is compressed by employing quadtree algorithm and communicated to the encoder via the feedback channel. The rate control in DVC is performed by channel coding techniques (turbo codes, LDPC, etc.). The performance of the channel code depends heavily on the accuracy of virtual channel model that models estimation error for each region. In this work, a turbo code has been used and an adaptive WZ DVC is designed both in transform domain and in pixel domain. The transform domain WZ video coding (TDWZ) has distinct superior performance as compared to the normal Pixel Domain Wyner-Ziv (PDWZ), since it exploits the ' spatial redundancy during the encoding. The performance evaluations show that the proposed system is superior to the existing distributed video coding solutions. Although the, proposed system requires extra bits representing the "regions map" to be transmitted, fuut still the rate gain is noticeable and it outperforms the state-of-the-art frame based DVC by 0.6-1.9 dB. The feedback channel (FC) has the role to adapt the bit rate to the changing ' statistics between the side infonmation and the frame to be encoded. In the unidirectional scenario, the encoder must perform the rate control. To correctly estimate the rate, the encoder must calculate typical side information. However, the rate cannot be exactly calculated at the encoder, instead it can only be estimated. This work also prbposes a feedback-free region-based adaptive DVC solution in pixel domain based on machine learning approach to estimate the side information. Although the performance evaluations show rate-penalty but it is acceptable considering the simplicity of the proposed algorithm. vii