1,025 research outputs found
Robust Transceiver Design for IRS-Assisted Cascaded MIMO Systems
{Robust transceiver design against unresolvable system uncertainties is of
crucial importance for reliable communication. We consider a MIMO multi-hop
system, where the source, the relay, and the destination are equipped with
multiple antennas. Further, an intelligent reconfigurable surface (IRS) is
established to cancel the RSI as much as possible. The considered
decode-and-forward (DF) hybrid relay can operate in either half-duplex or
full-duplex mode, and the mode changes adaptively depending on the RSI
strength. We investigate a robust transceiver design problem, which maximizes
the throughput rate corresponding to the worst-case RSI under a
self-interference channel uncertainty bound constraint. To the best of our
knowledge, this is the first work that uses the IRS for RSI cancellation in
MIMO full-duplex DF relay systems. The yielded problem turns out to be a
non-convex optimization problem, where the non-convex objective is optimized
over the cone of semidefinite matrices. We propose a closed-from lower bound
for the IRS worst case RSI cancellation. Eventually, we show an important
result that, for the worst case scenario, IRS can be helpful only if the number
of IRS elements are at least as large as the size of the interference channel.
Moreover, a novel method based on majorization theory is proposed to find the
best response of the transmitters and relay against worst case RSI.
Furthermore, we propose a multi-level water-filling algorithm to obtain a
locally optimal solution iteratively. Finally, we obtain insights on the
optimal antenna allocation at the relay input-frontend and output-frontend, for
relay reception and transmission, respectively.Comment: arXiv admin note: substantial text overlap with arXiv:1912.1283
Hardware Impairments Aware Transceiver Design for Full-Duplex Amplify-and-Forward MIMO Relaying
In this work we study the behavior of a full-duplex (FD) and
amplify-and-forward (AF) relay with multiple antennas, where hardware
impairments of the FD relay transceiver is taken into account. Due to the
inter-dependency of the transmit relay power on each antenna and the residual
self-interference in an FD-AF relay, we observe a distortion loop that degrades
the system performance when the relay dynamic range is not high. In this
regard, we analyze the relay function in presence of the hardware inaccuracies
and an optimization problem is formulated to maximize the signal to
distortion-plus-noise ratio (SDNR), under relay and source transmit power
constraints. Due to the problem complexity, we propose a
gradient-projection-based (GP) algorithm to obtain an optimal solution.
Moreover, a nonalternating sub-optimal solution is proposed by assuming a
rank-1 relay amplification matrix, and separating the design of the relay
process into multiple stages (MuStR1). The proposed MuStR1 method is then
enhanced by introducing an alternating update over the optimization variables,
denoted as AltMuStR1 algorithm. It is observed that compared to GP, (Alt)MuStR1
algorithms significantly reduce the required computational complexity at the
expense of a slight performance degradation. Finally, the proposed methods are
evaluated under various system conditions, and compared with the methods
available in the current literature. In particular, it is observed that as the
hardware impairments increase, or for a system with a high transmit power, the
impact of applying a distortion-aware design is significant.Comment: Submitted to IEEE Transactions on Wireless Communication
Improving Bandwidth Efficiency in E-band Communication Systems
The allocation of a large amount of bandwidth by regulating bodies in the
70/80 GHz band, i.e., the E-band, has opened up new potentials and challenges
for providing affordable and reliable Gigabit per second wireless
point-to-point links. This article first reviews the available bandwidth and
licensing regulations in the E-band. Subsequently, different propagation
models, e.g., the ITU-R and Cane models, are compared against measurement
results and it is concluded that to meet specific availability requirements,
E-band wireless systems may need to be designed with larger fade margins
compared to microwave systems. A similar comparison is carried out between
measurements and models for oscillator phase noise. It is confirmed that phase
noise characteristics, that are neglected by the models used for narrowband
systems, need to be taken into account for the wideband systems deployed in the
E-band. Next, a new multi-input multi-output (MIMO) transceiver design, termed
continuous aperture phased (CAP)-MIMO, is presented. Simulations show that
CAP-MIMO enables E-band systems to achieve fiber-optic like throughputs.
Finally, it is argued that full-duplex relaying can be used to greatly enhance
the coverage of E-band systems without sacrificing throughput, thus,
facilitating their application in establishing the backhaul of heterogeneous
networks.Comment: 16 pages, 6 Figures, Journal paper. IEEE Communication Magazine 201
Hybrid Transceiver Optimization for Multi-Hop Communications
Multi-hop communication with the aid of large-scale antenna arrays will play
a vital role in future emergence communication systems. In this paper, we
investigate amplify-and-forward based and multiple-input multiple-output
assisted multi-hop communication, in which all nodes employ hybrid
transceivers. Moreover, channel errors are taken into account in our hybrid
transceiver design. Based on the matrix-monotonic optimization framework, the
optimal structures of the robust hybrid transceivers are derived. By utilizing
these optimal structures, the optimizations of analog transceivers and digital
transceivers can be separated without loss of optimality. This fact greatly
simplifies the joint optimization of analog and digital transceivers. Since the
optimization of analog transceivers under unit-modulus constraints is
non-convex, a projection type algorithm is proposed for analog transceiver
optimization to overcome this difficulty. Based on the derived analog
transceivers, the optimal digital transceivers can then be derived using
matrix-monotonic optimization. Numeral results obtained demonstrate the
performance advantages of the proposed hybrid transceiver designs over other
existing solutions.Comment: 32 pages, 6 figures. This manuscript has been submitted to IEEE
Journal on Selected Areas in Communications (special issue on Multiple
Antenna Technologies for Beyond 5G
- …