Robust Andrew's sine estimate adaptive filtering

The Andrew's sine function is a robust estimator, which has been used in outlier rejection and robust statistics. However, the performance of such estimator does not receive attention in the field of adaptive filtering techniques. Two Andrew's sine estimator (ASE)-based robust adaptive filtering algorithms are proposed in this brief. Specifically, to achieve improved performance and reduced computational complexity, the iterative Wiener filter (IWF) is an attractive choice. A novel IWF based on ASE (IWF-ASE) is proposed for impulsive noises. To further reduce the computational complexity, the leading dichotomous coordinate descent (DCD) algorithm is combined with the ASE, developing DCD-ASE algorithm. Simulations on system identification demonstrate that the proposed algorithms can achieve smaller misalignment as compared to the conventional IWF, recursive maximum correntropy criterion (RMCC), and DCD-RMCC algorithms in impulsive noise. Furthermore, the proposed algorithms exhibit improved performance in partial discharge (PD) denoising.Comment: 5 pages, 5 figure

Microprocessor based signal processing techniques for system identification and adaptive control of DC-DC converters

PhD ThesisMany industrial and consumer devices rely on switch mode power converters (SMPCs) to provide a reliable, well regulated, DC power supply. A poorly performing power supply can potentially compromise the characteristic behaviour, efficiency, and operating range of the device. To ensure accurate regulation of the SMPC, optimal control of the power converter output is required. However, SMPC uncertainties such as component variations and load changes will affect the performance of the controller. To compensate for these time varying problems, there is increasing interest in employing real-time adaptive control techniques in SMPC applications. It is important to note that many adaptive controllers constantly tune and adjust their parameters based upon on-line system identification. In the area of system identification and adaptive control, Recursive Least Square (RLS) method provide promising results in terms of fast convergence rate, small prediction error, accurate parametric estimation, and simple adaptive structure. Despite being popular, RLS methods often have limited application in low cost systems, such as SMPCs, due to the computationally heavy calculations demanding significant hardware resources which, in turn, may require a high specification microprocessor to successfully implement. For this reason, this thesis presents research into lower complexity adaptive signal processing and filtering techniques for on-line system identification and control of SMPCs systems. The thesis presents the novel application of a Dichotomous Coordinate Descent (DCD) algorithm for the system identification of a dc-dc buck converter. Two unique applications of the DCD algorithm are proposed; system identification and self-compensation of a dc-dc SMPC. Firstly, specific attention is given to the parameter estimation of dc-dc buck SMPC. It is computationally efficient, and uses an infinite impulse response (IIR) adaptive filter as a plant model. Importantly, the proposed method is able to identify the parameters quickly and accurately; thus offering an efficient hardware solution which is well suited to real-time applications. Secondly, new alternative adaptive schemes that do not depend entirely on estimating the plant parameters is embedded with DCD algorithm. The proposed technique is based on a simple adaptive filter method and uses a one-tap finite impulse response (FIR) prediction error filter (PEF). Experimental and simulation results clearly show the DCD technique can be optimised to achieve comparable performance to classic RLS algorithms. However, it is computationally superior; thus making it an ideal candidate technique for low cost microprocessor based applications.Iraq Ministry of Higher Educatio

Soft-Decision-Driven Sparse Channel Estimation and Turbo Equalization for MIMO Underwater Acoustic Communications

Multi-input multi-output (MIMO) detection based on turbo principle has been shown to provide a great enhancement in the throughput and reliability of underwater acoustic (UWA) communication systems. Benefits of the iterative detection in MIMO systems, however, can be obtained only when a high quality channel estimation is ensured. In this paper, we develop a new soft-decision-driven sparse channel estimation and turbo equalization scheme in the triply selective MIMO UWA. First, the Homotopy recursive least square dichotomous coordinate descent (Homotopy RLS-DCD) adaptive algorithm, recently proposed for sparse single-input single-output system identification, is extended to adaptively estimate rapid time-varying MIMO sparse channels. Next, the more reliable a posteriori soft-decision symbols, instead of the hard decision symbols or the a priori soft-decision symbols, at the equalizer output, are not only feedback to the Homotopy RLS-DCD-based channel estimator but also to the minimum mean-square-error (MMSE) equalizer. As the turbo iterations progress, the accuracy of channel estimation and the quality of the MMSE equalizer are improved gradually, leading to the enhancement in the turbo equalization performance. This also allows the reduction in pilot overhead. The proposed receiver has been tested by using the data collected from the SHLake2013 experiment. The performance of the receiver is evaluated for various modulation schemes, channel estimators, and MIMO sizes. Experimental results demonstrate that the proposed a posteriori soft-decision-driven sparse channel estimation based on the Homotopy RLS-DCD algorithm and turbo equalization offer considerable improvement in system performance over other turbo equalization schemes

Performance Analysis of Linear-Equality-Constrained Least-Squares Estimation

We analyze the performance of a linear-equality-constrained least-squares (CLS) algorithm and its relaxed version, called rCLS, that is obtained via the method of weighting. The rCLS algorithm solves an unconstrained least-squares problem that is augmented by incorporating a weighted form of the linear constraints. As a result, unlike the CLS algorithm, the rCLS algorithm is amenable to our approach to performance analysis presented here, which is akin to the energy-conservation-based methodology. Therefore, we initially inspect the convergence properties and evaluate the precision of estimation as well as satisfaction of the constraints for the rCLS algorithm in both mean and mean-square senses. Afterwards, we examine the performance of the CLS algorithm by evaluating the limiting performance of the rCLS algorithm as the relaxation parameter (weight) approaches infinity. Numerical examples verify the accuracy of the theoretical findings

Microprocessor based signal processing techniques for system identification and adaptive control of DC-DC converters

Many industrial and consumer devices rely on switch mode power converters (SMPCs) to provide a reliable, well regulated, DC power supply. A poorly performing power supply can potentially compromise the characteristic behaviour, efficiency, and operating range of the device. To ensure accurate regulation of the SMPC, optimal control of the power converter output is required. However, SMPC uncertainties such as component variations and load changes will affect the performance of the controller. To compensate for these time varying problems, there is increasing interest in employing real-time adaptive control techniques in SMPC applications. It is important to note that many adaptive controllers constantly tune and adjust their parameters based upon on-line system identification. In the area of system identification and adaptive control, Recursive Least Square (RLS) method provide promising results in terms of fast convergence rate, small prediction error, accurate parametric estimation, and simple adaptive structure. Despite being popular, RLS methods often have limited application in low cost systems, such as SMPCs, due to the computationally heavy calculations demanding significant hardware resources which, in turn, may require a high specification microprocessor to successfully implement. For this reason, this thesis presents research into lower complexity adaptive signal processing and filtering techniques for on-line system identification and control of SMPCs systems. The thesis presents the novel application of a Dichotomous Coordinate Descent (DCD) algorithm for the system identification of a dc-dc buck converter. Two unique applications of the DCD algorithm are proposed; system identification and self-compensation of a dc-dc SMPC. Firstly, specific attention is given to the parameter estimation of dc-dc buck SMPC. It is computationally efficient, and uses an infinite impulse response (IIR) adaptive filter as a plant model. Importantly, the proposed method is able to identify the parameters quickly and accurately; thus offering an efficient hardware solution which is well suited to real-time applications. Secondly, new alternative adaptive schemes that do not depend entirely on estimating the plant parameters is embedded with DCD algorithm. The proposed technique is based on a simple adaptive filter method and uses a one-tap finite impulse response (FIR) prediction error filter (PEF). Experimental and simulation results clearly show the DCD technique can be optimised to achieve comparable performance to classic RLS algorithms. However, it is computationally superior; thus making it an ideal candidate technique for low cost microprocessor based applications.EThOS - Electronic Theses Online ServiceIraq Ministry of Higher EducationGBUnited Kingdo