A Novel Circulating Current Suppression for Paralleled Current Source Converter Based on Virtual Impedance Concept

The circulating current is one of the important issues for parallel converters. It affects the system stable operation and degrades the power quality. In order to reduce the circulating current of the parallel converter and reduce the harmonic pollution to the power grid, a new circulating current suppression strategy is proposed for the parallel current source converter without any communication line. This strategy is able to realize the current sharing between parallel modules by changing the external characteristics of the parallel modules to thus suppress the circulating current among the parallel current source converters. The proposed control strategy adopts DC-side droop control and AC-side virtual impedance control. The DC-side droop control is used to generate the reference voltage of each parallel module, while the AC-side virtual impedance is used to the circulating current suppression. We performed a time domain test of the parallel converter, and the results show that the proposed control strategy reduced the RMS circulating current of the parallel converter by 50% and effectively reduced the grid-side current THD while ensuring the stable operation of the converter. The effectiveness of the proposed control strategy was, therefore, verified

Wide frequency range active damping of LCL-filtered grid connected converters

It can be challenging to guarantee the stability of grids with many converters with LCL filters connected due to the presence of multiple resonances within the system. This paper presents an active damping technique to mitigate multiple resonance effects and harmonics in power converters connected to weak grids. The proposed technique employs grid current and capacitor voltage feedback to achieve active damping for a wide range of multiple resonance frequencies. The effectiveness of the proposed wide frequency active damping and improved controller stability are demonstrated through frequency domain analysis and experimental results for single and parallel grid connected converters

Suppression of line voltage related distortion in current controlled grid connected inverters

The influence of selected control strategies on the level of low-order current harmonic distortion generated by an inverter connected to a distorted grid is investigated through a combination of theoretical and experimental studies. A detailed theoretical analysis, based on the concept of harmonic impedance, establishes the suitability of inductor current feedback versus output current feedback with respect to inverter power quality. Experimental results, obtained from a purpose-built 500-W, three-level, half-bridge inverter with an L-C-L output filter, verify the efficacy of inductor current as the feedback variable, yielding an output current total harmonic distortion (THD) some 29% lower than that achieved using output current feedback. A feed-forward grid voltage disturbance rejection scheme is proposed as a means to further reduce the level of low-order current harmonic distortion. Results obtained from an inverter with inductor current feedback and optimized feed-forward disturbance rejection show a THD of just 3% at full-load, representing an improvement of some 53% on the same inverter with output current feedback and no feed-forward compensation. Significant improvements in THD were also achieved across the entire load range. It is concluded that the use of inductor current feedback and feed-forward voltage disturbance rejection represent cost–effect mechanisms for achieving improved output current quality

Performance Analysis of Adaptive Notch Filter Active Damping Methods for Grid-Connected Converters under a Varying Grid Impedance

Grid connected converters commonly use LCL filters for harmonic content suppression. However, associated with such filters is a resonant frequency at which the gain value increases significantly. To mitigate this problem, a notch filter is introduced into the current control loop of the converter. When tuned to the LCL resonant frequency, it introduces an opposing notch, thereby neutralizing the resonance effect. To ensure robustness of the control system, the notch filter must be made adaptive. This will ensure any variation in the resonant frequency, either due to a change in grid impedance or aging of components, can be tracked accurately. This paper provides two novel methods of online tuning for the adaptive notch filter using grid impedance estimation and discrete Fourier transform (DFT) techniques. Simulation results show that both methods are capable of fast and accurate detection of the resonant frequency, for varying strengths of the grid