Control and structural optimization for maneuvering large spacecraft

Presented here are the results of an advanced control design as well as a discussion of the requirements for automating both the structures and control design efforts for maneuvering a large spacecraft. The advanced control application addresses a general three dimensional slewing problem, and is applied to a large geostationary platform. The platform consists of two flexible antennas attached to the ends of a flexible truss. The control strategy involves an open-loop rigid body control profile which is derived from a nonlinear optimal control problem and provides the main control effort. A perturbation feedback control reduces the response due to the flexibility of the structure. Results are shown which demonstrate the usefulness of the approach. Software issues are considered for developing an integrated structures and control design environment

NASA/DOD Control/Structures Interaction Technology, 1986

Papers presented at the CSI Technology Conference are given. The conference was jointly sponsored by the NASA Office of Aeronautics and Space Technology and the Department of Defense. The conference is the beginning of a series of annual conferences whose purpose is to report to industry, academia, and government agencies the current status of Control/Structures Interaction technology. The conference program was divided into five sessions: (1) Future spacecraft requirements; Technology issues and impact; (2) DOD special topics; (3) Large space systems technology; (4) Control of flexible structures, and (5) Selected NASA research in control structures interaction

On the Attitude Control by Thruster of a Spinning Solar Sail and Bending Moment's Effect Analysis

The membrane dynamics of spinning solar sails have a special relevance when considering attitude control of the spacecraft. Because of being non-rigid structures, local deformation occurs, changing the overall effect of the Solar Radiation Pressure, which might lead to attitude disturbances and unexpected behavior. Thus, an accurate model and study of such dynamics is needed. Until this point, several researches on the topic have been conducted (Nakano, T., et al., 2005 - Takao, Y., 2018), modeling the membrane as a completely flexible body. However, the deformation observed in IKAROS (a spacecraft developed by the Japan Aerospace Exploration Agency (JAXA) to demonstrate solar sail technology) during its low-spin operation suggested a higher rigidity of the sail than the predicted one (Shirasawa, Y.,et al., 2012). The difference between the observed and the predicted deformation of IKAROS is believed to be caused by the bending stiffness present in the membrane. First, this study shows that the bending moment has strong effects on the attitude of the sail during its spin axis reorientation. Given the difficulty of measuring the actual bending stiffness of the membrane, it is necesOutgoin

Large space structure experiments for AAP. Volume 2 - Analysis and evaluation of space structure concepts Final report, 15 Sep. 1966 - 15 Sep. 1967

Systems analyses of space erectable structure concepts for Apollo Applications Progra

The dynamics and control of large flexible space structures, part 11

A mathematical model is developed to predict the dynamics of the proposed Spacecraft Control Laboratory Experiment during the stationkeeping phase. The Shuttle and reflector are assumed to be rigid, while the mass connecting the Shuttle to the reflector is assumed to be flexible with elastic deformations small as compared with its length. It is seen that in the presence of gravity-gradient torques, the system assumes a new equilibrium position primarily due to the offset in the mass attachment point to the reflector from the reflector's mass center. Control is assumed to be provided through the Shuttle's three torquers and throught six actuators located by painrs at two points on the mass and at the reflector mass center. Numerical results confirm the robustness of an LQR derived control strategy during stationkeeping with maximum control efforts significantly below saturation levels. The linear regulator theory is also used to derive control laws for the linearized model of the rigidized SCOLE configuration where the mast flexibility is not included. It is seen that this same type of control strategy can be applied for the rapid single axis slewing of the SCOLE through amplitudes as large as 20 degrees. These results provide a definite trade-off between the slightly larger slewing times with the considerable reduction in over-all control effort as compared with the results of the two point boundary value problem application of Pontryagin's Maximum Principle

Autonomous pointing control of a large satellite antenna subject to parametric uncertainty

With the development of satellite mobile communications, large antennas are now widely used. The precise pointing of the antenna’s optical axis is essential for many space missions. This paper addresses the challenging problem of high-precision autonomous pointing control of a large satellite antenna. The pointing dynamics are firstly proposed. The proportional–derivative feedback and structural filter to perform pointing maneuvers and suppress antenna vibrations are then presented. An adaptive controller to estimate actual system frequencies in the presence of modal parameters uncertainty is proposed. In order to reduce periodic errors, the modified controllers, which include the proposed adaptive controller and an active disturbance rejection filter, are then developed. The system stability and robustness are analyzed and discussed in the frequency domain. Numerical results are finally provided, and the results have demonstrated that the proposed controllers have good autonomy and robustness

Advances in Spacecraft Systems and Orbit Determination

"Advances in Spacecraft Systems and Orbit Determinations", discusses the development of new technologies and the limitations of the present technology, used for interplanetary missions. Various experts have contributed to develop the bridge between present limitations and technology growth to overcome the limitations. Key features of this book inform us about the orbit determination techniques based on a smooth research based on astrophysics. The book also provides a detailed overview on Spacecraft Systems including reliability of low-cost AOCS, sliding mode controlling and a new view on attitude controller design based on sliding mode, with thrusters. It also provides a technological roadmap for HVAC optimization. The book also gives an excellent overview of resolving the difficulties for interplanetary missions with the comparison of present technologies and new advancements. Overall, this will be very much interesting book to explore the roadmap of technological growth in spacecraft systems

Lunar Orbiter program guidance and control system design survey Final report

Design criteria for Lunar Orbiter program guidance and control syste