Smart Power Devices and ICs Using GaAs and Wide and Extreme Bandgap Semiconductors

We evaluate and compare the performance and potential of GaAs and of wide and extreme bandgap semiconductors (SiC, GaN, Ga2O3, diamond), relative to silicon, for power electronics applications. We examine their device structures and associated materials/process technologies and selectively review the recent experimental demonstrations of high voltage power devices and IC structures of these semiconductors. We discuss the technical obstacles that still need to be addressed and overcome before large-scale commercialization commences

The Role of Frequency and Duty Cycle on the Gate Reliability of p-GaN HEMTs

In this letter, we present an extensive analysis on the role of both switching frequency (ranging from 100 kHz to 1 MHz) and duty cycle (from 10% to 90%) on the time-dependent gate breakdown of high electron mobility transistors (HEMTs) with Schottky metal to p-GaN gate. More specifically, results show how the gate lifetime of GaN HEMTs increases by reducing the frequency and the duty cycle of the stressing gate signal (VG). Such behavior is ascribed to the OFF-time, which is responsible to alter the electrostatic potential in the p-GaN layer during the rising phases of VG (from OFF- to ON-state). Findings of this analysis are useful both for further technology improvement and for GaN-based power circuit designers

The effects of carbon on the bidirectional threshold voltage instabilities induced by negative gate bias stress in GaN MIS-HEMTs

In this paper, numerical device simulations are used to point out the possible contributions of carbon doping to the threshold voltage instabilities induced by negative gate bias stress in AlGaN/GaN metal–insulator–semiconductor high-electron mobility transistors. It is suggested that carbon can have a role in both negative and positive threshold voltage shifts, as a result of (1) the changes in the total negative charge stored in the carbon-related acceptor traps in the GaN buffer, and (2) the attraction of carbon-related free holes to the device surface and their capture into interface traps or recombination with gate-injected electrons. For a proper device optimization of carbon-doped MIS-HEMTs, it is therefore important to take these mechanisms into account, in addition to those related to defects in the gate dielectric volume and interface which are conventionally held responsible for threshold voltage instabilities

GaN Power Devices: Discerning Application-Specific Challenges and Limitations in HEMTs

GaN power devices are typically used in the 600 V market, for high efficiency, high power-density systems. For these devices, the lateral optimization of gate-to-drain, gate, and gate-to-source lengths, as well as gate field-plate length are critical for optimizing breakdown voltage and performance. This work presents a systematic study of lateral scaling optimization for high voltage devices to minimize figure of merit and maximize breakdown voltage. In addition, this optimization is extended for low voltage devices ( \u3c 100 V), presenting results to optimize both lateral features and vertical features. For low voltage design, simulation work suggests that breakdown is more reliant on punch-through as the primary breakdown mechanism rather than on vertical leakage current as is the case with high-voltage devices. A fabrication process flow has been developed for fabricating Schottky-gate, and MIS-HEMT structures at UCF in the CREOL cleanroom. The fabricated devices were designed to validate the simulation work for low voltage GaN devices. The UCF fabrication process is done with a four layer mask, and consists of mesa isolation, ohmic recess etch, an optional gate insulator layer, ohmic metallization, and gate metallization. Following this work, the fabrication process was transferred to the National Nano Device Laboratories (NDL) in Hsinchu, Taiwan, to take advantage of the more advanced facilities there. Following fabrication, a study has been performed on defect induced performance degradation, leading to the observation of a new phenomenon: trap induced negative differential conductance (NDC). Typically NDC is caused by self-heating, however by implementing a substrate bias test in conjunction with pulsed I-V testing, the NDC seen in our fabricated devices has been confirmed to be from buffer traps that are a result of poor channel carrier confinement during the dc operating condition