Frequency-adaptive virtual flux estimation for grid synchronization under unbalanced conditions

This paper proposes a new and explicitly frequencyadaptive method for Virtual Flux estimation and voltage sensorless grid synchronization under unbalanced conditions. The proposed system is based on using Second Order Generalized Integrators, arranged to simultaneously fulfill the purposes of frequency-adaptive band-pass filtering, integration and quadrature signal generation. This results in a simple and efficient structure for combined Virtual Flux estimation and separation into positive and negative sequence components. The properties of the proposed Virtual Flux model is analyzed theoretically, first as an integrator for implementing generic Virtual Flux estimation, and then with respect to sequence separation. The dynamic performance of the proposed estimation method is tested by simulations for the case of an unbalanced voltage drop in the grid and for a step in grid frequency. The simulations verify the performance to be as expected, with similar dynamics as synchronization based on voltage measurements.Peer ReviewedPostprint (published version

Power conversion for a modular lightweight direct-drive wind turbine generator

A power conversion system for a modular lightweight direct-drive wind turbine generator has been proposed, based on a modular cascaded multilevel voltage-source inverter. Each module of the inverter is connected to two generator coils, which eliminates the problem of DC-link voltage balancing found in multilevel inverters with a large number of levels.The slotless design of the generator, and modular inverter, means that a high output voltage can be achieved from the inverter, while using standard components in the modules. Analysis of the high voltage issues shows that isolating the modules to a high voltage is easily possible, but insulating the generator coils could result in a signicant increase in the airgap size, reducing the generator effciency. A boost rectier input to the modules was calculated to have the highest electrical effciency of all the rectier systems tested, as well as the highest annual power extraction, while having a competitive cost. A rectier control system, based on estimating the generator EMF from the coil current and drawing a sinusoidal current in phase with the EMF, was developed. The control system can mitigate the problem of airgap eccentricity, likely to be present in a lightweight generator. A laboratory test rig was developed, based on two 2.5kW generators, with 12 coils each. A single phase of the inverter, with 12 power modules, was implemented, with each module featuring it's own microcontroller. The system is able to produce a good quality AC voltage waveform, and is able to tolerate the fault of a single module during operation. A decentralised inverter control system was developed, based on all modules estimating the grid voltage position and synchronising their estimates. Distributed output current limiting was also implemented, and the system is capable of riding through grid faults

Synchronverter-based control for wind power

More and more attention has been paid to the energy crisis due to the increasing energy demand from industrial and commercial applications. The utilisation of wind power, which is considered as one of the most promising renewable energy sources, has grown rapidly in the last three decades. In recent years, many power converter techniques have been developed to integrate wind power with the electrical grid. The use of power electronic converters allows for variable speed operation of wind turbines, and enhanced power extraction. This work, which is supported by EPSRC and Nheolis under the DHPA scheme, focuses on the design and analysis of control systems for wind power. In this work, two of the most popular AC-DC-AC topologies with permanent magnet synchronous generators (PMSG) have been developed. One consists of an uncontrollable rectifier, a boost converter and an inverter and a current control scheme is proposed to achieve the maximum power point tracking (MPPT). In the control strategy, the output current of the uncontrollable rectifier is controlled by a boost converter according to the current reference, which is determined by a climbing algorithm, to achieve MPPT. The synchronverter technology has been applied to control the inverter for the grid-connection. An experimental setup based on DSP has been designed to implement all the above mentioned experiments. In addition, a synchronverter-based parallel control strategy, which consists of a frequency droop loop and a voltage droop loop to achieve accurate sharing of real power and reactive power respectively, has been further studied. Moreover, a control strategy based on the synchronverter has been presented to force the inverter to have capacitive output impedance, so that the quality of the output voltage is improved. Abstract The other topology consists of a full-scale back-to-back converter, of which the rectifier is controllable. Two control strategies have been proposed to operate a three-phase rectifier to mimic a synchronous motor, following the idea of synchronverters to operate inverters to mimic synchronous generators. In the proposed schemes, the real power extracted from the source and the output voltage are the control variables, respectively, hence they can be employed in different applications. Furthermore, improved control strategies are proposed to self-synchronise with the grid. This does not only improve the performance of the system but also considerably reduces the complexity of the overall controller. All experiments have been implemented on a test rig based on dSPACE to demonstrate the excellent performance of the proposed control strategies with unity power factor, sinusoidal currents and good dynamics. Finally, an original control strategy based on the synchronverter technology has been proposed for back-to-back converters in wind power applications to make the whole system behave as a generator-motor-generator system

Performance of direct power controlled grid-connected voltage source converters

PhD ThesisIn this thesis the performance of direct power controlled grid-connected voltage source converters (VSCs) is investigated. Of particular interest is the stability of the controller with the third-order LCL filter employed as the grid filter, effect of grid impedance variations and grid voltage distortion, and current limitation during voltage dips. The control scheme implemented is virtual-flux direct power control with space vector modulation (VF-DPC-SVM). By mathematical modelling and stability analysis, it is found that the closed-loop power control system is stable for all values of proportional gain when the current sensors are on the inverter side of the LCL filter. The inverter current together with the estimated grid virtual-flux is used to estimate the active power and the reactive power. The difference between the estimated reactive power and the reactive power on the grid side is compensated for, using a new reactive power error compensation scheme based on the estimated capacitor current. The control system is found to be robust to changes in grid inductance, and remains stable for a range of grid inductance values, and controller proportional gain. It is demonstrated in simulation and experimentally that the total harmonic distortion (THD) of the current injected by the VSC is less than the limit of 5 %, set by standards, for all different values of grid inductance and proportional gain. This is true even in the presence of significant grid voltage distortion. To control the VSC during voltage dips without damaging the semiconductor devices, a new current limiting algorithm is proposed and implemented. The positive-sequence component of the virtual-flux is used for synchronization and power estimation to achieve balanced, undistorted currents during unsymmetrical voltage dips. Experimental results show that the current achieved during unsymmetrical voltage dips is balanced and has a THD of less than 3 %.Commonwealth Scholarship and Fellowship Plan, Copperbelt Universit

Fast Harmonic compensation in hybrid HVDC offshore system

Hybrid HVDC systems have been proposed as an alternative for nominal VSC-Based HVDC for offshore applications. Hybrid HVDC systems consist of an offshore power station composed of the connection of high-power diode rectifiers in series with a fractional power VSC-HVDC. This hybrid configuration allows large power transfer from offshore sites, with the added robustness, simplicity and efficiency of uncontrolled rectifiers. In this research, a robust and fast-acting controller, the Two Degrees of Freedom Internal Model controller (2DF-IMC), is used to control the active power filter features of the fractional-power VSC-HVDC system, resulting in a much faster overall THD reduction in the offshore AC currents in dynamic conditions (i.e. time-varying wind power) when compared with standard active power filter controllers. This improvement is the direct consequence of the fast closed-loop dynamics of the 2DF-IMC controller that do not require filtering stages. Additionally, the increased closed-loop response time did not affect the overall robustness of the control system, thanks to the enhanced disturbance rejection capabilities of the 2DF-IMC configuration

Control strategy of grid connected power converter based on virtual flux approach

A la portada consta el nom del programa interuniversitari: Joint Doctoral Programme in Electric Energy Systems [by the] Universidad de Málaga, Universidad de Sevilla, Universidad del País Vasco/Euskal Erriko Unibertsitatea i Universitat Politècnica de CatalunyaDistributed Generation (DG) provides an alternative to the Centralized Generation (CG) by means of generating electricity near to the end user of power with the employment of small-scale technologies to produce electricity, mainly using Renewable Energy Sources (RES). The prospects of renewable energy integration during the next years are still very optimistic. This PhD dissertation is made to provide an alternative control framework for the grid connected power converter by adopting the virtual flux concept in the control layer. This dissertation can be divided into three main topics. The 1st topic presents the voltage sensorless control system for the grid-connected power converter. The control system presented is done without depending on AC-voltage measurement where the grid synchronization is based on the Virtual Flux (VF) estimation. In this regard, the Frequency Locked Loop (FLL) is used in conjunction with the estimation scheme to make the system fully adaptive to the frequency changes. This voltage sensorless application is useful for reducing cost and complexity of the control hardware. It is also can be utilized in case of limited reliability or availability of voltage measurements at the intended point of synchronization to the grid. Considering that most previous studies are based on the VF estimation for the case of power converter connected to the grid through the L-filter or LC-filter, this dissertation is focused on the power converter connected to the grid through the LCL filter. The Proportional Resonant (PR) current controller is adopted in the inner loop control of the power electronics-based converter to test the performance of such system. Another control method based on VF synchronization that permits to control the active and reactive power delivery in a remote point of the grid is also presented in this dissertation. This is due to the fact that the VF is implemented that the voltage in a remote point of the line can be estimated. As it will be shown in simulations and experiments, the proposed control scheme provides a good tracking and dynamic performance under step changes in the reference power. The fast synchronization and the smooth reference tracking achieved in transient conditions have demonstrated the effectiveness of the Dual Second Order Generalized Integrator controlled as Quadrature Signal Generator (DSOGI-QSG) and also the current controller used in the proposed system. In addition to the power control itself, this study could also benefit the frequency and the voltage regulation methods in distributed generation applications as for instance in microgrid. Considering the fact that the grid connected power converter can be controlled as a virtual synchronous generator where the flux is a variable to be used for controlling its operation, this dissertation also presents a Virtual Synchronous Flux Controller (VSFC) as a new control framework of the grid connected power converter. In this regard, a new control strategy in the inner loop control of the power converter will be proposed. The main components of the outer loop control of VSFC are based on the active and reactive power control. The results presented show that the VSFC works well to control the active and reactive power without considering any synchronization system. The inner loop control is able to work as it is required, and the measurement flux is able to track the reference flux without any significant delays. All the work presented in this dissertation are supported by mathematical and simulation analysis. In order to endorse the conclusions achieved, a complete experimental validations have been conducted before wrapping this dissertation with a conclusion and recommendation for future enhancement of the control strategies that have been presented.Postprint (published version

Design and implementation of a grid-connected variable-speed PM WECS

Includes bibliographical references (leaves 120-122).As renewable energy (RE) sources are increasingly becoming an integral part of the world's power generation capacity, they are becoming more sophisticated and provide a solid platform for power generation today. Wind Energy is the fastest growing RE source. The correct understanding of issues associated with this technology and how to address them is integral in furthering this RE source... The main objective of the work presented in this thesis is the full understanding and implementation of a PM Wind Turbine System

Predictive control of a series-input, parallel-output, back-to-back, flying-capacitor multilevel converter

Thesis (MScEng (Electrical and Electronic Engineering))--Stellenbosch University, 2011.ENGLISH ABSTRACT: This thesis investigates the viability of constructing a solid-state transformer (SST) with a series-input, parallel-output connection of full-bridge, three-level ying-capacitor converters. It focusses on the active recti er front-end of the SST which is used to control the input current to be sinusoidal and in-phase with the sinusoidal input voltage. A stack of two converters are built and tested. The input current, as well as the ying capacitor voltages of the two active recti ers in the stack, are actively controlled by a nite-state model-based predictive (FS-MPC) controller. The use of multiple ying-capacitor converters poses a problem when using FS-MPC because of the large number of possible switching states to include in the prediction equations. Three FS-MPC control algorithms are proposed to attempt to overcome the problem associated with the large number of switching states. They are implemented on an FPGA digital controller. The algorithms are compared on the bases of voltage and current errors, as well as their responses to disturbances that are introduced into the system. The simulation and experimental results that are presented shows that by interleaving the control actions for the two converters, one can obtain fast and robust responses of the controlled variables. The viability of extending the interleaving control algorithm beyond two converters is also motivated.AFRIKAANSE OPSOMMING: Hierdie tesis ondersoek die moontlikheid van volbrug, drievlak vlieënde-kapasitoromsetters wat gebruik word om 'n serie-intree, parallel-uittree drywingselektroniese transformator (DET) te bou. Dit fokus op die aktiewe gelykrigter van die DET wat gebruik word om die intreestroom te beheer om sinusvormig en in fase met die sinusvormige intreespanning te wees. 'n Stapel van twee omsetters word gebou en getoets. Die intreestroom, sowel as die vlieënde kapasitorspannings van die twee aktiewe gelykrigters in die stapel, word aktief beheer met behulp van 'n eindige-toestand, model-gebaseerde voorspellende beheerder (ET-MVB). Die gebruik van veelvuldige vlieënde-kapasitoromsetters bemoeilik die implementering van 'n ET-MVB-beheerder as gevolg van die groot aantal skakeltoestande wat in die voorspellende vergelykings in ag geneem moet word. Drie ET-MVB-algoritmes word voorgestel om te poog om die probleme, wat met die groot aantal skakeltoestande geassosieer word, te oorkom. Die algoritmes word in 'n FPGA digitale verwerker geïmplementeer. Die algoritmes word vergelyk op grond van hul stroom- en spanningsfoute, asook hul reaksie op steurings wat op die stelsel ingevoer word. Die simulasie en praktiese resultate toon dat, deur die beheeraksies vir die twee omsetters te laat oorvleuel, die gedrag van die beheerde veranderlikes vinniger en meer robuust is. Die moontlikheid om die oorvleuelende beheeraksies uit te brei tot meer as twee omsetters word ook gemotiveer