Channel equalization to achieve high bit rates in discrete multitone systems

textMulticarrier modulation (MCM) techniques such as orthogonal frequency division multiplexing (OFDM) and discrete multi-tone (DMT) modulation are attractive for high-speed data communications due to the ease with which MCM can combat channel dispersion. With all the benefits MCM could give, DMT modulation has an extra ability to perform dynamic bit loading, which has the potential to exploit fully the available bandwidth in a slowly time-varying channel. In broadband wireline communications, DMT modulation is standardized for asymmetric digital subscribe line (ADSL) and very-high-bit-rate digital subscriber line (VDSL) modems. ADSL and VDSL standards are used by telephone companies to provide high speed data service to residences and offices. In an ADSL receiver, an equalizer is required to compensate for the channel’s dispersion in the time domain and the channel’s distortion in the frequency domain of the transmitted waveform. This dissertation proposes design methods for linear equalizers to increase the bit rate of the connection. The methods are amenable to implementation on programmable fixed-point digital signal processors, which are employed in ADSL/VDSL transceivers. A conventional ADSL equalizer consists of a time-domain equalizer, a fast Fourier transform, and a frequency domain equalizer. The time domain equalizer (TEQ) is a finite impulse response filter that when coupled with a discretized channel produces an equivalent channel whose impulse response is shorter than that of the discretized channel. This channel shortening is required by the ADSL standards. In this dissertation, I first propose a linear phase TEQ design that exploits symmetry in existing eigen-filter approaches such as minimum mean square error(MMSE), maximum shortening signal to noise ratio (MSSNR) and minimum intersymbol interference (Min-ISI) equalizers. TEQs with symmetric coefficients can reach the same performance as non-symmetric ones with much lower training complexity. Second, I improve Min-ISI design. I reformulate the cost function to make long TEQs design feasible. I remove the dependency of transmission delay in order to reduce the complexity associated with delay optimization. The quantized weighting is introduced to further lower the complexity. I also propose an iterative optimization procedure of Min-ISI that completely avoids Cholesky decomposition hence is better suited for a fixed-point implementation. Finally I propose a dual-path TEQ structure, which designs a standard singleFIR TEQ to achieve good bit rate over the entire transmission bandwidth, and designs another FIR TEQ to improve the bit rate over a subset of subcarriers. Dualpath TEQ can be viewed as a special case of a complex valued filter bank structure that delivers the best bit rate of existing DMT equalizers. However, dual-path TEQ provides a very good tradeoff between achievable bit rate vs. implementation complexity on a programmable digital signal processor.Electrical and Computer Engineerin

A Near-Optimal Linear Crosstalk Canceler for VDSL

Crosstalk is the major source of performance degradation in VDSL. Several crosstalk cancelers have been proposed to address this. Unfortunately they suffer from error propagation, high complexity and long latency. In this paper we present a simple, linear zero forcing (ZF) crosstalk canceler. This design has a low complexity, no latency and does not suffer from error propagation. Furthermore, due to the well conditioned structure of the VDSL channel matrix, the ZF design causes negligible noise enhancement. A lower bound on the performance of the linear ZF canceler is derived. This allows performance to be predicted without explicit knowledge of the crosstalk channels, which simplies service provisioning considerably. This bound shows that the linear ZF canceler operates close to the single user bound. So the linear ZF canceler is a low complexity, low latency design with predictable, near-optimal performance. The combination of spectral optimization and crosstalk cancellation is also considered. Spectra optimization in a multi-access channel generally involves a highly complex optimization problem. Since the linear ZF canceler decouples transmission on each line, the spectrum on each modem can be optimized independently, leading to a signicant reduction in complexity.

Orthogonal transmultiplexers : extensions to digital subscriber line (DSL) communications

An orthogonal transmultiplexer which unifies multirate filter bank theory and communications theory is investigated in this dissertation. Various extensions of the orthogonal transmultiplexer techniques have been made for digital subscriber line communication applications. It is shown that the theoretical performance bounds of single carrier modulation based transceivers and multicarrier modulation based transceivers are the same under the same operational conditions. Single carrier based transceiver systems such as Quadrature Amplitude Modulation (QAM) and Carrierless Amplitude and Phase (CAP) modulation scheme, multicarrier based transceiver systems such as Orthogonal Frequency Division Multiplexing (OFDM) or Discrete Multi Tone (DMT) and Discrete Subband (Wavelet) Multicarrier based transceiver (DSBMT) techniques are considered in this investigation. The performance of DMT and DSBMT based transceiver systems for a narrow band interference and their robustness are also investigated. It is shown that the performance of a DMT based transceiver system is quite sensitive to the location and strength of a single tone (narrow band) interference. The performance sensitivity is highlighted in this work. It is shown that an adaptive interference exciser can alleviate the sensitivity problem of a DMT based system. The improved spectral properties of DSBMT technique reduces the performance sensitivity for variations of a narrow band interference. It is shown that DSBMT technique outperforms DMT and has a more robust performance than the latter. The superior performance robustness is shown in this work. Optimal orthogonal basis design using cosine modulated multirate filter bank is discussed. An adaptive linear combiner at the output of analysis filter bank is implemented to eliminate the intersymbol and interchannel interferences. It is shown that DSBMT is the most suitable technique for a narrow band interference environment. A blind channel identification and optimal MMSE based equalizer employing a nonmaximally decimated filter bank precoder / postequalizer structure is proposed. The performance of blind channel identification scheme is shown not to be sensitive to the characteristics of unknown channel. The performance of the proposed optimal MMSE based equalizer is shown to be superior to the zero-forcing equalizer

A Near-Optimal Linear Crosstalk Canceler for Upstream VDSL

Crosstalk is the major source of performance degradation in VDSL. Several crosstalk cancelers have been proposed to address this. Unfortunately, they suffer from error propagation, high complexity, and long latency. This paper presents a simple, linear zero-forcing (ZF) crosstalk canceler. This design has a low complexity and no latency and does not suffer from error propagation. Furthermore, due to the well-conditioned structure of the VDSL channel matrix, the ZF design causes negligible noise enhancement. A lower bound on the performance of the linear ZF canceler is derived. This allows performance to be predicted without explicit knowledge of the crosstalk channels, which simplifies service provisioning considerably. This bound shows that the linear ZF canceler operates close to the single-user bound. Therefore, the linear ZF canceler is a low-complexity, low-latency design with predictable near-optimal performance. The combination of spectral optimization and crosstalk cancellation is also considered. Spectra optimization in a multiaccess channel generally involves a complex optimization problem. Since the linear ZF canceler decouples transmission on each line, the spectrum on each modem can be optimized independently, leading to a significant reduction in complexity

A simple RLS-POCS solution for reduced complexity ADSL impulse shortening

Recently, with the realization of the World Wide Web, the tremendous need for high-speed data communications has grown. Several access techniques have been proposed which utilize the existing copper twisted pair cabling. Of these, the xDSL family, particularly ADSL and VDSL, have shown great promise in providing broadband or near-broadband access through the common telephone lines. A critical component of the ADSL and VDSL systems is the guard band needed to eliminate the interference caused by the previously transmitted blocks. This guard band must come in the form of redundant samples at the start of every transmit block, and be at least as long as the channel impulse response. Since the required guard band length is much greater than the length of the actual transmitted samples, techniques to shorten the channel impulse response must be considered. In this thesis, a new algorithm based on the RLS error minimization and POCS optimization techniques will be applied to the channel impulse-shortening problem in an ADSL environment. As will be shown, the proposed algorithm will provide a much better solution with a minimal increase in complexity as compared to the existing LMS techniques

Digital Signal Processing on FPGA for Short-Range Optical Communications Systems over Plastic Optical Fiber

Nowadays bandwidth requirements are increasing vertiginously. As new ways and concepts of how to share information emerge, new ways of how to access the web enter the market. Computers and mobile devices are only the beginning, the spectrum of web products and services such as IPTV, VoIP, on-line gaming, etc has been augmented by the possibility to share, store data, interact and work on the Cloud. The rush for bandwidth has led researchers from all over the world to enquire themselves on how to achieve higher data rates, and it is thanks to their efforts, that both long-haul and short-range communications systems have experienced a huge development during the last few years. However, as the demand for higher information throughput increases traditional short-range solutions reach their lim- its. As a result, optical solutions are now migrating from long-haul to short-range communication systems. As part of this trend, plastic optical fiber (POF) systems have arisen as promising candidates for applications where traditional glass optical fibers (GOF) are unsuitable. POF systems feature a series of characteristics that make them very suitable for the market requirements. More in detail, these systems are low cost, robust, easy to handle and to install, flexible and yet tolerant to bendings. Nonetheless, these features come at the expense of a considerable higher bandwidth limitation when compared to GOF systems. This thesis is aimed to the investigate the use of digital signal processing (DSP) algorithms to overcome the bandwidth limitation in short-range optical communications system based on POF. In particular, this dissertation presents the design and development of DSP algorithms on field programmable gate arrays (FPGAs) with the ultimate purpose of implementing a fully engineered 1Gbit/s Ethernet Media Converter capable of establishing data links over 50+ meters of PMMA-SI POF using an RC-LED as transmitte

A Multi-CAP Visible-Light Communications System With 4.85-b/s/Hz Spectral Efficiency

In this paper, we experimentally demonstrate a multiband carrierless amplitude and phase modulation format for the first time in VLC. We split a conventional carrierless amplitude and phase modulated signal into m subcarriers in order to protect from the attenuation experienced at high frequencies in low-pass VLC systems. We investigate the relationship between throughput/spectral efficiency and m, where m = {10, 8, 6, 4, 2, 1} subcarriers over a fixed total signal bandwidth of 6.5 MHz. We show that transmission speeds (spectral efficiencies) of 31.53 (4.85), 30.88 (4.75), 25.40 (3.90), 23.65 (3.60), 15.78 (2.40), and 9.04 (1.40) Mb/s (b/s/Hz) can be achieved for the listed values of m, respectively