406 research outputs found
Resource allocation for transmit hybrid beamforming in decoupled millimeter wave multiuser-MIMO downlink
This paper presents a study on joint radio resource allocation and hybrid precoding in multicarrier massive multiple-input multiple-output communications for 5G cellular networks. In this paper, we present the resource allocation algorithm to maximize the proportional fairness (PF) spectral efficiency under the per subchannel power and the beamforming rank constraints. Two heuristic algorithms are designed. The proportional fairness hybrid beamforming algorithm provides the transmit precoder with a proportional fair spectral efficiency among users for the desired number of radio-frequency (RF) chains. Then, we transform the number of RF chains or rank constrained optimization problem into convex semidefinite programming (SDP) problem, which can be solved by standard techniques. Inspired by the formulated convex SDP problem, a low-complexity, two-step, PF-relaxed optimization algorithm has been provided for the formulated convex optimization problem. Simulation results show that the proposed suboptimal solution to the relaxed optimization problem is near-optimal for the signal-to-noise ratio SNR <= 10 dB and has a performance gap not greater than 2.33 b/s/Hz within the SNR range 0-25 dB. It also outperforms the maximum throughput and PF-based hybrid beamforming schemes for sum spectral efficiency, individual spectral efficiency, and fairness index
Multicell MIMO Communications Relying on Intelligent Reflecting Surfaces
Intelligent reflecting surfaces (IRSs) constitute a disruptive wireless communication technique capable of creating a controllable propagation environment. In this paper, we propose to invoke an IRS at the cell boundary of multiple cells to assist the downlink transmission to cell-edge users, whilst mitigating the inter-cell interference, which is a crucial issue in multicell communication systems. We aim for maximizing the weighted sum rate (WSR) of all users through jointly optimizing the active precoding matrices at the base stations (BSs) and the phase shifts at the IRS subject to each BS’s power constraint and unit modulus constraint. Both the BSs and the users are equipped with multiple antennas, which enhances the spectral efficiency by exploiting the spatial multiplexing gain. Due to the nonconvexity of the problem, we first reformulate it into an equivalent one, which is solved by using the block coordinate descent (BCD) algorithm, where the precoding matrices and phase shifts are alternately optimized. The optimal precoding matrices can be obtained in closed form, when fixing the phase shifts. A pair of efficient algorithms are proposed for solving the phase shift optimization problem, namely the Majorization-Minimization (MM) Algorithm and the Complex Circle Manifold (CCM) Method. Both algorithms are guaranteed to converge to at least locally optimal solutions. We also extend the proposed algorithms to the more general multiple-IRS and network MIMO scenarios. Finally, our simulation results confirm the advantages of introducing IRSs in enhancing the cell-edge user performance
Waveforms for the Massive MIMO Downlink: Amplifier Efficiency, Distortion and Performance
In massive MIMO, most precoders result in downlink signals that suffer from
high PAR, independently of modulation order and whether single-carrier or OFDM
transmission is used. The high PAR lowers the power efficiency of the base
station amplifiers. To increase power efficiency, low-PAR precoders have been
proposed. In this article, we compare different transmission schemes for
massive MIMO in terms of the power consumed by the amplifiers. It is found that
(i) OFDM and single-carrier transmission have the same performance over a
hardened massive MIMO channel and (ii) when the higher amplifier power
efficiency of low-PAR precoding is taken into account, conventional and low-PAR
precoders lead to approximately the same power consumption. Since downlink
signals with low PAR allow for simpler and cheaper hardware, than signals with
high PAR, therefore, the results suggest that low-PAR precoding with either
single-carrier or OFDM transmission should be used in a massive MIMO base
station
Towards Dual-functional Radar-Communication Systems: Optimal Waveform Design
We focus on a dual-functional multi-input-multi-output (MIMO)
radar-communication (RadCom) system, where a single transmitter communicates
with downlink cellular users and detects radar targets simultaneously. Several
design criteria are considered for minimizing the downlink multi-user
interference. First, we consider both the omnidirectional and directional
beampattern design problems, where the closed-form globally optimal solutions
are obtained. Based on these waveforms, we further consider a weighted
optimization to enable a flexible trade-off between radar and communications
performance and introduce a low-complexity algorithm. The computational costs
of the above three designs are shown to be similar to the conventional
zero-forcing (ZF) precoding. Moreover, to address the more practical constant
modulus waveform design problem, we propose a branch-and-bound algorithm that
obtains a globally optimal solution and derive its worst-case complexity as a
function of the maximum iteration number. Finally, we assess the effectiveness
of the proposed waveform design approaches by numerical results.Comment: 13 pages, 10 figures. This work has been submitted to the IEEE for
possible publication. Copyright may be transferred without notice, after
which this version may no longer be accessibl
Interference Exploitation via Symbol-Level Precoding: Overview, State-of-the-Art and Future Directions
Interference is traditionally viewed as a performance limiting factor in wireless communication systems, which is to be minimized or mitigated. Nevertheless, a recent line of work has shown that by manipulating the interfering signals such that they add up constructively at the receiver side, known interference can be made beneficial and further improve the system performance in a variety of wireless scenarios, achieved by symbol-level precoding (SLP). This paper aims to provide a tutorial on interference exploitation techniques from the perspective of precoding design in a multi-antenna wireless communication system, by beginning with the classification of constructive interference (CI) and destructive interference (DI). The definition for CI is presented and the corresponding mathematical characterization is formulated for popular modulation types, based on which optimization-based precoding techniques are discussed. In addition, the extension of CI precoding to other application scenarios as well as for hardware efficiency is also described. Proof-of-concept testbeds are demonstrated for the potential practical implementation of CI precoding, and finally a list of open problems and practical challenges are presented to inspire and motivate further research directions in this area
- …