High temporal resolution refractivity retrieval from radar phase measurements

Knowledge of the spatial and temporal variability of near-surface water vapor is of great importance to successfully model reliable radio communications systems and forecast atmospheric phenomena such as convective initiation and boundary layer processes. However, most current methods to measure atmospheric moisture variations hardly provide the temporal and spatial resolutions required for detection of such atmospheric processes. Recently, considering the high correlation between refractivity variations and water vapor pressure variations at warm temperatures, and the good temporal and spatial resolution that weather radars provide, the measurement of the refractivity with radar became of interest. Firstly, it was proposed to estimate refractivity variations from radar phase measurements of ground-based stationary targets returns. For that, it was considered that the backscattering from ground targets is stationary and the vertical gradient of the refractivity could be neglected. Initial experiments showed good results over flat terrain when the radar and target heights are similar. However, the need to consider the non-zero vertical gradient of the refractivity over hilly terrain is clear. Up to date, the methods proposed consider previous estimation of the refractivity gradient in order to correct the measured phases before the refractivity estimation. In this paper, joint estimation of the refractivity variations at the radar height and the refractivity vertical gradient variations using scan-to-scan phase measurement variations is proposed. To reduce the noisiness of the estimates, a least squares method is used. Importantly, to apply this algorithm, it is not necessary to modify the radar scanning mode. For the purpose of this study, radar data obtained during the Refractivity Experiment for H2O Research and Collaborative Operational Technology Transfer (REFRACTT_2006), held in northeastern Colorado (USA), are used. The refractivity estimates obtained show a good performance of the algorithm proposed compared to the refractivity derived from two automatic weather stations located close to the radar, demonstrating the possibility of radar based refractivity estimation in hilly terrain and non-homogeneous atmosphere with high spatial resolution.Ministerio de Economía y Competitividad | Ref. TEC2014-55735-C3-3-RXunta de Galicia | Ref. GRC2015/01

Applications in Low-Power Phased Array Weather Radars

Low-cost X-band radars are an emerging technology that offer significant advantages over traditional systems for weather remote sensing applications. X-band radars provide enhanced angular resolution at a fraction of the aperture size compared to larger, lower frequency systems. Because of their low cost and small form factor, these radars can now be integrated into more research and commercial applications. This work presents research and development activities using a low-cost, X-band (9410 MHz) Phase-Tilt Radar. The phase-tilt design is a novel phased array architecture that allows for rapid electronic scanning in azimuth and mechanical tilting in elevation, as a compromise between cost and performance. This work focuses on field studies and experiments in three meteorological applications. The first stage of research focuses on the real-world application of phased array radars in forest fire monitoring and observation. From April to May 2013, a phase-tilt radar was deployed to South Australia and underwent a field campaign to make polarimetric observations of prescribed burns within and around the Adelaide Hills region. Measurements show the real-time evolution of the smoke plume dynamics at a spatial and temporal resolution that has never before been observed with an X-band radar. This dissertation will perform data analysis on results from this field campaign. Results are compared against existing work, theories, and approaches. In the second stage of research, field experiments are performed to assess the data quality of X-band phased array radars. Specifically, this research focuses on the measurement of and techniques to improve the variance of weather product estimators for dual-polarized systems. Variability in the radar products is a complicated relationship between the radar system specifications, scanning strategy, and the physics governing precipitation. Here, the variance of the radar product estimators is measured using standard radar scanning strategies employed in traditional mechanical antenna systems. Results are compared against adaptive scan strategies such as beam multiplexing and frequency diversity. This work investigates the improvement that complex scanning strategies offer in dual-polarized, X-band phased array radar systems. In the third stage of research, simulations and field experiments are conducted to investigate the performance benefits of adaptive scanning to optimize the data quality of radar returns. This research focuses on the development and implementation of a waveform agile and adaptive scanning strategy to improve the quality of weather product estimators. Active phased array radars allow radar systems to quickly vary both scan pointing angles and waveform parameters in response to real-time observations of the atmosphere. As an evolution of the previous research effort, this work develops techniques to adaptively change the scan pointing angles, transmit and matched filter waveform parameters to achieve a desired level of data quality. Strategies and techniques are developed to minimize the error between observed and desired data quality measures. Simulation and field experiments are performed to assess the quality of the developed strategies