6,621 research outputs found
Preliminary error budget for an optical ranging system: Range, range rate, and differenced range observables
Future missions to the outer solar system or human exploration of Mars may use telemetry systems based on optical rather than radio transmitters. Pulsed laser transmission can be used to deliver telemetry rates of about 100 kbits/sec with an efficiency of several bits for each detected photon. Navigational observables that can be derived from timing pulsed laser signals are discussed. Error budgets are presented based on nominal ground stations and spacecraft-transceiver designs. Assuming a pulsed optical uplink signal, two-way range accuracy may approach the few centimeter level imposed by the troposphere uncertainty. Angular information can be achieved from differenced one-way range using two ground stations with the accuracy limited by the length of the available baseline and by clock synchronization and troposphere errors. A method of synchronizing the ground station clocks using optical ranging measurements is presented. This could allow differenced range accuracy to reach the few centimeter troposphere limit
Constellation Shaping for WDM systems using 256QAM/1024QAM with Probabilistic Optimization
In this paper, probabilistic shaping is numerically and experimentally
investigated for increasing the transmission reach of wavelength division
multiplexed (WDM) optical communication system employing quadrature amplitude
modulation (QAM). An optimized probability mass function (PMF) of the QAM
symbols is first found from a modified Blahut-Arimoto algorithm for the optical
channel. A turbo coded bit interleaved coded modulation system is then applied,
which relies on many-to-one labeling to achieve the desired PMF, thereby
achieving shaping gain. Pilot symbols at rate at most 2% are used for
synchronization and equalization, making it possible to receive input
constellations as large as 1024QAM. The system is evaluated experimentally on a
10 GBaud, 5 channels WDM setup. The maximum system reach is increased w.r.t.
standard 1024QAM by 20% at input data rate of 4.65 bits/symbol and up to 75% at
5.46 bits/symbol. It is shown that rate adaptation does not require changing of
the modulation format. The performance of the proposed 1024QAM shaped system is
validated on all 5 channels of the WDM signal for selected distances and rates.
Finally, it was shown via EXIT charts and BER analysis that iterative
demapping, while generally beneficial to the system, is not a requirement for
achieving the shaping gain.Comment: 10 pages, 12 figures, Journal of Lightwave Technology, 201
Apparatus to control and visualize the impact of a high-energy laser pulse on a liquid target
We present an experimental apparatus to control and visualize the response of
a liquid target to a laser-induced vaporization. We use a millimeter-sized drop
as target and present two liquid-dye solutions that allow a variation of the
absorption coefficient of the laser light in the drop by seven orders of
magnitude. The excitation source is a Q-switched Nd:YAG laser at its
frequency-doubled wavelength emitting nanosecond pulses with energy densities
above the local vaporization threshold. The absorption of the laser energy
leads to a large-scale liquid motion at timescales that are separated by
several orders of magnitude, which we spatiotemporally resolve by a combination
of ultra-high-speed and stroboscopic high-resolution imaging in two orthogonal
views. Surprisingly, the large-scale liquid motion at upon laser impact is
completely controlled by the spatial energy distribution obtained by a precise
beam-shaping technique. The apparatus demonstrates the potential for accurate
and quantitative studies of laser-matter interactions.Comment: Submitted to Review of Scientific Instrument
Optical Time-Frequency Packing: Principles, Design, Implementation, and Experimental Demonstration
Time-frequency packing (TFP) transmission provides the highest achievable
spectral efficiency with a constrained symbol alphabet and detector complexity.
In this work, the application of the TFP technique to fiber-optic systems is
investigated and experimentally demonstrated. The main theoretical aspects,
design guidelines, and implementation issues are discussed, focusing on those
aspects which are peculiar to TFP systems. In particular, adaptive compensation
of propagation impairments, matched filtering, and maximum a posteriori
probability detection are obtained by a combination of a butterfly equalizer
and four 8-state parallel Bahl-Cocke-Jelinek-Raviv (BCJR) detectors. A novel
algorithm that ensures adaptive equalization, channel estimation, and a proper
distribution of tasks between the equalizer and BCJR detectors is proposed. A
set of irregular low-density parity-check codes with different rates is
designed to operate at low error rates and approach the spectral efficiency
limit achievable by TFP at different signal-to-noise ratios. An experimental
demonstration of the designed system is finally provided with five
dual-polarization QPSK-modulated optical carriers, densely packed in a 100 GHz
bandwidth, employing a recirculating loop to test the performance of the system
at different transmission distances.Comment: This paper has been accepted for publication in the IEEE/OSA Journal
of Lightwave Technolog
Probabilistic Eigenvalue Shaping for Nonlinear Fourier Transform Transmission
We consider a nonlinear Fourier transform (NFT)-based transmission scheme,
where data is embedded into the imaginary part of the nonlinear discrete
spectrum. Inspired by probabilistic amplitude shaping, we propose a
probabilistic eigenvalue shaping (PES) scheme as a means to increase the data
rate of the system. We exploit the fact that for an NFT-based transmission
scheme the pulses in the time domain are of unequal duration by transmitting
them with a dynamic symbol interval and find a capacity-achieving distribution.
The PES scheme shapes the information symbols according to the
capacity-achieving distribution and transmits them together with the parity
symbols at the output of a low-density parity-check encoder, suitably
modulated, via time-sharing. We furthermore derive an achievable rate for the
proposed PES scheme. We verify our results with simulations of the
discrete-time model as well as with split-step Fourier simulations.Comment: Published in IEEE/OSA Journal of Lightwave Technology, 201
Space Station communications and tracking systems modeling and RF link simulation
In this final report, the effort spent on Space Station Communications and Tracking System Modeling and RF Link Simulation is described in detail. The effort is mainly divided into three parts: frequency division multiple access (FDMA) system simulation modeling and software implementation; a study on design and evaluation of a functional computerized RF link simulation/analysis system for Space Station; and a study on design and evaluation of simulation system architecture. This report documents the results of these studies. In addition, a separate User's Manual on Space Communications Simulation System (SCSS) (Version 1) documents the software developed for the Space Station FDMA communications system simulation. The final report, SCSS user's manual, and the software located in the NASA JSC system analysis division's VAX 750 computer together serve as the deliverables from LinCom for this project effort
- …