Double Resonant High-Frequency Converters for Wireless Power Transfer

This thesis describes novel techniques and developments in the design and implementation of a low power radio frequency (40kHz to 1MHz) wireless power transfer (WPT) system, with an application in the wireless charging of autonomous drones without physical connection to its on-board Battery Management System (BMS). The WPT system is developed around a matrix converter exploiting the benefits such as a small footprint (DC-link free), high efficiency and high power density. The overall WPT system topology discussed in this thesis is based on the current state-of-the-art found in literature, but enhancements are made through novel methods to further improve the converter’s stability, reduce control complexity and improve the wireless power efficiency. In this work, each part of the system is analysed and novel techniques are proposed to achieve improvements. The WPT system design methodology presented in this thesis commences with the use of a conventional full-bridge converter. For cost-efficiency and to improve the converters stability, a novel gate drive circuit is presented which provides self-generated negative bias such that a bipolar MOSFET drive can be driven without an additional voltage source or magnetic component. The switching control sequences for both a full-bridge and single phase to single phase matrix converter are analysed which show that the switching of a matrix converter can be considered to be the same as a full-bridge converter under certain conditions. A middleware is then presented that reduces the complexity of the control required for a matrix converter and enables control by a conventional full-bridge controller (i.e. linear controller or microcontroller). A novel technique that can maximise and maintain in real-time the WPT efficiency is presented using a maximum efficiency point tracking approach. A detailed study of potential issues that may affect the implementation of this novel approach are presented and new solutions are proposed. A novel wireless pseudo-synchronous sampling method is presented and implemented on a prototype system to realise the maximum efficiency point tracking approach. Finally, a new hybrid wireless phase-locked loop is presented and implemented to minimise the bandwidth requirements of the maximum efficiency point tracking approach. The performance and methods for implementation of the novel concepts introduced in this thesis are demonstrated through a number of prototypes that were built. These include a matrix converter and two full WPT systems with operating frequencies ranging from sub-megahertz to megahertz level. Moreover, the final prototype is applied to the charging of a quadcopter battery pack to successfully charge the pack wirelessly whilst actively balancing the cells. Hence, fast battery charging and cell balancing, which conventionally requires battery removal, can be achieved without re-balance the weight of the UAV

Coulomb Blockade and Digital Single-Electron Devices

Tunneling of single electrons has been thoroughly studied both theoretically and experimentally during last ten years. By the present time the basic physics is well understood, and creation of useful single-electron devices becomes the important issue. Single-electron tunneling seems to be the most promising candidate to be used in the future integrated digital circuits with the typical size scale of few nanometers and below, i.e. in the molecular electronics. In the review we first briefly discuss the physics of single-electron tunneling and the operation of the single-electron transistor. After that, we concentrate on the hypothetical ultradense digital single-electron circuits and discuss the different proposed families of them. The last part of the review considers the issues of the discrete energy spectrum and the finite tunnel barrier height which are important for the molecular-size single-electron devices.Comment: Review paper, to be published in "Molecular Electronics", ed. by J. Jortner and M. A. Ratner (Blackwell, Oxford). 49 pages, RevTex, 15 figure

High Performance Optical Transmitter Ffr Next Generation Supercomputing and Data Communication

High speed optical interconnects consuming low power at affordable prices are always a major area of research focus. For the backbone network infrastructure, the need for more bandwidth driven by streaming video and other data intensive applications such as cloud computing has been steadily pushing the link speed to the 40Gb/s and 100Gb/s domain. However, high power consumption, low link density and high cost seriously prevent traditional optical transceiver from being the next generation of optical link technology. For short reach communications, such as interconnects in supercomputers, the issues related to the existing electrical links become a major bottleneck for the next generation of High Performance Computing (HPC). Both applications are seeking for an innovative solution of optical links to tackle those current issues. In order to target the next generation of supercomputers and data communication, we propose to develop a high performance optical transmitter by utilizing CISCO Systems®\u27s proprietary CMOS photonic technology. The research seeks to achieve the following outcomes: 1. Reduction of power consumption due to optical interconnects to less than 5pJ/bit without the need for Ring Resonators or DWDM and less than 300fJ/bit for short distance data bus applications. 2. Enable the increase in performance (computing speed) from Peta-Flop to Exa-Flops without the proportional increase in cost or power consumption that would be prohibitive to next generation system architectures by means of increasing the maximum data transmission rate over a single fiber. 3. Explore advanced modulation schemes such as PAM-16 (Pulse-Amplitude-Modulation with 16 levels) to increase the spectrum efficiency while keeping the same or less power figure. This research will focus on the improvement of both the electrical IC and optical IC for the optical transmitter. An accurate circuit model of the optical device is created to speed up the performance optimization and enable co-simulation of electrical driver. Circuit architectures are chosen to minimize the power consumption without sacrificing the speed and noise immunity. As a result, a silicon photonic based optical transmitter employing 1V supply, featuring 20Gb/s data rate is fabricated. The system consists of an electrical driver in 40nm CMOS and an optical MZI modulator with an RF length of less than 0.5mm in 0.13&mu m SOI CMOS. Two modulation schemes are successfully demonstrated: On-Off Keying (OOK) and Pulse-Amplitude-Modulation-N (PAM-N N=4, 16). Both versions demonstrate signal integrity, interface density, and scalability that fit into the next generation data communication and exa-scale computing. Modulation power at 20Gb/s data rate for OOK and PAM-16 of 4pJ/bit and 0.25pJ/bit are achieved for the first time of an MZI type optical modulator, respectively

Imaging Probe for Charged Particle Detection

Single Photon Avalanche Diodes (SPADs) are semiconductor devices that detect individual photons. However, they can also experience dark count rate (DCR), generating avalanche current even when no photons are present, which limits their ability to detect low-level signals. SPADs characterization is important to gain insight into their behavior and improve their performance for various applications. This thesis discusses the development of a portable detection probe that uses the APIX2LF chip, which contains arrays of SPADs that were produced using a 150 nm standard CMOS process. A prototype board, that includes a battery, front-end electronics, and a microcontroller acting as the interface between the sensor and the PC was developed and tested using a beta-emitting source. Additionally, custom firmware was designed for the microcontroller and an automatic data acquisition framework was developed for the characterization of the DCR of six APIX2LF chips at different bias voltages and temperatures.This thesis discusses the development of a portable detection probe that uses the APIX2LF chip, which contains arrays of SPADs that were produced using a 150 nm standard CMOS process. A prototype board, that includes a battery, front-end electronics, and a microcontroller acting as the interface between the sensor and the PC was developed and tested using a beta-emitting source. Additionally, custom firmware was designed for the microcontroller and an automatic data acquisition framework was developed for the characterization of the DCR of six APIX2LF chips at different bias voltages and temperatures

Single-Photon Avalanche Diodes in CMOS Technologies for Optical Communications

As optical communications may soon supplement Wi-Fi technologies, a concept known as visible light communications (VLC), low-cost receivers must provide extreme sensitivity to alleviate attenuation factors and overall power usage within communications link budgets. We present circuits with an advantage over conventional optical receivers, in that gain can be applied within the photodiode thus reducing the need for amplification circuits. To achieve this, single-photon avalanche diodes (SPADs) can be implemented in complementary metal-oxide-semiconductor (CMOS) technologies and have already been investigated in several topologies for VLC. The digital nature of SPADs removes the design effort used for low-noise, high-gain but high-bandwidth analogue circuits. We therefore present one of these circuit topologies, along with some common design and performance metrics. SPAD receivers are however not yet mature prompting research to take low-level parameters up to the communications level

The Conference on High Temperature Electronics

The status of and directions for high temperature electronics research and development were evaluated. Major objectives were to (1) identify common user needs; (2) put into perspective the directions for future work; and (3) address the problem of bringing to practical fruition the results of these efforts. More than half of the presentations dealt with materials and devices, rather than circuits and systems. Conference session titles and an example of a paper presented in each session are (1) User requirements: High temperature electronics applications in space explorations; (2) Devices: Passive components for high temperature operation; (3) Circuits and systems: Process characteristics and design methods for a 300 degree QUAD or AMP; and (4) Packaging: Presently available energy supply for high temperature environment

POWER DISTRIBUTION ANALYSIS IN COMPLEX SYSTEMS

Electronic systems are continuously growing nowadays in every ambit and application; concepts like mobile systems, domotic, wireless monitoring are becoming very common, and the reason is the continuous reduction of the energy and time needed to collect, process and send information and data to the end user. The energy management complexity of these systems is increasing in parallel both in terms of efficiency and reliability, in order to increase the lifetime of the application and try to make it energy-autonomous, thus also the power management should not be seen only as an efficient energy conversion stage, but as a complex system which can now manage different energy sources, and ensure an uninterrupted power supply to the application. The problems that must be overcome increase as the number of scenarios where the end applications have to be used: this thesis aims to present some complex power distribution systems and provide a detailed analysis of the strategies necessary to make the solution reliable and efficient

Towards phase-coherent caloritronics in superconducting circuits

The emerging field of phase-coherent caloritronics (from the Latin word "calor", i.e., heat) is based on the possibility to control heat currents using the phase difference of the superconducting order parameter. The goal is to design and implement thermal devices able to master energy transfer with a degree of accuracy approaching the one reached for charge transport by contemporary electronic components. This can be obtained by exploiting the macroscopic quantum coherence intrinsic to superconducting condensates, which manifests itself through the Josephson and the proximity effect. Here, we review recent experimental results obtained in the realization of heat interferometers and thermal rectifiers, and discuss a few proposals for exotic non-linear phase-coherent caloritronic devices, such as thermal transistors, solid-state memories, phase-coherent heat splitters, microwave refrigerators, thermal engines and heat valves. Besides being very attractive from the fundamental physics point of view, these systems are expected to have a vast impact on many cryogenic microcircuits requiring energy management, and possibly lay the first stone for the foundation of electronic thermal logic.Comment: 11 pages, 6 colour figure

R&D Paths of Pixel Detectors for Vertex Tracking and Radiation Imaging

This report reviews current trends in the R&D of semiconductor pixellated sensors for vertex tracking and radiation imaging. It identifies requirements of future HEP experiments at colliders, needed technological breakthroughs and highlights the relation to radiation detection and imaging applications in other fields of science.Comment: 17 pages, 2 figures, submitted to the European Strategy Preparatory Grou