Physical Layer Performance Evaluation of LTE-Advanced Pro Broadcast and ATSC 3.0 Systems

This work provides a detailed performance analysis of the physical layer of two state-of-the-art point-to-multipoint (PTM) technologies: evolved Multimedia Broadcast Multicast Services (eMBMS) and Advanced Television Systems Committee - Third Generation (ATSC 3.0). The performance of these technologies is evaluated and compared using link-level simulations, considering relevant identified scenarios. A selection of Key Performance Indicators (KPI) for the International Mobile Telecommunications 2020 (IMT-2020) evaluation process has been considered. Representative use cases are also aligned to the test environments as defined in the IMT-2020 evaluation guidelines. It is observed that ATSC 3.0 outperforms both eMBMS solutions, i.e. MBMS over Single Frequency Networks (MBSFN) and Single-Cell PTM (SC-PTM) in terms of spectral efficiency, peak data rate and mobility, among others. This performance evaluation serves as a benchmark for comparison with a potential 5G PTM solution

Pioneering Studies on LTE eMBMS: Towards 5G Point-to-Multipoint Transmissions

The first 5G (5th generation wireless systems) New Radio Release-15 was recently completed. However, the specification only considers the use of unicast technologies and the extension to point-to-multipoint (PTM) scenarios is not yet considered. To this end, we first present in this work a technical overview of the state-of-the-art LTE (Long Term Evolution) PTM technology, i.e., eMBMS (evolved Multimedia Broadcast Multicast Services), and investigate the physical layer performance via link-level simulations. Then based on the simulation analysis, we discuss potential improvements for the two current eMBMS solutions, i.e., MBSFN (MBMS over Single Frequency Networks) and SC-PTM (Single-Cell PTM). This work explicitly focus on equipping the current eMBMS solutions with 5G candidate techniques, e.g., multiple antennas and millimeter wave, and its potentials to meet the requirements of next generation PTM transmissions.Comment: SAM 2018, 5 pages, 4 fig

Turbo Packet Combining for Broadband Space-Time BICM Hybrid-ARQ Systems with Co-Channel Interference

In this paper, efficient turbo packet combining for single carrier (SC) broadband multiple-input--multiple-output (MIMO) hybrid--automatic repeat request (ARQ) transmission with unknown co-channel interference (CCI) is studied. We propose a new frequency domain soft minimum mean square error (MMSE)-based signal level combining technique where received signals and channel frequency responses (CFR)s corresponding to all retransmissions are used to decode the data packet. We provide a recursive implementation algorithm for the introduced scheme, and show that both its computational complexity and memory requirements are quite insensitive to the ARQ delay, i.e., maximum number of ARQ rounds. Furthermore, we analyze the asymptotic performance, and show that under a sum-rank condition on the CCI MIMO ARQ channel, the proposed packet combining scheme is not interference-limited. Simulation results are provided to demonstrate the gains offered by the proposed technique.Comment: 12 pages, 7 figures, and 2 table

Doppler compensation algorithms for DSP-based implementation of OFDM underwater acoustic communication systems

In recent years, orthogonal frequency division multiplexing (OFDM) has gained considerable attention in the development of underwater communication (UWC) systems for civilian and military applications. However, the wideband nature of the communication links necessitate robust algorithms to combat the consequences of severe channel conditions such as frequency selectivity, ambient noise, severe multipath and Doppler Effect due to velocity change between the transmitter and receiver. This velocity perturbation comprises two scenarios; the first induces constant time scale expansion/compression or zero acceleration during the transmitted packet time, and the second is time varying Doppler-shift. The latter is an increasingly important area in autonomous underwater vehicle (AUV) applications. The aim of this thesis is to design a low complexity OFDM-based receiver structure for underwater communication that tackles the inherent Doppler effect and is applicable for developing real-time systems on a digital signal processor (DSP). The proposed structure presents a paradigm in modem design from previous generations of single carrier receivers employing computationally expensive equalizers. The thesis demonstrates the issues related to designing a practical OFDM system, such as channel coding and peak-to-average power ratio (PAPR). In channel coding, the proposed algorithms employ convolutional bit-interleaved coded modulation with iterative decoding (BICM-ID) to obtain a higher degree of protection against power fading caused by the channel. A novel receiver structure that combines an adaptive Doppler-shift correction and BICM-ID for multi-carrier systems is presented. In addition, the selective mapping (SLM) technique has been utilized for PAPR. Due to their time varying and frequency selective channel nature, the proposed systems are investigated via both laboratory simulations and experiments conducted in the North Sea off the UK’s North East coast. The results of the study show that the proposed systems outperform block-based Doppler-shift compensation and are capable of tracking the Doppler-shift at acceleration up to 1m /s2.EThOS - Electronic Theses Online ServiceIraqi Government's Ministry of Higher Education and Scientific ResearchGBUnited Kingdo

Enhanced Air-Interfaces for Fifth Generation Mobile Broadband Communication

In broadband wireless multicarrier communication systems, intersymbol interference (ISI) and intercarrier interference (ICI) should be reduced. In orthogonal frequency division multiplexing (OFDM), the cyclic prefix (CP) guarantees to reduce the ISI interference. However, the CP reduces spectral and power efficiency. In this thesis, iterative interference cancellation (IIC) with iterative decoding is used to reduce ISI and ICI from the received signal in multicarrier modulation (MCM) systems. Alternative schemes as well as OFDM with insufficient CP are considered; filter bank multicarrier (FBMC/Offset QAM) and discrete wavelet transform based multicarrier modulation (DWT-MCM). IIC is applied in these different schemes. The required components are calculated from either the hard decision of the demapper output or the estimated decoded signal. These components are used to improve the received signal. Channel estimation and data detection are very important parts of the receiver design of the wireless communication systems. Iterative channel estimation using Wiener filter channel estimation with known pilots and IIC is used to estimate and improve data detection. Scattered and interference approximation method (IAM) preamble pilot are using to calculate the estimated values of the channel coefficients. The estimated soft decoded symbols with pilot are used to reduce the ICI and ISI and improve the channel estimation. The combination of Multi-Input Multi-Output MIMO and OFDM enhances the air-interface for the wireless communication system. In a MIMO-MCM scheme, IIC and MIMO-IIC-based successive interference cancellation (SIC) are proposed to reduce the ICI/ISI and cross interference to a given antenna from the signal transmitted from the target and the other antenna respectively. The number of iterations required can be calculated by analysing the convergence of the IIC with the help of EXtrinsic Information Transfer (EXIT) charts. A new EXIT approach is proposed to provide a means to define performance for a given outage probability on quasi-static channels

Self-concatenated coding for wireless communication systems

In this thesis, we have explored self-concatenated coding schemes that are designed for transmission over Additive White Gaussian Noise (AWGN) and uncorrelated Rayleigh fading channels. We designed both the symbol-based Self-ConcatenatedCodes considered using Trellis Coded Modulation (SECTCM) and bit-based Self- Concatenated Convolutional Codes (SECCC) using a Recursive Systematic Convolutional (RSC) encoder as constituent codes, respectively. The design of these codes was carried out with the aid of Extrinsic Information Transfer (EXIT) charts. The EXIT chart based design has been found an efficient tool in finding the decoding convergence threshold of the constituent codes. Additionally, in order to recover the information loss imposed by employing binary rather than non-binary schemes, a soft decision demapper was introduced in order to exchange extrinsic information withthe SECCC decoder. To analyse this information exchange 3D-EXIT chart analysis was invoked for visualizing the extrinsic information exchange between the proposed Iteratively Decoding aided SECCC and soft-decision demapper (SECCC-ID). Some of the proposed SECTCM, SECCC and SECCC-ID schemes perform within about 1 dB from the AWGN and Rayleigh fading channels’ capacity. A union bound analysis of SECCC codes was carried out to find the corresponding Bit Error Ratio (BER) floors. The union bound of SECCCs was derived for communications over both AWGN and uncorrelated Rayleigh fading channels, based on a novel interleaver concept.Application of SECCCs in both UltraWideBand (UWB) and state-of-the-art video-telephone schemes demonstrated its practical benefits.In order to further exploit the benefits of the low complexity design offered by SECCCs we explored their application in a distributed coding scheme designed for cooperative communications, where iterative detection is employed by exchanging extrinsic information between the decoders of SECCC and RSC at the destination. In the first transmission period of cooperation, the relay receives the potentially erroneous data and attempts to recover the information. The recovered information is then re-encoded at the relay using an RSC encoder. In the second transmission period this information is then retransmitted to the destination. The resultant symbols transmitted from the source and relay nodes can be viewed as the coded symbols of a three-component parallel-concatenated encoder. At the destination a Distributed Binary Self-Concatenated Coding scheme using Iterative Decoding (DSECCC-ID) was employed, where the two decoders (SECCC and RSC) exchange their extrinsic information. It was shown that the DSECCC-ID is a low-complexity scheme, yet capable of approaching the Discrete-input Continuous-output Memoryless Channels’s (DCMC) capacity.Finally, we considered coding schemes designed for two nodes communicating with each other with the aid of a relay node, where the relay receives information from the two nodes in the first transmission period. At the relay node we combine a powerful Superposition Coding (SPC) scheme with SECCC. It is assumed that decoding errors may be encountered at the relay node. The relay node then broadcasts this information in the second transmission period after re-encoding it, again, using a SECCC encoder. At the destination, the amalgamated block of Successive Interference Cancellation (SIC) scheme combined with SECCC then detects and decodes the signal either with or without the aid of a priori information. Our simulation results demonstrate that the proposed scheme is capable of reliably operating at a low BER for transmission over both AWGN and uncorrelated Rayleigh fading channels. We compare the proposed scheme’s performance to a direct transmission link between the two sources having the same throughput