Recovering Multiplexing Loss Through Successive Relaying Using Repetition Coding

In this paper, a transmission protocol is studied for a two relay wireless network in which simple repetition coding is applied at the relays. Information-theoretic achievable rates for this transmission scheme are given, and a space-time V-BLAST signalling and detection method that can approach them is developed. It is shown through the diversity multiplexing tradeoff analysis that this transmission scheme can recover the multiplexing loss of the half-duplex relay network, while retaining some diversity gain. This scheme is also compared with conventional transmission protocols that exploit only the diversity of the network at the cost of a multiplexing loss. It is shown that the new transmission protocol offers significant performance advantages over conventional protocols, especially when the interference between the two relays is sufficiently strong.Comment: To appear in the IEEE Transactions on Wireless Communication

Performance Evaluation of ML-VBLAST MIMO System using various antenna configurations with Ricean and Rayleigh Channel

Wireless communication technology has shown that the application of multiple antennas at both transmitter and receiver sides improve the possibility of high data rates through multiplexing or to improve performance through diversity compared to single antenna systems. In this article, we studied the BER performance of Maximum Likelihood (ML)- Vertical Bells Lab Layered Space Time Architecture (V-BLAST) Spatial Multiplexing Technique with using different modulation techniques such as BPSK and QPSK, in independent, identically distributed (i.i.d) flat fading channel like Rayleigh and Ricean Channel. In this article we will compared a different multiple antenna configuration with BPSK and QPSK modulation techniques in different channel and finally we will concluded that ML-VBLAST decoding technique using BPSK modulation scheme gives better result than QPSK modulation technique in both the channels. In this we got more optimal result for 1× 4 antennas for V-BLAST system in rician fading channel and for Rayleigh channel 4 X 4 antennas for ML-V-BLAST system. Finally we compare the Rayleigh and Ricean Channel for 2 X 2 antenna configurations and in this we found Ricean Channel have better results than Rayleigh Channel in ML-VBLAST MIMO System. Keywords: Binary Phase Shift Key (BPSK), Bit Error Rate (BER), Multiple input multiple output (MIMO), Maximum Likelihood (ML), Vertical Bell Laboratories Layered Space-Time (V-BLAST

Design and Implementation of Efficient Algorithms for Wireless MIMO Communication Systems

En la última década, uno de los avances tecnológicos más importantes que han hecho culminar la nueva generación de banda ancha inalámbrica es la comunicación mediante sistemas de múltiples entradas y múltiples salidas (MIMO). Las tecnologías MIMO han sido adoptadas por muchos estándares inalámbricos tales como LTE, WiMAS y WLAN. Esto se debe principalmente a su capacidad de aumentar la máxima velocidad de transmisión , junto con la fiabilidad alcanzada y la cobertura de las comunicaciones inalámbricas actuales sin la necesidad de ancho de banda extra ni de potencia de transmisión adicional. Sin embargo, las ventajas proporcionadas por los sistemas MIMO se producen a expensas de un aumento sustancial del coste de implementación de múltiples antenas y de la complejidad del receptor, la cual tiene un gran impacto sobre el consumo de energía. Por esta razón, el diseño de receptores de baja complejidad es un tema importante que se abordará a lo largo de esta tesis. En primer lugar, se investiga el uso de técnicas de preprocesado de la matriz de canal MIMO bien para disminuir el coste computacional de decodificadores óptimos o bien para mejorar las prestaciones de detectores subóptimos lineales, SIC o de búsqueda en árbol. Se presenta una descripción detallada de dos técnicas de preprocesado ampliamente utilizadas: el método de Lenstra, Lenstra, Lovasz (LLL) para lattice reduction (LR) y el algorimo VBLAST ZF-DFE. Tanto la complejidad como las prestaciones de ambos métodos se han evaluado y comparado entre sí. Además, se propone una implementación de bajo coste del algoritmo VBLAST ZF-DFE, la cual se incluye en la evaluación. En segundo lugar, se ha desarrollado un detector MIMO basado en búsqueda en árbol de baja complejidad, denominado detector K-Best de amplitud variable (VB K-Best). La idea principal de este método es aprovechar el impacto del número de condición de la matriz de canal sobre la detección de datos con el fin de disminuir la complejidad de los sistemasRoger Varea, S. (2012). Design and Implementation of Efficient Algorithms for Wireless MIMO Communication Systems [Tesis doctoral no publicada]. Universitat Politècnica de València. https://doi.org/10.4995/Thesis/10251/16562Palanci

Noncooperative and Cooperative Transmission Schemes with Precoding and Beamforming

The next generation mobile networks are expected to provide multimedia applications with a high quality of service. On the other hand, interference among multiple base stations (BS) that co-exist in the same location limits the capacity of wireless networks. In conventional wireless networks, the base stations do not cooperate with each other. The BSs transmit individually to their respective mobile stations (MS) and treat the transmission from other BSs as interference. An alternative to this structure is a network cooperation structure. Here, BSs cooperate with other BSs to simultaneously transmit to their respective MSs using the same frequency band at a given time slot. By doing this, we significantly increase the capacity of the networks. This thesis presents novel research results on a noncooperative transmission scheme and a cooperative transmission scheme for multi-user multiple-input-multiple-output orthogonal frequency division multiplexing (MIMO-OFDM). We first consider the performance limit of a noncooperative transmission scheme. Here, we propose a method to reduce the interference and increase the throughput of orthogonal frequency division multiplexing (OFDM) systems in co-working wireless local area networks (WLANs) by using joint adaptive multiple antennas(AMA) and adaptive modulation (AM) with acknowledgement (ACK) Eigen-steering. The calculation of AMA and AM are performed at the receiver. The AMA is used to suppress interference and to maximize the signal-to-interference-plus-noise ratio (SINR). The AM scheme is used to allocate OFDM sub-carriers, power, and modulation mode subject to the constraints of power, discrete modulation, and the bit error rate (BER). The transmit weights, the allocation of power, and the allocation of sub-carriers are obtained at the transmitter using ACK Eigen-steering. The derivations of AMA, AM, and ACK Eigen-steering are shown. The performance of joint AMA and AM for various AMA configurations is evaluated through the simulations of BER and spectral efficiency (SE) against SIR. To improve the performance of the system further, we propose a practical cooperative transmission scheme to mitigate against the interference in co-working WLANs. Here, we consider a network coordination among BSs. We employ Tomlinson Harashima precoding (THP), joint transmit-receive beamforming based on SINR (signal-to-interference-plus-noise-ratio) maximization, and an adaptive precoding order to eliminate co-working interference and achieve bit error rate (BER) fairness among different users. We also consider the design of the system when partial channel state information (CSI) (where each user only knows its own CSI) and full CSI (where each user knows CSI of all users) are available at the receiver respectively. We prove analytically and by simulation that the performance of our proposed scheme will not be degraded under partial CSI. The simulation results show that the proposed scheme considerably outperforms both the existing noncooperative and cooperative transmission schemes. A method to design a spectrally efficient cooperative downlink transmission scheme employing precoding and beamforming is also proposed. The algorithm eliminates the interference and achieves symbol error rate (SER) fairness among different users. To eliminate the interference, Tomlinson Harashima precoding (THP) is used to cancel part of the interference while the transmit-receive antenna weights cancel the remaining one. A new novel iterative method is applied to generate the transmit-receive antenna weights. To achieve SER fairness among different users and further improve the performance of MIMO systems, we develop algorithms that provide equal SINR across all users and order the users so that the minimum SINR for each user is maximized. The simulation results show that the proposed scheme considerably outperforms existing cooperative transmission schemes in terms of the SER performance and complexity and approaches an interference free performance under the same configuration. We could improve the performance of the proposed interference cancellation further. This is because the proposed interference cancellation does not consider receiver noise when calculating the transmit-receive weight antennas. In addition, the proposed scheme mentioned above is designed specifically for a single-stream multi-user transmission. Here, we employ THP precoding and an iterative method based on the uplink-downlink duality principle to generate the transmit-receive antenna weights. The algorithm provides an equal SINR across all users. A simpler method is then proposed by trading off the complexity with a slight performance degradation. The proposed methods are extended to also work when the receiver does not have complete Channel State Informations (CSIs). A new method of setting the user precoding order, which has a much lower complexity than the VBLAST type ordering scheme but with almost the same performance, is also proposed. The simulation results show that the proposed schemes considerably outperform existing cooperative transmission schemes in terms of SER performance and approach an interference free performance. In all the cooperative transmission schemes proposed above, we use THP to cancel part of the interference. In this thesis, we also consider an alternative approach that bypasses the use of THP. The task of cancelling the interference from other users now lies solely within the transmit-receive antenna weights. We consider multiuser Gaussian broadcast channels with multiple antennas at both transmitter and receivers. An iterative multiple beamforming (IMB) algorithm is proposed, which is flexible in the antenna configuration and performs well in low to moderate data rates. Its capacity and bit error rate performance are compared with the ones achieved by the traditional zero-forcing method

Index modulation for next generation wireless communications.

Doctoral Degree. University of KwaZulu-Natal, Durban.A multicarrier index modulation technique in the form of quadrature spatial modulation (QSM) orthogonal frequency division multiplexing (QSM-OFDM) is proposed, in which transmit antenna indices are employed to transmit additional bits. Monte Carlo simulation results demonstrates a 5 dB gain in signal-to-noise ratio (SNR) over other OFDM schemes. Furthermore, an analysis of the receiver computational complexity is presented. A low-complexity near-ML detector for space-time block coded (STBC) spatial modulation (STBC-SM) with cyclic structure (STBC-CSM), which demonstrate near-ML error performance and yields significant reduction in computational complexity is proposed. In addition, the union-bound theoretical framework to quantify the average bit-error probability (ABEP) of STBC-CSM is formulated and validates the Monte Carlo simulation results. The application of media-based modulation (MBM), to STBC-SM and STBC-CSM employing radio frequency (RF) mirrors, in the form of MBSTBC-SM and MBSTBC-CSM is proposed to improve the error performance. Numerical results of the proposed schemes demonstrate significant improvement in error performance when compared with STBC-CSM and STBC-SM. In addition, the analytical framework of the union-bound on the ABEP of MBSTBC-SM and MBSTBC-CSM for the ML detector is formulated and agrees well with Monte Carlo simulations. Furthermore, a low-complexity near-ML detector for MBSTBC-SM and MBSTBC-CSM is proposed, and achieves a near-ML error performance. Monte Carlo simulation results demonstrate a trade-off between the error performance and the resolution of the detector that is employed. Finally, the application of MBM, an index modulated system to spatial modulation, in the form of spatial MBM (SMBM) is investigated. SMBM employs RF mirrors located around the transmit antenna units to create distinct channel paths to the receiver. This thesis presents an easy to evaluate theoretical bound for the error performance of SMBM, which is validated by Monte Carlo simulation results. Lastly, two low-complexity suboptimal mirror activation pattern (MAP) optimization techniques are proposed, which improve the error performance of SMBM significantly

Cooperative MIMO Systems in Wireless Sensor Networks

28 page(s

Deep Fading Effect On an Individual Link of 4× 4 Mimo Communication Systems

The hottest issue of next generation communication systems is data throughput improvement for any wireless channel conditions. Mul-ti-Input Multi-Output (MIMO) systems are the key technology for the next generation communication systems. Bill Lab Layered Space Time (BLAST) system achieves high data rates with acceptable BER performance over a good channels state. However, when the wireless channel has a considerable fading then the performance will be decreased and at a deep-fading state the system may fail to transmit any signal. This paper studies and compares the conventional 4 4 Vertical BLAST system capacity and bit error rate (BER) performance at Maximum Likelihood (ML) receiver through a simulation. It also studies the effect of a transmit link deep-fading on the effective signal to noise ratio, system BER and system capacity in 4 4 VBLAST system in a comparative way with the conventional 4 4, 3 4, 2 4 and 1 4 VBLAST system. Considering that every possible case of transmit link deep fade lower than-20dB fading gain is equivalent to switching off this transmit link an