1,840 research outputs found
Optimality Properties, Distributed Strategies, and Measurement-Based Evaluation of Coordinated Multicell OFDMA Transmission
The throughput of multicell systems is inherently limited by interference and
the available communication resources. Coordinated resource allocation is the
key to efficient performance, but the demand on backhaul signaling and
computational resources grows rapidly with number of cells, terminals, and
subcarriers. To handle this, we propose a novel multicell framework with
dynamic cooperation clusters where each terminal is jointly served by a small
set of base stations. Each base station coordinates interference to neighboring
terminals only, thus limiting backhaul signalling and making the framework
scalable. This framework can describe anything from interference channels to
ideal joint multicell transmission.
The resource allocation (i.e., precoding and scheduling) is formulated as an
optimization problem (P1) with performance described by arbitrary monotonic
functions of the signal-to-interference-and-noise ratios (SINRs) and arbitrary
linear power constraints. Although (P1) is non-convex and difficult to solve
optimally, we are able to prove: 1) Optimality of single-stream beamforming; 2)
Conditions for full power usage; and 3) A precoding parametrization based on a
few parameters between zero and one. These optimality properties are used to
propose low-complexity strategies: both a centralized scheme and a distributed
version that only requires local channel knowledge and processing. We evaluate
the performance on measured multicell channels and observe that the proposed
strategies achieve close-to-optimal performance among centralized and
distributed solutions, respectively. In addition, we show that multicell
interference coordination can give substantial improvements in sum performance,
but that joint transmission is very sensitive to synchronization errors and
that some terminals can experience performance degradations.Comment: Published in IEEE Transactions on Signal Processing, 15 pages, 7
figures. This version corrects typos related to Eq. (4) and Eq. (28
AirSync: Enabling Distributed Multiuser MIMO with Full Spatial Multiplexing
The enormous success of advanced wireless devices is pushing the demand for
higher wireless data rates. Denser spectrum reuse through the deployment of
more access points per square mile has the potential to successfully meet the
increasing demand for more bandwidth. In theory, the best approach to density
increase is via distributed multiuser MIMO, where several access points are
connected to a central server and operate as a large distributed multi-antenna
access point, ensuring that all transmitted signal power serves the purpose of
data transmission, rather than creating "interference." In practice, while
enterprise networks offer a natural setup in which distributed MIMO might be
possible, there are serious implementation difficulties, the primary one being
the need to eliminate phase and timing offsets between the jointly coordinated
access points.
In this paper we propose AirSync, a novel scheme which provides not only time
but also phase synchronization, thus enabling distributed MIMO with full
spatial multiplexing gains. AirSync locks the phase of all access points using
a common reference broadcasted over the air in conjunction with a Kalman filter
which closely tracks the phase drift. We have implemented AirSync as a digital
circuit in the FPGA of the WARP radio platform. Our experimental testbed,
comprised of two access points and two clients, shows that AirSync is able to
achieve phase synchronization within a few degrees, and allows the system to
nearly achieve the theoretical optimal multiplexing gain. We also discuss MAC
and higher layer aspects of a practical deployment. To the best of our
knowledge, AirSync offers the first ever realization of the full multiuser MIMO
gain, namely the ability to increase the number of wireless clients linearly
with the number of jointly coordinated access points, without reducing the per
client rate.Comment: Submitted to Transactions on Networkin
Downlink Training in Cell-Free Massive MIMO: A Blessing in Disguise
Cell-free Massive MIMO (multiple-input multiple-output) refers to a
distributed Massive MIMO system where all the access points (APs) cooperate to
coherently serve all the user equipments (UEs), suppress inter-cell
interference and mitigate the multiuser interference. Recent works demonstrated
that, unlike co-located Massive MIMO, the \textit{channel hardening} is, in
general, less pronounced in cell-free Massive MIMO, thus there is much to
benefit from estimating the downlink channel. In this study, we investigate the
gain introduced by the downlink beamforming training, extending the previously
proposed analysis to non-orthogonal uplink and downlink pilots. Assuming
single-antenna APs, conjugate beamforming and independent Rayleigh fading
channel, we derive a closed-form expression for the per-user achievable
downlink rate that addresses channel estimation errors and pilot contamination
both at the AP and UE side. The performance evaluation includes max-min
fairness power control, greedy pilot assignment methods, and a comparison
between achievable rates obtained from different capacity-bounding techniques.
Numerical results show that downlink beamforming training, although increases
pilot overhead and introduces additional pilot contamination, improves
significantly the achievable downlink rate. Even for large number of APs, it is
not fully efficient for the UE relying on the statistical channel state
information for data decoding.Comment: Published in IEEE Transactions on Wireless Communications on August
14, 2019. {\copyright} 2019 IEEE. Personal use of this material is permitted.
Permission from IEEE must be obtained for all other use
On the Impact of Control Channel Reliability on Coordinated Multi-Point Transmission
In the heterogeneous networks (HetNets), co-channel interference is a serious problem. Coordinated multi-point (CoMP) transmission has emerged as a powerful technique to mitigate co-channel interference. However, all CoMP techniques rely on information exchange through reliable control channels, which are unlikely to be available in HetNets. In this paper, we study the effect of unreliable control channels, consisting of the access links and backhaul links, on the performance of CoMP. A control channel model is introduced by assigning link failure probability (LFP) to backhaul and access links for the cooperative clusters. Three CoMP architectures, namely the centralized, semi-distributed and fully distributed are analyzed. We investigate the probability of deficient control channels reducing quality of service, and impeding transmission. General closed-form expressions are derived for the probability of a cooperative transmission node staying silent in a resource slot due to unreliable control links. By evaluating the average sum rate of users within a CoMP cluster, we show that the performance gains offered by CoMP quickly diminish, as the unreliability of the control links grows
Receive Combining vs. Multi-Stream Multiplexing in Downlink Systems with Multi-Antenna Users
In downlink multi-antenna systems with many users, the multiplexing gain is
strictly limited by the number of transmit antennas and the use of these
antennas. Assuming that the total number of receive antennas at the
multi-antenna users is much larger than , the maximal multiplexing gain can
be achieved with many different transmission/reception strategies. For example,
the excess number of receive antennas can be utilized to schedule users with
effective channels that are near-orthogonal, for multi-stream multiplexing to
users with well-conditioned channels, and/or to enable interference-aware
receive combining. In this paper, we try to answer the question if the data
streams should be divided among few users (many streams per user) or many users
(few streams per user, enabling receive combining). Analytic results are
derived to show how user selection, spatial correlation, heterogeneous user
conditions, and imperfect channel acquisition (quantization or estimation
errors) affect the performance when sending the maximal number of streams or
one stream per scheduled user---the two extremes in data stream allocation.
While contradicting observations on this topic have been reported in prior
works, we show that selecting many users and allocating one stream per user
(i.e., exploiting receive combining) is the best candidate under realistic
conditions. This is explained by the provably stronger resilience towards
spatial correlation and the larger benefit from multi-user diversity. This
fundamental result has positive implications for the design of downlink systems
as it reduces the hardware requirements at the user devices and simplifies the
throughput optimization.Comment: Published in IEEE Transactions on Signal Processing, 16 pages, 11
figures. The results can be reproduced using the following Matlab code:
https://github.com/emilbjornson/one-or-multiple-stream
- …