2,280 research outputs found
Pedestrians effects on indoor MIMO-OFDM channel capacity
Temporal variations caused by pedestrian movement can significantly affect the channel capacity of indoor MIMOOFDM wireless systems. This paper compares systematic measurements of MIMO-OFDM channel capacity in presence of pedestrians with predicted MIMO-OFDM channel capacity values using geometric optics-based ray tracing techniques. Capacity results are presented for a single room environment using 5.2 GHz with 2x2, 3x3 and 4x4 arrays as well as a 2.45 GHz narrowband 8x8 MIMO array. The analysis shows an increase of up to 2 b/s/Hz on instant channel capacity with up to 3 pedestrians. There is an increase of up to 1 b/s/Hz in the average capacity of the 4x4 MIMO-OFDM channel when the number of pedestrians goes from 1 to 3. Additionally, an increment of up to 2.5 b/s/Hz in MIMO-OFDM channel capacity was measured for a 4x4 array compared to a 2x2 array in presence of pedestrians. Channel capacity values derived from this analysis are important in terms of understanding the limitations and possibilities for MIMO-OFDM systems in indoor populated environments
A Novel Millimeter-Wave Channel Simulator and Applications for 5G Wireless Communications
This paper presents details and applications of a novel channel simulation
software named NYUSIM, which can be used to generate realistic temporal and
spatial channel responses to support realistic physical- and link-layer
simulations and design for fifth-generation (5G) cellular communications.
NYUSIM is built upon the statistical spatial channel model for broadband
millimeter-wave (mmWave) wireless communication systems developed by
researchers at New York University (NYU). The simulator is applicable for a
wide range of carrier frequencies (500 MHz to 100 GHz), radio frequency (RF)
bandwidths (0 to 800 MHz), antenna beamwidths (7 to 360 degrees for azimuth and
7 to 45 degrees for elevation), and operating scenarios (urban microcell, urban
macrocell, and rural macrocell), and also incorporates multiple-input
multiple-output (MIMO) antenna arrays at the transmitter and receiver. This
paper also provides examples to demonstrate how to use NYUSIM for analyzing
MIMO channel conditions and spectral efficiencies, which show that NYUSIM is an
alternative and more realistic channel model compared to the 3rd Generation
Partnership Project (3GPP) and other channel models for mmWave bands.Comment: 7 pages, 8 figures, in 2017 IEEE International Conference on
Communications (ICC), Paris, May 201
Indoor wireless communications and applications
Chapter 3 addresses challenges in radio link and system design in indoor scenarios. Given the fact that most human activities take place in indoor environments, the need for supporting ubiquitous indoor data connectivity and location/tracking service becomes even more important than in the previous decades. Specific technical challenges addressed in this section are(i), modelling complex indoor radio channels for effective antenna deployment, (ii), potential of millimeter-wave (mm-wave) radios for supporting higher data rates, and (iii), feasible indoor localisation and tracking techniques, which are summarised in three dedicated sections of this chapter
Four-element ultrawideband textile cross array for dual-spatial and dual-polarization diversity
The emergence of miniaturized flexible electronics enables on-duty first responders to collect biometrical and environmental data through multiple on-body sensors, integrated into their clothing. However, gathering these life-saving data would be useless if they cannot set up reliable, preferable high-data-rate, wireless communication links between the sensors and a remote base station. Therefore, we have developed a four-element ultrawideband textile cross array that combines dual-spatial and dual-polarization diversity and is easily deployable in a first responder's garment. The impedance bandwidth of the array equals 1.43 GHz, while mutual coupling between its elements remains below -25 dB. For a maximal bit error rate of 1e-4, the array realizes a diversity gain of 24.81 dB. When applying adaptive subcarrier modulation, the mean throughput per orthogonal frequency division multiplexing (OFDM) subcarrier increases by an extra bit/symbol when comparing fourth- to second-order diversity
- âŠ