Pilot patterns and power loading in NC-OFDM cognitive radios

Includes abstract.Includes bibliographical references.The implementation of cognitive radios is widely proposed through the use of Orthogonal Frequency Division Multiplexing (OFDM) modulation. In the special case of cognitive radios however, the OFDM modulation scheme cannot simply be implemented without modification due to the huge change in the basic laws of the transmission paradigm. The main reason behind this is that the modulation scheme can no longer assume the contiguousness of its band as well as the interference that may be caused by the cognitive radio users operating in such close proximity to the licensed users. The research presented in this thesis namely identified two areas of cognitive radio which addressed these issues. These were the power loading and channel estimation areas

Low-Complexity Algorithms for Channel Estimation in Optimised Pilot-Assisted Wireless OFDM Systems

Orthogonal frequency division multiplexing (OFDM) has recently become a dominant transmission technology considered for the next generation fixed and mobile broadband wireless communication systems. OFDM has an advantage of lessening the severe effects of the frequency-selective (multipath) fading due to the band splitting into relatively flat fading subchannels, and allows for low-complexity transceiver implementation based on the fast Fourier transform algorithms. Combining OFDM modulation with multilevel frequency-domain symbol mapping (e.g., QAM) and spatial multiplexing (SM) over the multiple-input multiple-output (MIMO) channels, can theoretically achieve near Shannon capacity of the communication link. However, the high-rate and spectrumefficient system implementation requires coherent detection at the receiving end that is possible only when accurate channel state information (CSI) is available. Since in practice, the response of the wireless channel is unknown and is subject to random variation with time, the receiver typically employs a channel estimator for CSI acquisition. The channel response information retrieved by the estimator is then used by the data detector and can also be fed back to the transmitter by means of in-band or out-of-band signalling, so the latter could adapt power loading, modulation and coding parameters according to the channel conditions. Thus, design of an accurate and robust channel estimator is a crucial requirement for reliable communication through the channel, which is selective in time and frequency. In a MIMO configuration, a separate channel estimator has to be associated with each transmit/receive antenna pair, making the estimation algorithm complexity a primary concern. Pilot-assisted methods, relying on the insertion of reference symbols in certain frequencies and time slots, have been found attractive for identification of the doubly-selective radio channels from both the complexity and performance standpoint. In this dissertation, a family of the reduced-complexity estimators for the single and multiple-antenna OFDM systems is developed. The estimators are based on the transform-domain processing and have the same order of computational complexity, irrespective of the number of pilot subcarriers and their positioning. The common estimator structure represents a cascade of successive small-dimension filtering modules. The number of modules, as well as their order inside the cascade, is determined by the class of the estimator (one or two-dimensional) and availability of the channel statistics (correlation and signal-to-noise power ratio). For fine precision estimation in the multipath channels with statistics not known a priori, we propose recursive design of the filtering modules. Simulation results show that in the steady state, performance of the recursive estimators approaches that of their theoretical counterparts, which are optimal in the minimum mean square error (MMSE) sense. In contrast to the majority of the channel estimators developed so far, our modular-type architectures are suitable for the reconfigurable OFDM transceivers where the actual channel conditions influence the decision of what class of filtering algorithm to use, and how to allot pilot subcarrier positions in the band. In the pilot-assisted transmissions, channel estimation and detection are performed separately from each other over the distinct subcarrier sets. The estimator output is used only to construct the detector transform, but not as the detector input. Since performance of both channel estimation and detection depends on the signal-to-noise power vi ratio (SNR) at the corresponding subcarriers, there is a dilemma of the optimal power allocation between the data and the pilot symbols as these are conflicting requirements under the total transmit power constraint. The problem is exacerbated by the variety of channel estimators. Each kind of estimation algorithm is characterised by its own SNR gain, which in general can vary depending on the channel correlation. In this dissertation, we optimise pilot-data power allocation for the case of developed low-complexity one and two-dimensional MMSE channel estimators. The resultant contribution is manifested by the closed-form analytical expressions of the upper bound (suboptimal approximate value) on the optimal pilot-to-data power ratio (PDR) as a function of a number of design parameters (number of subcarriers, number of pilots, number of transmit antennas, effective order of the channel model, maximum Doppler shift, SNR, etc.). The resultant PDR equations can be applied to the MIMO-OFDM systems with arbitrary arrangement of the pilot subcarriers, operating in an arbitrary multipath fading channel. These properties and relatively simple functional representation of the derived analytical PDR expressions are designated to alleviate the challenging task of on-the-fly optimisation of the adaptive SM-MIMO-OFDM system, which is capable of adjusting transmit signal configuration (e.g., block length, number of pilot subcarriers or antennas) according to the established channel conditions

Spectrally and Energy Efficient Wireless Communications: Signal and System Design, Mathematical Modelling and Optimisation

This thesis explores engineering studies and designs aiming to meeting the requirements of enhancing capacity and energy efficiency for next generation communication networks. Challenges of spectrum scarcity and energy constraints are addressed and new technologies are proposed, analytically investigated and examined. The thesis commences by reviewing studies on spectrally and energy-efficient techniques, with a special focus on non-orthogonal multicarrier modulation, particularly spectrally efficient frequency division multiplexing (SEFDM). Rigorous theoretical and mathematical modelling studies of SEFDM are presented. Moreover, to address the potential application of SEFDM under the 5th generation new radio (5G NR) heterogeneous numerologies, simulation-based studies of SEFDM coexisting with orthogonal frequency division multiplexing (OFDM) are conducted. New signal formats and corresponding transceiver structure are designed, using a Hilbert transform filter pair for shaping pulses. Detailed modelling and numerical investigations show that the proposed signal doubles spectral efficiency without performance degradation, with studies of two signal formats; uncoded narrow-band internet of things (NB-IoT) signals and unframed turbo coded multi-carrier signals. The thesis also considers using constellation shaping techniques and SEFDM for capacity enhancement in 5G system. Probabilistic shaping for SEFDM is proposed and modelled to show both transmission energy reduction and bandwidth saving with advantageous flexibility for data rate adaptation. Expanding on constellation shaping to improve performance further, a comparative study of multidimensional modulation techniques is carried out. A four-dimensional signal, with better noise immunity is investigated, for which metaheuristic optimisation algorithms are studied, developed, and conducted to optimise bit-to-symbol mapping. Finally, a specially designed machine learning technique for signal and system design in physical layer communications is proposed, utilising the application of autoencoder-based end-to-end learning. Multidimensional signal modulation with multidimensional constellation shaping is proposed and optimised by using machine learning techniques, demonstrating significant improvement in spectral and energy efficiencies

Algorithm-Architecture Co-Design for Digital Front-Ends in Mobile Receivers

The methodology behind this work has been to use the concept of algorithm-hardware co-design to achieve efficient solutions related to the digital front-end in mobile receivers. It has been shown that, by looking at algorithms and hardware architectures together, more efficient solutions can be found; i.e., efficient with respect to some design measure. In this thesis the main focus have been placed on two such parameters; first reduced complexity algorithms to lower energy consumptions at limited performance degradation, secondly to handle the increasing number of wireless standards that preferably should run on the same hardware platform. To be able to perform this task it is crucial to understand both sides of the table, i.e., both algorithms and concepts for wireless communication as well as the implications arising on the hardware architecture. It is easier to handle the high complexity by separating those disciplines in a way of layered abstraction. However, this representation is imperfect, since many interconnected "details" belonging to different layers are lost in the attempt of handling the complexity. This results in poor implementations and the design of mobile terminals is no exception. Wireless communication standards are often designed based on mathematical algorithms with theoretical boundaries, with few considerations to actual implementation constraints such as, energy consumption, silicon area, etc. This thesis does not try to remove the layer abstraction model, given its undeniable advantages, but rather uses those cross-layer "details" that went missing during the abstraction. This is done in three manners: In the first part, the cross-layer optimization is carried out from the algorithm perspective. Important circuit design parameters, such as quantization are taken into consideration when designing the algorithm for OFDM symbol timing, CFO, and SNR estimation with a single bit, namely, the Sign-Bit. Proof-of-concept circuits were fabricated and showed high potential for low-end receivers. In the second part, the cross-layer optimization is accomplished from the opposite side, i.e., the hardware-architectural side. A SDR architecture is known for its flexibility and scalability over many applications. In this work a filtering application is mapped into software instructions in the SDR architecture in order to make filtering-specific modules redundant, and thus, save silicon area. In the third and last part, the optimization is done from an intermediate point within the algorithm-architecture spectrum. Here, a heterogeneous architecture with a combination of highly efficient and highly flexible modules is used to accomplish initial synchronization in at least two concurrent OFDM standards. A demonstrator was build capable of performing synchronization in any two standards, including LTE, WiFi, and DVB-H

Traitement du signal pour les communications numériques au travers de canaux radio-mobiles

This manuscript of ''Habilitation à diriger les Recherches'' (Habilitation to conduct researches) gives me the opportunity to take stock of the last 14 years on my associate professor activities and on my research works in the field of signal processing for digital communications, particularly for radio-mobile communications. The purpose of this signal processing is generally to obtain a robust transmission, despite the passage of digital information through a communication channel disrupted by the mobility between the transmitter and the receiver (Doppler effect), the phenomenon of echoes (multi-path propagation), the addition of noise or interference, or by limitations in bandwidth, in transmitted power or in signal-to-noise ratio. In order to recover properly the digital information, the receiver needs in general to have an accurate knowledge of the channel state. Much of my work has focused on receiver synchronization or more generally on the dynamic estimation of the channel parameters (delays, phases, amplitudes, Doppler shifts, ...). We have developed estimators and studied their performance in asymptotic variance, and have compared them to minimum lower bound (Cramer-rao or Bayesian Cramer Rao bounds). Some other studies have focused only on the recovering of information (''detection'' or ''equalization'' task) by the receiver after channel estimation, or proposed and analyzed emission / reception schemes, reliable for certain scenarios (transmit diversity scheme for flat fading channel, scheme with high energy efficiency, ...).Ce mémoire de HDR est l'occasion de dresser un bilan des 14 dernières années concernant mes activités d'enseignant-chercheur et mes travaux de recherche dans le domaine du traitement du signal pour les communications numériques, et plus particulièrement les communications radio-mobiles. L'objet de ce traitement du signal est globalement l'obtention d'une transmission robuste, malgré le passage de l'information numérique au travers d'un canal de communication perturbé par la mobilité entre l'émetteur et le récepteur (effet Doppler), le phénomène d'échos, l'addition de bruit ou d'interférence, ou encore par des limitations en bande-passante, en puissance transmise ou en rapport-signal à bruit. Afin de restituer au mieux l'information numérique, le récepteur a en général besoin de disposer d'une connaissance précise du canal. Une grande partie de mes travaux s'est intéressé à l'estimation dynamique des paramètres de ce canal (retards, phases, amplitudes, décalages Doppler, ...), et en particulier à la synchronisation du récepteur. Quelques autres travaux se sont intéressés seulement à la restitution de l'information (tâches de ''détection'' ou d' ''égalisation'') par le récepteur une fois le canal estimé, ou à des schémas d'émission / réception spécifiques. La synthèse des travaux commence par une introduction générale décrivant les ''canaux de communications'' et leurs problèmes potentiels, et positionne chacun de mes travaux en ces termes. Une première partie s'intéresse aux techniques de réception pour les signaux à spectre étalé des systèmes d'accès multiple à répartition par codes (CDMA). Ces systèmes large-bande offrent un fort pouvoir de résolution temporelle et des degrés de liberté, que nous avons exploités pour étudier l'égalisation et la synchronisation (de retard et de phase) en présence de trajets multiples et d'utilisateurs multiples. La première partie regroupe aussi d'autres schémas d'émission/réception, proposés pour leur robustesse dans différents scénarios (schéma à diversité pour canaux à évanouissement plats, schéma à forte efficacité énergétique, ...). La seconde partie est consacrée à l'estimation dynamique Bayésienne des paramètres du canal. On suppose ici qu'une partie des paramètres à estimer exhibe des variations temporelles aléatoires selon une certaine loi à priori. Nous proposons d'abord des estimateurs et des bornes minimales d'estimation pour des modèles de transmission relativement complexes, en raison de la distorsion temporelle due à la forte mobilité en modulation multi-porteuse (OFDM), ou de la présence de plusieurs paramètres à estimer conjointement, ou encore de non linéarités dans les modèles. Nous nous focalisons ensuite sur le problème d'estimation des amplitudes complexes des trajets d'un canal à évolution lente (à 1 ou plusieurs bonds). Nous proposons des estimateurs récursifs (dénommés CATL, pour ''Complex Amplitude Tracking Loop'') à structure imposée inspirée par les boucles à verrouillage de phase numériques, de performance asymptotiques proches des bornes minimales. Les formules analytiques approchées de performances asymptotiques et de réglages de ces estimateurs sont établies sous forme de simples fonctions des paramètres physiques (spectre Doppler, retards, niveau de bruit). Puis étant donné les liens établis entre ces estimateurs CATL et certains filtres de Kalman (construits pour des modèles d'état de type marche aléatoire intégrée), les formules approchées de performances asymptotiques et de réglage de ces filtres de Kalman sont aussi dérivées