PAR-Aware Large-Scale Multi-User MIMO-OFDM Downlink

We investigate an orthogonal frequency-division multiplexing (OFDM)-based downlink transmission scheme for large-scale multi-user (MU) multiple-input multiple-output (MIMO) wireless systems. The use of OFDM causes a high peak-to-average (power) ratio (PAR), which necessitates expensive and power-inefficient radio-frequency (RF) components at the base station. In this paper, we present a novel downlink transmission scheme, which exploits the massive degrees-of-freedom available in large-scale MU-MIMO-OFDM systems to achieve low PAR. Specifically, we propose to jointly perform MU precoding, OFDM modulation, and PAR reduction by solving a convex optimization problem. We develop a corresponding fast iterative truncation algorithm (FITRA) and show numerical results to demonstrate tremendous PAR-reduction capabilities. The significantly reduced linearity requirements eventually enable the use of low-cost RF components for the large-scale MU-MIMO-OFDM downlink.Comment: To appear in IEEE Journal on Selected Areas in Communication

Investigations on Filtered OFDM with Selective Mapping Method and Partial Transmit Sequence Technique for Future Generation Mobile Communication Systems

Future generation mobile communication system requires asynchronous transmission of data, reduced out-of-band power emission, low peak-to-average power ratio, low latency, high data transmission rate, better spectrum, energy, and power efficiency, etc. Investigations on suitable waveform candidates for future-generation mobile communication have been reported in this paper. Filtered Orthogonal Frequency Division Multiplexing (F- OFDM), F- OFDM with Selective Mapping Method (SLM), and F- OFDM with Partial Transmit Sequence (PTS) technique, have been investigated. Its performances have been evaluated in terms of peak-to-average power ratio (PAPR), bit error rate (BER), and out-of-band power emissions. F–OFDM is a suitable candidate for future-generation mobile communication systems that can be used with single-rate or multirate filters. It can also be used in combination with other PAPR reduction techniques. F-OFDM with PTS technique requires a smaller number of IFFT operations than F-OFDM with SLM. The result obtained from my present investigations reveals that F-OFDM with the PTS technique has 4.3 dB less PAPR than that of OFDM at the cost of marginal increase in the BER value

Modified Alternative-signal Technique for Sequential Optimisation for PAPR Reduction in OFDM-OQAM Systems

A modified alternative signal technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing systems employing offset quadrature amplitude modulation (OFDM-OQAM) is proposed. Lower PAPR reduces the complexity of digital to analog converters and results in increasing the efficiency of power amplifiers. The main objective of the algorithm is to decrease PAPR with low complexity. The alternative signal method involves the individual alternative signal (AS-I) and combined alternative signal (AS-C) algorithms. Both the algorithms decrease the peak to average power ratio of OFDM-OQAM signals and AS-C algorithm performs better in decreasing PAPR. However the complexity of AS-C algorithm is very high compared to that of AS-I. To achieve reduction in PAPR with low complexity, modified alternative signal technique with sequential optimisation (MAS-S) is proposed. The quantitative PAPR analysis and complexity analysis of the proposed algorithm are carried out. It is demonstrated that MAS-S algorithm simultaneously achieves PAPR reduction and low complexity

A Low Complexity Partial Transmit Sequence for Peak to Average Power Ratio Reduction in OFDM Systems

Partial transmit sequence (PTS) is one of the most important techniques for reducing the peak to average power ratio (PAPR) in OFDM systems. This paper presents a low complexity PTS scheme by applying a new phase sequence. Unlike the conventional PTS which needs several inverse fast Fourier transform (IFFT) operations, the proposed technique requires half IFFT operations only at the expense of slight PAPR degradation. Simulation and results are examined with QPSK modulation and OFDM signal and power amplifier with memory effects

Blind Algorithm Development for Peak to Average Power Ratio Reduction in OFDM Systems under Frequency Selective Channels

One major drawback of orthogonal frequency division multiplexing (OFDM) system is peak to average power ratio (PAPR). This effect causes high power amplifier (HPA) to introduce intermodulation and out of band radiation as the signal goes through, thus degrades the performance of OFDM systems. This paper proposes blind algorithms which takes advantage of signal transformation technique and signal distortion technique. Simulation results show that at complementary cumulative distribution function (CCDF) level of 10-3 , the proposed algorithm achieved 3.2 dB PAPR improvement compared to discrete Fourier transform with interleaved frequency division multiple access (DFT-IFDMA) based algorithm. The bit error rate (BER) performance has degraded by 2 dB compared to the original OFDM signal with no distortion under frequency selective channel (FCS) at BER of 10-4 . These presented results, mark this algorithm as a better candidate for PAPR reduction algorithm in long term evolution (LTE) network. Under AWGN channels, the proposed algorithm performs better both in low and high signal power values. Under frequency selective channels, the existing and proposed algorithm converges after 10 dB of signal to noise power values. The low BER transmissions at low signal power values signify energy efficiency, ideal for portable wireless devices with limited battery power

New SLM scheme to reduce the PAPR of OFDM signals using a genetic algorithm

AbstractSelected mapping (SLM) is a popular peak-to-average power ratio (PAPR) reduction technique suitable for use in orthogonal frequency division multiplexing (OFDM) systems as it achieves good PAPR reduction performance without signal distortion. However, SLM requires a bank of inverse fast Fourier transforms (IFFTs) to produce candidate signals, resulting in high computational complexity. In this paper, we introduce a novel SLM technique based on conversion matrices (CM) and a genetic algorithm (GA) that requires only one IFFT module. Simulation results indicate that the proposed method obtains desirable PAPR reduction performance with low computational complexity

Reduction of Peak to Average Power Ratio using Selective Mapping Technique of an OFDM Signal: An Analysis

Orthogonal Frequency Division Multiplexing (OFDM) is a optimistic and very popular modulation technique in multicarrier domain which is quite promising regarding the issues of interferences present in next generation mobile communication systems. It deployed in the area where high data rate and low latency required while efficiency will be as better as possible. The critical problem in OFDM system is maintaining low PAPR (peak to average power ratio) because it reduces the performance of system. There are several techniques which are used to overcome problem of high PAPR in OFDM modulation system. One of the techniques is Selective Mapping (SLM) which comes in distortion less criteria. In this paper analysis of PAPR reduction of an OFDM system for distortion less transmission criterion is shown. We have also used some mathematical equations to calculate and simulate its performance. It’s also shown that SLM method grants the user a better PAPR reduction while having high complex circuitry