Turbo NOC: a framework for the design of Network-on-Chip-basedturbo decoder architectures

This paper proposes a general framework for the design and simulation of network-on-chip-based turbo decoder architectures. Several parameters in the design space are investigated, namely, network topology, parallelism degree, the rate at which messages are sent by processing nodes over the network, and routing strategy. The main results of this analysis are as follows: 1) the most suited topologies to achieve high throughput with a limited complexity overhead are generalized de Bruijn and generalized Kautz topologies and 2) depending on the throughput requirements, different parallelism degrees, message injection rates, and routing algorithms can be used to minimize the network area overhead

Improving Network-on-Chip-based Turbo Decoder Architectures

In this work novel results concerning Networkon- Chip-based turbo decoder architectures are presented. Stemming from previous publications, this work concentrates first on improving the throughput by exploiting adaptive-bandwidth-reduction techniques. This technique shows in the best case an improvement of more than 60 Mb/s. Moreover, it is known that double-binary turbo decoders require higher area than binary ones. This characteristic has the negative effect of increasing the data width of the network nodes. Thus, the second contribution of this work is to reduce the network complexity to support doublebinary codes, by exploiting bit-level and pseudo-floatingpoint representation of the extrinsic information. These two techniques allow for an area reduction of up to more than the 40 % with a performance degradation of about 0.2 d

Low-Density Parity-Check Coded High-order Modulation Schemes

In this thesis, we investigate how to support reliable data transmissions at high speeds in future communication systems, such as 5G/6G, WiFi, satellite, and optical communications. One of the most fundamental problems in these communication systems is how to reliably transmit information with a limited number of resources, such as power and spectral. To obtain high spectral efficiency, we use coded modulation (CM), such as bit-interleaved coded modulation (BICM) and delayed BICM (DBICM). To be specific, BICM is a pragmatic implementation of CM which has been largely adopted in both industry and academia. While BICM approaches CM capacity at high rates, the capacity gap between BICM and CM is still noticeable at lower code rates. To tackle this problem, DBICM, as a variation of BICM, introduces a delay module to create a dependency between multiple codewords, which enables us to exploit extrinsic information from the decoded delayed sub-blocks to improve the detection of the undelayed sub-blocks. Recent work shows that DBICM improves capacity over BICM. In addition, BICM and DBICM schemes protect each bit-channel differently, which is often referred to as the unequal error protection (UEP) property. Therefore, bit mapping designs are important for constructing pragmatic BICM and DBICM. To provide reliable communication, we have jointly designed bit mappings in DBICM and irregular low-density parity-check (LDPC) codes. For practical considerations, spatially coupled LDPC (SC-LDPC) codes have been considered as well. Specifically, we have investigated the joint design of the multi-chain SC-LDPC and the BICM bit mapper. In addition, the design of SC-LDPC codes with improved decoding threshold performance and reduced rate loss has been investigated in this thesis as well. The main body of this thesis consists of three parts. In the first part, considering Gray-labeled square M-ary quadrature amplitude modulation (QAM) constellations, we investigate the optimal delay scheme with the largest spectrum efficiency of DBICM for a fixed maximum number of delayed time slots and a given signal-to-noise ratio. Furthermore, we jointly optimize degree distributions and channel assignments of LDPC codes using protograph-based extrinsic information transfer charts. In addition, we proposed a constrained progressive edge growth-like algorithm to jointly construct LDPC codes and bit mappings for DBICM, taking the capacity of each bit-channel into account. Simulation results demonstrate that the designed LDPC-coded DBICM systems significantly outperform LDPC-coded BICM systems. In the second part, we proposed a windowed decoding algorithm for DBICM, which uses the extrinsic information of both the decoded delayed and undelayed sub-blocks, to improve the detection for all sub-blocks. We show that the proposed windowed decoding significantly outperforms the original decoding, demonstrating the effectiveness of the proposed decoding algorithm. In the third part, we apply multi-chain SC-LDPC to BICM. We investigate various connections for multi-chain SC-LDPC codes and bit mapping designs and analyze the performance of the multi-chain SC-LDPC codes over the equivalent binary erasure channels via density evolution. Numerical results demonstrate the superiority of the proposed design over existing connected-chain ensembles and over single-chain ensembles with the existing bit mapping design

The interplay between mapping/demapping and non-binary LDPC coding in MIMO wireless communication systems

Recently, the need for innovative services available for the end users has led to an increasing demand of higher throughputs of wireless systems. On the other hand higher throughput means wider bandwidth, so that channel selectivity and fading might be a severe challenge to combat in order to ensure high level of Quality of Service (QoS). In this scenario one of the possible approach to increase the system throughput is the use of multiple antennas, both at the transmitter and the receiver side. Instead the typical manner to combat channel effects is to employ powerful channel coding schemes, which target the mitigation of these propagation effects. This work follows this approach combining the MIMO techniques jointly with the powerful channel coding scheme of non-binary LDPC. The expression "non-binary" refers to the fact that these codes are defined over high order Galois Field. These codes have been researched in the literature to achieve higher error protection than conventional binary codes for transmission over different noisy channels. The main novelty of this work is related to the mapping and demapping of the non-binary information. Typically the main contributions in the literature focus on the low complexity decoders, whilst the demapping complexity is neglected. However, the demapping complexity might become a real bottleneck in the global receiver complexity, so that we decide to investigate this topic. A strategy is devised to guarantee an efficient mapping at the transmitter, together with an algorithm for low complexity soft demapping at the receiver. The proposed solutions target the best trade-off between performance and complexity, for any combination of the Galois field order, QAM constellation order, and MIMO scheme