2,489 research outputs found
An Iterative Receiver for OFDM With Sparsity-Based Parametric Channel Estimation
In this work we design a receiver that iteratively passes soft information
between the channel estimation and data decoding stages. The receiver
incorporates sparsity-based parametric channel estimation. State-of-the-art
sparsity-based iterative receivers simplify the channel estimation problem by
restricting the multipath delays to a grid. Our receiver does not impose such a
restriction. As a result it does not suffer from the leakage effect, which
destroys sparsity. Communication at near capacity rates in high SNR requires a
large modulation order. Due to the close proximity of modulation symbols in
such systems, the grid-based approximation is of insufficient accuracy. We show
numerically that a state-of-the-art iterative receiver with grid-based sparse
channel estimation exhibits a bit-error-rate floor in the high SNR regime. On
the contrary, our receiver performs very close to the perfect channel state
information bound for all SNR values. We also demonstrate both theoretically
and numerically that parametric channel estimation works well in dense
channels, i.e., when the number of multipath components is large and each
individual component cannot be resolved.Comment: Major revision, accepted for IEEE Transactions on Signal Processin
Communication Subsystems for Emerging Wireless Technologies
The paper describes a multi-disciplinary design of modern communication systems. The design starts with the analysis of a system in order to define requirements on its individual components. The design exploits proper models of communication channels to adapt the systems to expected transmission conditions. Input filtering of signals both in the frequency domain and in the spatial domain is ensured by a properly designed antenna. Further signal processing (amplification and further filtering) is done by electronics circuits. Finally, signal processing techniques are applied to yield information about current properties of frequency spectrum and to distribute the transmission over free subcarrier channels
Indoor wireless communications and applications
Chapter 3 addresses challenges in radio link and system design in indoor scenarios. Given the fact that most human activities take place in indoor environments, the need for supporting ubiquitous indoor data connectivity and location/tracking service becomes even more important than in the previous decades. Specific technical challenges addressed in this section are(i), modelling complex indoor radio channels for effective antenna deployment, (ii), potential of millimeter-wave (mm-wave) radios for supporting higher data rates, and (iii), feasible indoor localisation and tracking techniques, which are summarised in three dedicated sections of this chapter
Performance of direct-oversampling correlator-type receivers in chaos-based DS-CDMA systems over frequency non-selective fading channels
In this paper, we present a study on the performance of direct-oversampling correlator-type receivers in chaos-based direct-sequence code division multiple access systems over frequency non-selective fading channels. At the input, the received signal is sampled at a sampling rate higher than the chip rate. This oversampling step is used to precisely determine the delayed-signal components from multipath fading channels, which can be combined together by a correlator for the sake of increasing the SNR at its output. The main advantage of using direct-oversampling correlator-type receivers is not only their low energy consumption due to their simple structure, but also their ability to exploit the non-selective fading characteristic of multipath channels to improve the overall system performance in scenarios with limited data speeds and low energy requirements, such as low-rate wireless personal area networks. Mathematical models in discrete-time domain for the conventional transmitting side with multiple access operation, the generalized non-selective Rayleigh fading channel, and the proposed receiver are provided and described. A rough theoretical bit-error-rate (BER) expression is first derived by means of Gaussian approximation. We then define the main component in the expression and build its probability mass function through numerical computation. The final BER estimation is carried out by integrating the rough expression over possible discrete values of the PFM. In order to validate our findings, PC simulation is performed and simulated performance is compared with the corresponding estimated one. Obtained results show that the system performance get better with the increment of the number of paths in the channel.Peer ReviewedPostprint (author's final draft
- …