Distributed coding of endoscopic video

Triggered by the challenging prerequisites of wireless capsule endoscopic video technology, this paper presents a novel distributed video coding (DVC) scheme, which employs an original hash-based side-information creation method at the decoder. In contrast to existing DVC schemes, the proposed codec generates high quality side-information at the decoder, even under the strenuous motion conditions encountered in endoscopic video. Performance evaluation using broad endoscopic video material shows that the proposed approach brings notable and consistent compression gains over various state-of-the-art video codecs at the additional benefit of vastly reduced encoding complexity

A Content-Adaptive Side Information Generation Method for Distributed Video Coding

AbstractIn this paper, a content-adaptive method to generate side information at the block level is presented. First, motion compensated temporal interpolation (MCTI) algorithm is used between the reconstructed key frames at the decoder to acquire initial motion vectors. Second, the image is segmented and the edge of moving region is detected by obtained the residual frame between two consecutive key frames. Furthermore, hierarchical motion estimation (HME) and motion vector filter (MVF) are adopted for edge region and an adaptive motion vector filter (AMVF) is introduced in non-edge region to correct the false estimated motion vectors. The proposal is tested and compared with the results of the state-of-the-art DISCOVER codec and RD improvements on the set of test sequences are observed

On the Effectiveness of Video Recolouring as an Uplink-model Video Coding Technique

For decades, conventional video compression formats have advanced via incremental improvements with each subsequent standard achieving better rate-distortion (RD) efficiency at the cost of increased encoder complexity compared to its predecessors. Design efforts have been driven by common multi-media use cases such as video-on-demand, teleconferencing, and video streaming, where the most important requirements are low bandwidth and low video playback latency. Meeting these requirements involves the use of computa- tionally expensive block-matching algorithms which produce excellent compression rates and quick decoding times. However, emerging use cases such as Wireless Video Sensor Networks, remote surveillance, and mobile video present new technical challenges in video compression. In these scenarios, the video capture and encoding devices are often power-constrained and have limited computational resources available, while the decoder devices have abundant resources and access to a dedicated power source. To address these use cases, codecs must be power-aware and offer a reasonable trade-off between video quality, bitrate, and encoder complexity. Balancing these constraints requires a complete rethinking of video compression technology. The uplink video-coding model represents a new paradigm to address these low-power use cases, providing the ability to redistribute computational complexity by offloading the motion estimation and compensation steps from encoder to decoder. Distributed Video Coding (DVC) follows this uplink model of video codec design, and maintains high quality video reconstruction through innovative channel coding techniques. The field of DVC is still early in its development, with many open problems waiting to be solved, and no defined video compression or distribution standards. Due to the experimental nature of the field, most DVC codec to date have focused on encoding and decoding the Luma plane only, which produce grayscale reconstructed videos. In this thesis, a technique called “video recolouring” is examined as an alternative to DVC. Video recolour- ing exploits the temporal redundancies between colour planes, reducing video bitrate by removing Chroma information from specific frames and then recolouring them at the decoder. A novel video recolouring algorithm called Motion-Compensated Recolouring (MCR) is proposed, which uses block motion estimation and bi-directional weighted motion-compensation to reconstruct Chroma planes at the decoder. MCR is used to enhance a conventional base-layer codec, and shown to reduce bitrate by up to 16% with only a slight decrease in objective quality. MCR also outperforms other video recolouring algorithms in terms of objective video quality, demonstrating up to 2 dB PSNR improvement in some cases

Intelligent Side Information Generation in Distributed Video Coding

Distributed video coding (DVC) reverses the traditional coding paradigm of complex encoders allied with basic decoding to one where the computational cost is largely incurred by the decoder. This is attractive as the proven theoretical work of Wyner-Ziv (WZ) and Slepian-Wolf (SW) shows that the performance by such a system should be exactly the same as a conventional coder. Despite the solid theoretical foundations, current DVC qualitative and quantitative performance falls short of existing conventional coders and there remain crucial limitations. A key constraint governing DVC performance is the quality of side information (SI), a coarse representation of original video frames which are not available at the decoder. Techniques to generate SI have usually been based on linear motion compensated temporal interpolation (LMCTI), though these do not always produce satisfactory SI quality, especially in sequences exhibiting non-linear motion. This thesis presents an intelligent higher order piecewise trajectory temporal interpolation (HOPTTI) framework for SI generation with original contributions that afford better SI quality in comparison to existing LMCTI-based approaches. The major elements in this framework are: (i) a cubic trajectory interpolation algorithm model that significantly improves the accuracy of motion vector estimations; (ii) an adaptive overlapped block motion compensation (AOBMC) model which reduces both blocking and overlapping artefacts in the SI emanating from the block matching algorithm; (iii) the development of an empirical mode switching algorithm; and (iv) an intelligent switching mechanism to construct SI by automatically selecting the best macroblock from the intermediate SI generated by HOPTTI and AOBMC algorithms. Rigorous analysis and evaluation confirms that significant quantitative and perceptual improvements in SI quality are achieved with the new framework

A simple encoder scheme for distributed residual video coding.

Rate-Distortion (RD) performance of Distributed Video Coding (DVC) is considerably less than that of conventional predictive video coding. In order to reduce the performance gap, many methods and techniques have been proposed to improve the coding efficiency of DVC with increased system complexity, especially techniques employed at the encoder such as encoder mode decisions, optimal quantization, hash methods etc., no doubt increase the complexity of the encoder. However, low complexity encoder is a widely desired feature of DVC. In order to improve the coding efficiency while maintaining low complexity encoder, this paper focuses on Distributed Residual Video Coding (DRVC) architecture and proposes a simple encoder scheme. The main contributions of this paper are as follows: 1) propose a bit plane block based method combined with bit plane re-arrangement to improve the dependency between source and Side Information (SI), and meanwhile, to reduce the amount of data to be channel encoded 2) present a simple iterative dead-zone quantizer with 3 levels in order to adjust quantization from coarse to fine. The simulation results show that the proposed scheme outperforms DISCOVER scheme for low to medium motion video sequences in terms of RD performance, and maintains a low complexity encoder at the same time